RPC Series * Proportional controller * Ratings from 15A to 40A @ 480 VAC * 500k or 1M Ohm potentiometer control * For use with resistive loads only PRODUCT SELECTION Description 120 VAC 240 VAC 480 VAC 15 A 25 A 40 A RPC1215 RPC2415 RPC4815 RPC1225 RPC2425 RPC4825 RPC1240 RPC2440 RPC4840 120 VAC 240 VAC 480 VAC 90-130 400 10 5000 yes 200-240 600 7 500 yes 400-480 1200 3 500 no 15 A 25 A 40 A 15 70 150 1.6 1.48 94 25 80 250 1.6 1.02 260 40 90 625 1.6 0.63 1620 RPC12XX RPC24XX RPC48XX 150K (1W) 1M (1/2W) 1M (1/2W) OUTPUT SPECIFICATIONS (voltage) (1) Description Operating Voltage (47-63Hz) [Vrms] Transient Overvoltage [Vpk] Maximum Off-State Leakage Current @ Rated Voltage [mArms] Minimum Off-State dv/dt @ Maximum Rated Voltage [V/sec] (2) Snubber (Internal) OUTPUT SPECIFICATIONS (current) (1) Description Maximum Load Current [Arms] (3) Minimum Load Current [mArms] Maximum Surge Current (16.6ms) [Apk] Maximum On-State Voltage Drop @ Rated Current [Vpk] Thermal Resistance Junction to Case (Rjc) [C/W] Maximum It for Fusing (8.3 msec) [A sec] INPUT SPECIFICATIONS (1) Description Variable Resistor Size (4) GENERAL SPECIFICATIONS Description Minimum Power Factor (with Maximum Load) Dielectric Strength, Input/Output/Base (50/60Hz) Ambient Operating Temperature Range Ambient Storage Temperature Range Weight (typical) Encapsulation Terminals Recommended Terminal Screw Torque Range: 0.6 2500 Vrms -30 to 80 C -40 to 125 C 3.2 oz (90g) Thermally conductive Epoxy Screws and saddle Clamps Furnished, Unmounted 6-32 Screws -10 in lbs. 8-32 and 10-32 Screws -20 in. lbs. (Screws dry without grase) GENERAL NOTES 1) All parameters at 25C unless otherwise specified. 2) Off-State dv/dt test method per EIA/NARM standard RS-443 3) Heat sinking required, see derating curves. 4) Potentiometer should be line voltage rated. MECHANICAL SPECIFICATIONS THERMAL DERATE INFORMATION PERCENTAGE ON VS INPUT RESISTANCE AGENCY APPROVALS Rev. 032111 ANNEX - ENVIROMENTAL INFORMATION