https://www.phoenixcontact.com/us/products/1855092
01/05/2021Page2/9
Sleeve housing-VC-K-T1-R-1855092
Technical data
General
Note When using fiber optics, the bending radii of the cable manufacturers must
be observed.
Type VC1
Degree of protection IP67
Flammability rating according to UL 94 V0
Locking type Screw locking, knurled head
Fixing screws M4
Tightening torque, mounting screw 1.5 Nm ±0.3Nm
Type of the screw connection Pg16
Cable outlet Angled
Housing material Polyamide
Seal material EPDM
Ambient temperature (operation) -40 °C ... 80 °C
Standards and Regulations
Flammability rating according to UL 94 V0
Safety note
WARNING: The connectors may not be plugged in or disconnected under
load. Ignoring the warning or improper use may damage persons and/or
property.
• WARNING: Commission properly functioning products only. The products
must be regularly inspected for damage. Decommission defective products
immediately. Replace damaged products. Repairs are not possible.
• WARNING: Only electrically qualified personnel may install and operate
the product. They must observe the following safety notes. The qualified
personnel must be familiar with the basics of electrical engineering. They
must be able to recognize and prevent danger. The relevant symbol on the
packaging indicates that only personnel familiar with electrical engineering
are allowed to install and operate the product.
• The products are suitable for applications in plant, controller, and
electrical device engineering.
• When operating the connectors in outdoor applications, they must be
separately protected against environmental influences.
• Assembled products may not be manipulated or improperly opened.
• Only use mating connectors that are specified in the technical data of the
standards listed (e.g. the ones listed in the product accessories online at
phoenixcontact.com/products).
• When using the product in direct connection with third-party
manufacturers, the user is responsible.
• For operating voltages > 50V AC, conductive connector housings must
be grounded
• Ensure that the protective or functional ground has been properly
connected.
• VDE 0100/1.97 § 411.1.3.2 and DIN EN 60 204/11.98 § 14.1.3 are
applicable when combining several circuits in a cable and/or connector