Angle Position Sensors AN9 Sensors Thin, programmable, non-contact magnetic position sensors capable of continuous rotation with dual outputs Description The AN9 Series sensors are non-contact, intrinsically linear angle position sensors with two independent outputs. The sensors operate through the use of Hall Effect technology with magnetic fields generated by permanent magnets. They provide a linear change in voltage output (ratiometric to the input voltage) corresponding to an angular rotation of the input shaft. Features * * * * * * * * * Typical Applications Angular position sensor with high tolerance for misalignment Non-contact angular position sensing and full 360 rotation Dual independent (fully redundant) outputs assure high reliability Custom programming available for: angle range, slope, PWM output, custom magnets - contact factory No mechanical interface means no parts to wear out or jam Comes with 18 AWG 305 mm (12") wire leads RoHS Compliant IP67 Maximum air gap of 5.5 mm (0.22")* * * * * * * Implement (fork lift, agricultural trailer hitch, etc.) position sensing Steer, throttle by wire Gear selection Zero-contact encoder alternative Replacement for smart bearings Outboard trim sensing Environmental Specifications Vibration Operating Temperature Storage Temperature Ingress Protection 15g sinusoidal, 9.26g RMS axial; 40 Hz - 2 kHz all 3 axes -40 C to 125 C (-40 F to 257 F) -40 C to 150 C (-40 F to 302 F) IP67 Electrical Specifications Input Voltage Output Voltage Input Current Output Current Output Accuracy Output Linearity Maximum Overvoltage Absolute Max. Output Current Output Type 5.0 VDC 10% 10% to 90% of input (see graph for voltage vs. rotation angle characteristics) 14 mA typ., 16 mA max. -8 mA to 8 mA 3.5% 3.5% 16 VDC 30 mA Analog (PWM available) Mechanical Specifications Housing Material Mechanical Travel Maximum Air Gap* *with AS500106 magnet carrier Maximum Center-To Center Offset Glass Reinforced Plastic 0 to 360 (continuous) 5.5 mm (0.22") 2 mm radial (magnet to center) Note: When used with AS500106 Magnet Carrier; user is responsible for determining characteristics when using other magnets. www.cherryswitches.com Page 1 of 2, last update 2014-10-29, Specifications subject to change without notice. Products Part Number (Sensor) AN920031 AN920032 AN920035 AN920036 Sensing Range Wires 180 360 45 90 18 AWG x 305 mm (12") 18 AWG x 305 mm (12") 18 AWG x 305 mm (12") 18 AWG x 305 mm (12") Sensor Output Dimensions mm (inches) www.cherryswitches.com Page 2 of 2, last update 2014-10-29, Specifications subject to change without notice.