SPEC NO: DSAC9233 REV NO: V.4 DATE: NOV/28/2005 PAGE: 1 O F 4
APPROVED: J. Lu CHECKED: Joe Lee DRAWN: Y.L.LI ERP:1332000493
Package Dimensions & Internal Circuit Diagram
P/N: TC08-81YWA YELLOW
Description
The Yellow source color devices are made with Gallium
Arsenide Phosphide on Gallium Phosphide Yellow Light
Emitting Diode.
Notes:
1. All dimensions are in millimeters (inches), Tolerance is ±0.25(0.01")unless otherwise noted.
2. Specifications are subject to change without notice.
20mm (0.8 INCH ) SINGLE COLOR DOT
MATRIX DISPLAY
Features
0.8INCH MATRIX HEIGHT.
DOT SIZE 2mm.
LOW CURRENT OPERATION.
COMPATIBLE WITH ASCII AND EBCDIC CODES.
STACKABLE VERTICALLY AND HORIZONTALLY.
COLUMN CATHODE.
EASY MOUNTING ON P.C.BOARDS OR SOCKETS.
MECHANICALLY RUGGED.
STANDARD:GRAY FACE, WHITE DOT.
RoHS COMPLIANT.
SPEC NO: DSAC9233 REV NO: V.4 DATE: NOV/28/2005 PAGE: 2 O F 4
APPROVED: J. Lu CHECKED: Joe Lee DRAWN: Y.L.LI ERP:1332000493
Selection Guide
Part No. Dice Lens Type Iv (ucd)
@ 10mA
Min. Typ.
TC08-81YWA YELLOW (GaAsP/GaP) WHITE DIFFUSED 800 3195 Column Cathode
Description
Absolute Maximum Ratings at TA=25°C
Notes:
1. 1/10 Duty Cycle, 0.1ms Pulse Width.
2. 2mm below package base.
Electrical / Optical Characteristics at TA=25°C
Symbol Parameter Device Typ. Max. Test ConditionsUnits
λpeak Peak Wavelength Yellow 590 nm IF=20mA
λDDominant Wavelength Yellow 588 nm IF=20mA
∆λ1/2 Spectral Line Half-width Yellow 35 nm IF=20mA
C Capacitance Yellow 20 pF VF=0V;f=1MHz
VFForward Voltage Yellow 2.1 2.5 V IF=20mA
IRReverse Current Yellow 10 uA VR = 5V
Parameter Yellow Units
Power dissipation 105 mW
DC Forward Current 30 mA
Peak Forward Current [1] 140 mA
Reverse Voltage 5 V
Operating / Storage Temperature -40°C To +85°C
Lead Solder Temperature [2] 260°C For 5 Seconds
SPEC NO: DSAC9233 REV NO: V.4 DATE: NOV/28/2005 PAGE: 3 O F 4
APPROVED: J. Lu CHECKED: Joe Lee DRAWN: Y.L.LI ERP:1332000493
Yellow TC08-81YWA
SPEC NO: DSAC9233 REV NO: V.4 DATE: NOV/28/2005 PAGE: 4 O F 4
APPROVED: J. Lu CHECKED: Joe Lee DRAWN: Y.L.LI ERP:1332000493
Remarks:
If special sorting is required (e.g. binning based on forward voltage, luminous intensity/ luminous flux or wavelength),
the typical accuracy of the sorting process is as follows:
1. Wavelength: +/-1nm
2. Luminous Intensity/ Luminous Flux: +/-15%
3. Forward Voltage: +/-0.1V
Note: Accuracy may depend on the sorting parameters.
PACKING & LABEL SPECIFICATIONS TC08-81YWA
