PVA1352N - International Rectifier

General Description

The PVA13 Series AC Relay (PVA) is a single-pole,

normally open, solid-state replacement for

electromechanical relays used for general purpose

switching of analog signals. It utilizes International

Rectifier’s HEXFET power MOSFETs as the output

switches, driven by an integrated circuit photovoltaic

generator of novel construction. The output switch is

controlled by radiation from a GaAlAs light emitting

diode (LED), which is optically isolated from the

photovoltaic generator.

The PVA13 Series overcomes the limitations of both

conventional electromechanical and reed relays by

offering the solid state advantages of long life, fast

operating speed, low pick up power, bounce-free

operation, low thermal offset voltages and miniature

package. These advantages allow product

improvement and design innovations in many

applications such as process control, multiplexing,

automatic test equipment and data acquisition.

The PVA13 can switch analog signals from

thermocouple level to 100 Volts peak AC or DC

polarity. Signal frequencies into the RF range are

easily controlled and switching rates up to 450Hz are

achievable. The extremely small thermally generated

offset voltages allow increased measurement

accuracies.

These relays are packaged in 8-pin, molded DIP

packages and available with either thru-hole or

surface-mount (“gull-wing”) leads, in plastic shipping

tubes.

Applications

Process Control

Data Acquisition

Test Equipment

Multiplexing and Scanning

Features

Bounce-Free Operation

1010 Off-State Resistance

1,000 V/µsec dv/dt

5 mA Input Sensitivity

4,000 VRMS I/O Isolation

Solid-State Reliability

UL Recognized

ESD Tolerance:

4000V Human Body Model

500V Machine Model

(HEXFET is the registered trademark for International Rectifier Power MOSFETs)

PVA1354NS-TPbF

Part Identification

PVA1352NPbF

PVA1354NPbF

PVA1352NSPbF

PVA1354NSPbF

thru-hole

surface-mount

(gull-wing)

surface-mount

tape and reel

Microelectronic Power IC

HEXFET® Power MOSFET Photovoltaic Relay

Single-Pole, Normally-Open, 0-100V AC/DC, 375mA

Series PVA13NPbF

Electrical Specifications (-40°C ≤ TA ≤ +85°C unless otherwise specified)

INPUT CHARACTERISTICS PVA1352N PVA1354N Units

Minimum Control Current (see figures 1 and 2) DC

For 325mA Continuous Load Current 2 mA@25°C

For 370mA Continuous Load Current 5 mA@40°C

For 190mA Continuous Load Current 5 mA@85°C

Maximum Control Current for Off-State Resistance at 25°C 10 µA(DC)

Control Current Range (Caution: current limit input LED. See figure 6) 2.0 to 25 mA(DC)

Maximum Reverse Voltage 6.0 V(DC)

International Rectifier does not recommend the use of this product in aerospace, avionics, military or life support applications.

Users of this International Rectifier product in such applications assume all risks of such use and indemnify International

Rectifier against all damages resulting from such use.

GENERAL CHARACTERISTICS (PVA1352N and PVA1354N) Units

Dielectric Strength: Input-Output 4000 VRMS

Insulation Resistance: Input-Output @ 90VDC 1012 @ 25°C - 50% RH Ω

Maximum Capacitance: Input-Output 1.0 pF

Max. Pin Soldering Temperature (1.6mm below seating plane, 10 seconds max.) +260

Ambient Temperature Range: Operating -40 to +85 °C

Storage -40 to +100

OUTPUT CHARACTERISTICS PVA1352N PVA1354N Units

Operating Voltage Range 0 to ± 100 V(peak)

Maxiumum Load Current 40°C, I LED 5mA 375 mA(DC)

Response Time @25°C (see figures 7 and 8)

Maximum T(on) @ 12mA Control, 50 mA Load, 50 VDC 150 µs

Maximum T(off) @ 12mA Control, 50 mA Load, 50 VDC 125 µs

Maximum On-state Resistance 25°C (Pulsed) (figure 4) 50 mA Load, 5mA Control 5Ω

Minimum Off-state Resistance 25°C @ 80 VDC (see figure 5) 1081010 Ω

Maximum Thermal Offset Voltage @ 5.0mA Control 0.2 µvolts

Minimum Off-State dv/dt 1000 V/µs

Typical Output Capacitance (see figure 9) 11pF @ 50VDC

Series PVA13NPbF

Figure 1. Current Derating Curves Figure 2. Typical Control Current Requirements

Figure 3.Typical On Characteristics Figure 4. Typical Normalized On-Resistance

Rd(on) (Νormalized to 25°C)

ILED (mA)

Ambient Temperature (°C)

Max. Load Current (mA)

VDD (volts)

Load Current (mA)

85ºC

LED

= 5mA, Forced Air

25ºC

40ºC

60ºC

Pulsed, 25ºC

Ambient Temperature (°C)

Max. Load Current (mA)

LED

=10mA

LED

=5mA

LED

=2mA

0.0 0.5 1.0 1.5 2.0 2.5 3.0

0 20 40 60 80 100

500

450

400

350

300

250

200

150

100

800

700

600

500

400

300

200

100

Series PVA13NPbF

IDOff/IDOff 25°C

Figure 5. Normalized Off-State Leakage Figure 6. Input Characteristics

(Current Controlled)

Figure 7.Typical Delay Times Figure 8. Delay Time Definitions

LED Forward Voltage Drop (Volts DC)

Input Current (mA)

Ambient Temperature (°C)

Delay Time (µS)

I LED (mA)

100

1000

0 5 10 15 20

Ton

Tdl

Toff

Series PVA13NPbF

Figure 9. Typical Output Capacitance

Typical Capacitance (pF)

VDD Drain to Drain Voltage

100

0 1020304050

yp p (p )

Wiring Diagram

Case Outlines

01-2013 00 (MS-001AB)

Note: For the most current drawing please refer to IR website at: http://www.irf.com/package/

Series PVA13NPbF

01-2019 00

IR WORLD HEADQUARTERS: 101 N. Sepulveda Blvd., El Segundo, California 90245, USA

Data and specifications subject to change without notice

To contact International Rectifier, please visit http://www.irf.com/whoto-call/

† Qualification standards can be found at International Rectifier’s web site: http://www.irf.com/product-info/reliability

†† Applicable version of JEDEC standard at the time of product release

Date Comments

• Added Qualification Information Table on

e 6

• Updated data sheet with new IR corporate template

Revision History

4/24/2015

Note: For the most current drawing please refer to IR website at: http://www.irf.com/package/

PVA1352NPbF

PVA1354NPbF

PVA1352NSPbF MSL4

PVA1354NSPbF

PVA1354NS-TPbF

RoHS compliant Yes

Qualification information

†

Moisture Sensitivity

Level

Qualification level Industrial

(per JEDEC JESD47I

††

guidelines)

N/A

(per JEDEC J-STD-020E & JEDEC J-STD-033C

††

)