Series PVA13NPbF Microelectronic Power IC HEXFET(R) Power MOSFET Photovoltaic Relay Single-Pole, Normally-Open, 0-100V AC/DC, 375mA General Description The PVA13 Series AC Relay (PVA) is a single-pole, normally open, solid-state replacement for electromechanical relays used for general purpose switching of analog signals. It utilizes International Rectifier's HEXFET power MOSFETs as the output switches, driven by an integrated circuit photovoltaic generator of novel construction. The output switch is controlled by radiation from a GaAlAs light emitting diode (LED), which is optically isolated from the photovoltaic generator. The PVA13 Series overcomes the limitations of both conventional electromechanical and reed relays by offering the solid state advantages of long life, fast operating speed, low pick up power, bounce-free operation, low thermal offset voltages and miniature package. These advantages allow product improvement and design innovations in many applications such as process control, multiplexing, automatic test equipment and data acquisition. The PVA13 can switch analog signals from thermocouple level to 100 Volts peak AC or DC polarity. Signal frequencies into the RF range are easily controlled and switching rates up to 450Hz are achievable. The extremely small thermally generated offset voltages allow increased measurement accuracies. These relays are packaged in 8-pin, molded DIP packages and available with either thru-hole or surface-mount ("gull-wing") leads, in plastic shipping tubes. Applications Process Control Data Acquisition Test Equipment Multiplexing and Scanning Features Bounce-Free Operation 1010 Off-State Resistance 1,000 V/sec dv/dt 5 mA Input Sensitivity 4,000 VRMS I/O Isolation Solid-State Reliability UL Recognized ESD Tolerance: 4000V Human Body Model 500V Machine Model Part Identification PVA1352NPbF PVA1354NPbF thru-hole PVA1352NSPbF PVA1354NSPbF PVA1354NS-TPbF surface-mount (gull-wing) surface-mount tape and reel (HEXFET is the registered trademark for International Rectifier Power MOSFETs) 1 www.irf.com (c) 2015 International Rectifier Submit Datasheet Feedback April 24, 2015 Series PVA13NPbF Electrical Specifications (-40C TA +85C unless otherwise specified) INPUT CHARACTERISTICS PVA1352N PVA1354N Units Minimum Control Current (see figures 1 and 2) For 325mA Continuous Load Current For 370mA Continuous Load Current For 190mA Continuous Load Current 2 5 5 DC mA@25C mA@40C mA@85C Maximum Control Current for Off-State Resistance at 25C 10 A(DC) 2.0 to 25 mA(DC) 6.0 V(DC) Control Current Range (Caution: current limit input LED. See figure 6) Maximum Reverse Voltage OUTPUT CHARACTERISTICS PVA1352N Operating Voltage Range PVA1354N Units 0 to 100 V(peak) 375 mA(DC) Maximum T(on) @ 12mA Control, 50 mA Load, 50 VDC 150 s Maximum T(off) @ 12mA Control, 50 mA Load, 50 VDC 125 s Maxiumum Load Current 40C, I LED 5mA Response Time @25C (see figures 7 and 8) Maximum On-state Resistance 25C (Pulsed) (figure 4) 50 mA Load, 5mA Control Minimum Off-state Resistance 25C @ 80 VDC (see figure 5) 10 Maximum Thermal Offset Voltage @ 5.0mA Control 5 10 8 10 0.2 Minimum Off-State dv/dt 1000 Typical Output Capacitance (see figure 9) 11pF GENERAL CHARACTERISTICS (PVA1352N and PVA1354N) V/s @ 50VDC Units Dielectric Strength: Input-Output Insulation Resistance: Input-Output @ 90VDC Maximum Capacitance: Input-Output Max. Pin Soldering Temperature (1.6mm below seating plane, 10 seconds max.) Ambient Temperature Range: volts 4000 VRMS 1012 @ 25C - 50% RH 1.0 pF +260 Operating -40 to +85 Storage -40 to +100 C International Rectifier does not recommend the use of this product in aerospace, avionics, military or life support applications. Users of this International Rectifier product in such applications assume all risks of such use and indemnify International Rectifier against all damages resulting from such use. 2 www.irf.com (c) 2015 International Rectifier Submit Datasheet Feedback April 24, 2015 Series PVA13NPbF 500 400 350 ILED=10mA 300 250 ILED=5mA 200 150 ILED=2mA 100 Max. Load Current (mA) Max. Load Current (mA) 450 50 0 0 20 40 60 80 100 ILED (mA) Ambient Temperature (C) Figure 1. Current Derating Curves Figure 2. Typical Control Current Requirements Load Current (mA) 700 Pulsed, 25C 25C 40C 60C 600 500 400 300 85C 200 I LED = 5mA, Forced Air 100 0 0.0 0.5 1.0 1.5 2.0 2.5 3.0 VDD (volts) Figure 3.Typical On Characteristics 3 Rd(on) (ormalized to 25C) 800 www.irf.com (c) 2015 International Rectifier Ambient Temperature (C) Figure 4. Typical Normalized On-Resistance Submit Datasheet Feedback April 24, 2015 IDOff/IDOff 25C Input Current (mA) Series PVA13NPbF LED Forward Voltage Drop (Volts DC) Ambient Temperature (C) Figure 6. Input Characteristics Figure 5. Normalized Off-State Leakage (Current Controlled) Delay Time (S) 1000 Ton Tdly 100 Toff 10 0 5 10 15 20 I LED (mA) Figure 7.Typical Delay Times 4 www.irf.com (c) 2015 International Rectifier Figure 8. Delay Time Definitions Submit Datasheet Feedback April 24, 2015 Series PVA13NPbF 100 Wiring Diagram Typical Capacitance (pF) yp p (p ) 90 80 70 60 50 40 30 20 10 0 0 10 20 30 40 50 VDD Drain to Drain Voltage Figure 9. Typical Output Capacitance Case Outlines 01-2013 00 (MS-001AB) Note: For the most current drawing please refer to IR website at: http://www.irf.com/package/ 5 www.irf.com (c) 2015 International Rectifier Submit Datasheet Feedback April 24, 2015 Series PVA13NPbF 01-2019 00 Note: For the most current drawing please refer to IR website at: http://www.irf.com/package/ Qualification information Industrial (per JEDEC JESD47I guidelines) Qualification level Moisture Sensitivity Level RoHS compliant PVA1352NPbF N/A PVA1354NPbF PVA1352NSPbF MSL4 PVA1354NSPbF (per JEDEC J-STD-020E & JEDEC J-STD-033C ) PVA1354NS-TPbF Yes Qualification standards can be found at International Rectifier's web site: http://www.irf.com/product-info/reliability Applicable version of JEDEC standard at the time of product release Revision History Date 4/24/2015 Comments * Added Qualification Information Table on page 6 * Updated data sheet with new IR corporate template IR WORLD HEADQUARTERS: 101 N. Sepulveda Blvd., El Segundo, California 90245, USA Data and specifications subject to change without notice To contact International Rectifier, please visit http://www.irf.com/whoto-call/ 6 www.irf.com (c) 2015 International Rectifier Submit Datasheet Feedback April 24, 2015