Microbox Drill Set Specification: Kit Contents : 0.3 to 1.6mm Drill Bits 20 Piece Microbox Drill Set - Metric - 1826421: High Speed steel metric drills from 0.3 tp 1.6mm in a handy plastic index box with sliding top. Keeps drills securely in place and dispenses one drill at a time. 20 Piece Microbox Drill Set - Wire Gauge (numbers) - 1826422: Contains one of each HSS number drill, sizes 61 to 80 inclusive, in handy sliding top index storage dispenser. 10 Piece Microbox 2.35mm Shank Drill Set - Metric - 1826423: High Speed Steel drills from 0.5 to 2.2mm all with standard 2.35mm size shanks. These are designed to be held in a collet or chuck, particularly useful for use with miniature power drills. Part Number Table Description Part Number Microbox Drill Set, 20-Pc, 0.3-1.6mm DR4001 Microbox Drill Set, 20-Pc, 61-80 DR4004 Microbox Shanked Drill Set, 10-Pc DR4005 Important Notice : This data sheet and its contents (the "Information") belong to the members of the Premier Farnell group of companies (the "Group") or are licensed to it. No licence is granted for the use of it other than for information purposes in connection with the products to which it relates. No licence of any intellectual property rights is granted. The Information is subject to change without notice and replaces all data sheets previously supplied. The Information supplied is believed to be accurate but the Group assumes no responsibility for its accuracy or completeness, any error in or omission from it or for any use made of it. Users of this data sheet should check for themselves the Information and the suitability of the products for their purpose and not make any assumptions based on information included or omitted. Liability for loss or damage resulting from any reliance on the Information or use of it (including liability resulting from negligence or where the Group was aware of the possibility of such loss or damage arising) is excluded. This will not operate to limit or restrict the Group's liability for death or personal injury resulting from its negligence. DURATOOL is the registered trademark of the Group. (c) Premier Farnell plc 2012. www.element14.com www.farnell.com www.newark.com www.cpc.co.uk www.mcmelectronics.com Page <1> 07/01/13 V1.0