Bridge Rectifier Features: * * * * * * Glass passivated. Surge overload rating -60 amperes peak. Ideal for printed circuit board. Reliable low cost construction utilizing moulded plastic technique results in expensive product. Mounting position : Any. Lead : Sliver plated copper lead. Reverse Voltage - 1,000 V Forward Current - 2 Amperes WOBM Dimensions : Inches (Millimetres) www.element14.com www.farnell.com www.newark.com Page <1> 06/07/11 V1.1 Bridge Rectifier Maximum Ratings and Electrical Characteristics Rating at 25C ambient temperature unless otherwise specified. Single phase, half wave, 60 Hz, resistive or inductive load. For capacitive load, derate current by 20%. Characteristics Symbol 2W10MG Maximum Recurrent Peak Reverse Voltage VRRM 1,000 Maximum RMS Bridge Input Voltage VRMS 700 VDC 1,000 I (AV) 2 Maximum DC Blocking Voltage Maximum Average Forward Rectified Current at TA = 25C Unit V A Peak Forward Surge Current, 8.3 ms Single Half Sine-wave Super Imposed on Rated Load IFSM 60 I2t Rating for Fusing (t < 8.3 ms) I2t 15 A2s Maximum Forward Voltage Drop Per Element at 2 A Peak VF 1.1 V Maximum Reverse Current at Rated DC Blocking Voltage IR 10 1 A mA Typical Junction Capacitance Per Element (Note 1) CJ 30 pF Operating Temperature Range TJ TJ = 25C TJ = 100C TSTG Storage Temperature Range -55 to +150 C Note : 1. Measured at 1 MHz and applied reverse Voltage of 4 V dc. Rating and Characteristics Curves Maximum Non-Repetitive Peak Forward Surge Current Average Forward Output Current Amperes Peak Forward Surge Current, Amperes Forting Curve Output Rectified Current Number of Cycles at 60 Hz Ambient Temperature (C) www.element14.com www.farnell.com www.newark.com Page <2> 06/07/11 V1.1 Bridge Rectifier Rating and Characteristics Curves Typical Forward Characteristics Instantaneous Reverse Current, Microamperes Instantaneous Forward Current Amperes Typical Reverse Characteristics Percent of Rated Peak Reverse Voltage Instantaneous Forward Voltage, Volts Capacitance, (pF) Typical Junction Capacitance Per Bridge Element Reverse Voltage, Volts Important Notice : This data sheet and its contents (the "Information") belong to the members of the Premier Farnell group of companies (the "Group") or are licensed to it. No licence is granted for the use of it other than for information purposes in connection with the products to which it relates. No licence of any intellectual property rights is granted. The Information is subject to change without notice and replaces all data sheets previously supplied. The Information supplied is believed to be accurate but the Group assumes no responsibility for its accuracy or completeness, any error in or omission from it or for any use made of it. Users of this data sheet should check for themselves the Information and the suitability of the products for their purpose and not make any assumptions based on information included or omitted. Liability for loss or damage resulting from any reliance on the Information or use of it (including liability resulting from negligence or where the Group was aware of the possibility of such loss or damage arising) is excluded. This will not operate to limit or restrict the Group's liability for death or personal injury resulting from its negligence. Multicomp is the registered trademark of the Group. (c) Premier Farnell plc 2011. www.element14.com www.farnell.com www.newark.com Page <3> 06/07/11 V1.1