PCM-9343 DM&P Vortex86DX-1.0 GHz 3.5" SBC, Ultra Low Power, Onboard Memory, Dual LAN, PC/104 Features NEW DM&P Vortex86DX, onboard DDR2 memory up to 512 MB Display type: CRT, 24-bit LVDS, 24-bit TTL Supports Floating Point Unit, total power consumption 4 ~ 6 Watts Dual Lan: 10/100 LAN1 and 10/100 LAN2, supports PC/104 (8-bit/16-bit ISA) expansion Supports embedded software APIs and utilities, OS: DOS, WinCE, WinXPE and Linux Software APIs: Watchdog I2C BIOS flash eSOS Brightness GPIO Backlight On/Off Utilities: Flash Lock Embedded Security ID Specifications Processor System Memory CPU Frequency L2 Cache System Chipset BIOS Technology Max. Capacity Onboard memory Chipset VRAM Graphics Engine Display LVDS VGA TTL LCD Dual Display Speed Ethernet Controller Connector WatchDog Timer CompactFlash Storage Rear I/O SATA SPI Flash Serial Ethernet KB/Mouse VGA Reset Button USB Serial Internal I/O Expansion Power Parallel(LPT) GPIO I2C PC/104 slot Power Type Power Supply Voltage Power Consumption (Typical) Power Consumption (Max, test in HCT) Environment Physical Characteristics Battery Operational Non-Operational Dimensions (L x W) Weight DM&P Vortex86DX 1.0 GHz, supports floating Point Unit (FPU) 1.0 GHz 256 KB DM&P Vortex86DX + SMI SM712 Award integrated 16 Mbit ROM in SOC DDR2 333 MHz SDRAM on board 512 MB Onboard 256 MB or 512 MB SMI SM712 2D graphics chip 4 MB internal memory 62.5 MHz single clock/cycle engine (EM+) 86 MHz single clock/cycle engine (EM4+) Designed to accelerate DirectDraw Supports up to 1024 x 768 @ 24-bit LVDS LCD Panel Supports up to 1024 x 768 @ 85 Hz Supports up to 1024 x 768 @ 24-bit TFT LCD Panel CRT + TTL, CRT + LVDS 10/100 Mbps on LAN1 10/100 Mbps on LAN2 LAN1: 10/100 Mbps on DM&P Vortex86DX LAN2: 10/100 Mbps on Realtek RTL8110SC RJ-45 on LAN1, box header on LAN2 Internal: 2 sets, 32.768 kHz frequency source to count a 24-bit counter so the time range is from 30.5 sec to 512 sec with resolution 30.5 sec Supports CompactFlash card TYPE I/II (Primary Master IDE Channel) Supports 2 channels Ultra-DMA 100 1 Optional onboard 4MB SPI Flash Disk (Supported by request) 1 (COM1 supports RS-232) 1 (10/100 Mbps LAN1) 1 1 1 4 x USB 2.0 3 COM (COM2, COM3, COM4) COM2 supports RS-232/422/485 COM3/COM4 supports RS-232 1 16-bit GPIO 1 PC/104 Expansion(8/16-Bit ISA) AT Single +5V boot up, (+12V for LCD, ISA) PCM-9343L-S6A1E: 5V : 0.44A PCM-9343F-S6A1E: 5V : 0.81A PCM-9343FG-S6A1E: 5 V : 1.03A PCM-9343L-S6A1E: 5V : 0.746 A PCM-9343F-S6A1E: 5V : 1.09 A PCM-9343FG-S6A1E: 5 V : 1.18 A Lithium 3 V / 210 mAH 0 ~ 60 C (32 ~ 140 F) Operating: 0 ~ 60 C (32 ~ 140 F) (Operating humidity: 40 C @ 85% RH non-condensing) Non-Operating: -40 C ~ 85 C and 60 C @ 95% RH non-condensing 146 x 102 mm (5.7" x 4") 0.85 kg (1.87 lb), weight of total package 3.5" Single Board Computers All product specifications are subject to change without notice Last updated : 05-Aug-2010 PCM-9343 Board Diagram 256MB/512MB DDR2 on board MAC+PHY CF 10/100 LAN Connector x 1 4 port USB 2.0 ACARD IDE to SATA SATA USB 2.0 Connector x 4 LPT Connector x 1 DM&P Vortex86DX COM (COM2: RS232/422/485) (COM1/3/4: RS-232) Connector x 4 16-bit GPIO ISA Bus PC/104 16Mbit SPI BIOS PS2 KB/MS Connector x 1 PCI Bus 4 MB SPI EEROM (Optional) Ethernet RTL8110SCL 10/100 LAN Connector x 1 CRT VGA Connector x 1 TTL 24-bit TTL Connector x 1 SMI 712 24-bit LVDS Connector x 1 NS DS90C385A Ordering Information Part No. PCM-9343L-S6A1E PCM-9343F-S6A1E PCM-9343FG-S6A1E PCM-9343FGZ-S6A1E Onboard Memory 256 MB 256 MB 512 MB 512 MB TTL LVDS CRT 24-bit 24-bit 24-bit 24-bit 24-bit 24-bit Yes Yes Yes 10/100 LAN1 1 1 1 1 10/100 LAN2 1 1 Buzzer LPT Yes Yes Yes Yes 1 1 1 1 Packing List Part No. 1700008894 1700060202 1700100250 1701140201 1700260250 1703100121 1700002142 Description PCM-9343 SBC Startup Manual Utility CD SATA 7P 30 cm cable PS2 6P x 2 20 cm cable COM3/4 IDE D-SUB 25 cm cable COM2 IDE D-SUB 20 cm cable LPT IDE 26P D-SUB 25 cm cable USB 2 x 5P-2.0 12 cm W/BKT cable LAN IDE 2.0 15 cm cable RS-232/ 422/485 1 1 1 1 RS-232 1 3 3 3 USB 2.0 2 4 4 4 CF SATA Expansion 1 1 1 1 1 1 1 PC/104 PC/104 PC/104 PC/104 ATX Power - AT Power Yes Yes Yes Yes Thermal Solution Passive Passive Passive Passive Operational Temp. 0 ~ 60 C 0 ~ 60 C 0 ~ 60 C -20 ~ 80 C Optional Accessories Quantity x1 x1 x2 x1 x1 x1 x1 Part No. 1703150102 Description SATA 10 cm Power cable Embedded OS/API Embedded OS/API WinCE 5.0 WinCE 6.0 Win XPE Part No. 2070009764 2070009537 20070009528 Software API 2056343000 Description CE 5.0 Pro PCM-9343 V1.3 ENG Image CE 6.0 Pro PCM-9343 V1.3 ENG Image XPE for PCM-9343 SUSI 3.0 SW API for PCM-9343 B:20100122 XP Online Download www.advantech.com/products Value-Added Software Services Software API: An interface that defines the ways by which an application program may request services from libraries and/or operating systems. Provides not only the underlying drivers required but also a rich set of user-friendly, intelligent and integrated interfaces, which speeds development, enhances security and offers add-on value for Advantech platforms. It plays the role of catalyst between developer and solution, and makes Advantech embedded platforms easier and simpler to adopt and operate with customer applications. Software APIs Control GPIO SMBus I2C Monitor General Purpose Input/Output is a flexible parallel interface that allows a variety of custom connections. It allows users to monitor the level of signal input or set the output status to switch on/off a device. Our API also provides Programmable GPIO, which allows developers to dynamically set the GPIO input or output status. SMBus is the System Management Bus defined by Intel(R) Corporation in 1995. It is used in personal computers and servers for low-speed system management communications. The SMBus API allows a developer to interface a embedded system environment and transfer serial messages using the SMBus protocols, allowing multiple simultaneous device control. I2C is a bi-directional two wire bus that was developed by Philips for use in their televisions in the 1980s. The I2C API allows a developer to interface with an embedded system environment and transfer serial messages using the I2C protocols, allowing multiple simultaneous device control. Display Watchdog Hardware Monitor Hardware Control A watchdog timer (WDT) is a device that performs a specific operation after a certain period of time if something goes wrong and the system does not recover on its own. A watchdog timer can be programmed to perform a warm boot (restarting the system) after a certain number of seconds. The Hardware Monitor (HWM) API is a system health supervision API that inspects certain condition indexes, such as fan speed, temperature and voltage. The Hardware Control API allows developers to set the PWM (Pulse Width Modulation) value to adjust fan speed or other devices; it can also be used to adjust the LCD brightness. Power Saving Make use of Intel SpeedStep technology to reduce power power consumption. The system will automatically adjust the CPU Speed depending on system loading. The Brightness Control API allows a developer to interface with an embedded device to easily control brightness. Brightness Control CPU Speed The Backlight API allows a developer to control the backlight (screen) on/off in an embedded device. System Throttling Backlight Refers to a series of methods for reducing power consumption in computers by lowering the clock frequency. These APIs allow the user to lower the clock from 87.5% to 12.5%. Software Utilities BIOS Flash The BIOS Flash utility allows customers to update the flash ROM BIOS version, or use it to back up current BIOS by copying it from the flash chip to a file on customers' disk. The BIOS Flash utility also provides a command line version and API for fast implementation into customized applications. Embedded Security ID The embedded application is the most important property of a system integrator. It contains valuable intellectual property, design knowledge and innovation, but it is easily copied! The Embedded Security ID utility provides reliable security functions for customers to secure their application data within embedded BIOS. Monitoring The Monitoring utility allows the customer to monitor system health, including voltage, CPU and system temperature and fan speed. These items are important to a device; if critical errors happen and are not solved immediately, permanent damage may be caused. eSOS The eSOS is a small OS stored in BIOS ROM. It will boot up in case of a main OS crash. It will diagnose the hardware status, and then send an e-mail to a designated administrator. The eSOS also provides remote connection: Telnet server and FTP server, allowing the administrator to rescue the system. Flash Lock Flash Lock is a mechanism that binds the board and CF card (SQFlash) together. The user can "Lock" SQFlash via the Flash Lock function and "Unlock" it via BIOS while booting. A locked SQFlash cannot be read by any card reader or boot from other platforms without a BIOS with the "Unlock" feature. 3.5" Single Board Computers All product specifications are subject to change without notice Last updated : 05-Aug-2010