09/2008
AWT6302R
PCS/CDMA 3.4V/28dBm
Linear Power Amplier Module
Data Sheet - Rev 2.1
M9 Package
8 Pin 3 mm x 3 mm x 1.1 mm
Surface Mount Module
Figure 1: Block Diagram
FEATURES
• InGaP HBT Technology
• High Efciency:
39%, VMODE = 0 V
40%, VMODE = +2.85 V (no mode switching)
• Low Quiescent Current: 50 mA
• Low Leakage Current in Shutdown Mode: <1 µA
• VREF = +2.85 V (+2.75 V min over temp)
• Optimized for a 50 Ω System
• Low Prole Miniature Surface Mount Package:
1.1 mm
• CDMA 1XRTT, 1xEV-DO Compliant
• Pinout Enables Easy Phone Board Migration
From 4 mm x 4 mm Package
• RoHS-Compliant Package, 250 oC MSL-3
APPLICATIONS
• CDMA/EVDO PCS-band Wireless Handsets and
Data Devices
PRODUCT DESCRIPTION
The AWT6302R meets the increasing demands for
higher efciency and linearity in CDMA 1X handsets,
while reducing pcb area by 44%. The package pinout
was chosen to enable handset manufacturers to
switch from a 4 mm x 4 mm PA module with very few
layout changes to the phone board. The PA module is
optimized for VREF = +2.85 V. The device is manufactured
on an advanced InGaP HBT MMIC technology offering
state-of-the-art reliability, temperature stability, and
ruggedness. Selectable bias modes that optimize
efciency for different output power levels, and a
shutdown mode with low leakage current, increase
handset talk and standby time. The self-contained
3 mm x 3 mm x 1.1 mm surface mount package
incorporates matching networks optimized for output
power, efciency, and linearity in a 50 Ω system.
Bias Control
VCC
VREF
RFIN RFOUT
GND
VMODE
1
7
5
8
6
GND at slug (pad)
3
4
2
VCC
GND
2Data Sheet - Rev 2.1
09/2008
AWT6302R
Figure 2: Pinout (X-ray Top View)
Table 1: Pin Description
VCC
RFOUT
VREF
RFIN
VMODE
GND
VCC
GND
1
GND
2
8
7
GND
6
5
3
4
PIN NAME DESCRIPTION
1 V
CC
Supply Voltage
2RF
IN
RF Input
3 V
MODE
Mode Control Voltage
4 V
REF
Reference Voltage
5GND Ground
6GND Ground
7RF
OUT
RF Output
8 V
CC
Supply Voltage
Data Sheet - Rev 2.1
09/2008
AWT6302R
3
ELECTRICAL CHARACTERISTICS
Table 2: Absolute Minimum and Maximum Ratings
Stresses in excess of the absolute ratings may cause permanent damage.
Functional operation is not implied under these conditions. Exposure
to absolute ratings for extended periods of time may adversely affect
reliability.
Table 3: Operating Ranges
The device may be operated safely over these conditions; however, parametric performance is guaranteed only
over the conditions dened in the electrical specications.
Notes:
(1) For operation at Vc c = +3.2 V, Po u t is derated by 0.5 dB.
PARAMETER MIN MAX UNIT
Supply Voltage (V
CC
)0+5 V
Mode Control Voltage (V
MODE
)0+3.5 V
Reference Voltage (V
REF
)0+3.5 V
RF Input Power (P
IN
)-+10 dBm
Storage Temperature (T
STG
)-40 +150 °C
PARAMETER MIN TYP MAX UNIT COMMENTS
Operating Frequency (f) 1850 -1910 MHz
Supply Voltage (VCC)+3.2 +3.4 +4.2 V
Reference Voltage (VREF)+2.75
0
+2.85
-
+3.1
+0.5 VPA "on"
PA "shut down"
Mode Control Voltage (VMODE)+2.5
0
+2.85
-
+3.1
+0.5 VLow Bias Mode
High Bias Mode
RF Output Power (POUT)27.5 (1) +28.0 -dBm
Case Temperature (TC)-30 -+85 °C
4Data Sheet - Rev 2.1
09/2008
AWT6302R
Table 4: Electrical Specications
(TC = +25 °C, VCC = +3.4 V, VREF = +2.85 V, 50 Ω system)
Notes:
1. ACPRs and Efciency Limits at mid-band only.
PARAMETER MIN TYP MAX UNIT COMMENTS
Gain 24.5
22
26.5
24.5
29
27 dB P
OUT
= +28 dBm, V
MODE
= 0 V
P
OUT
= +16 dBm, V
MODE
= +2.85 V
Adjacent Channel Power
at +1.25 MHz offset
Primary Channel BW =1.23 MHz
Adjacent Channel BW = 30 kHz
-
-
-51
-51
-47
-47 dBc P
OUT
= +28 dBm, V
MODE
= 0 V
P
OUT
= +16 dBm, V
MODE
= +2.85 V
Adjacent Channel Power
at +2.25 MHz offset
Primary Channel BW =1.23 MHz
Adjacent Channel BW = 30 kHz
-
-
-63
-69
-57
-57 dBc P
OUT
= +28 dBm, V
MODE
= 0 V
P
OUT
= +16 dBm, V
MODE
= +2.85 V
Power-Added Efficiency 37
8.3
39
9
-
-%P
OUT
= +28 dBm, V
MODE
= 0 V
P
OUT
= +16 dBm, V
MODE
= +2.85 V
Quiescent Current (Icq) -50 62 mA V
MODE
= +2.85 V
Reference Current -2.3 4mA through V
REF
pin, PA "on"
Mode Control Current -0.3 1.0 mA through V
MODE
pin, V
MODE
= +2.85 V
Leakage Current -<1 5µA V
CC
= +4.2 V, V
REF
= 0 V,
V
MODE
= 0 V
Noise in Receive Band --132 -130 dBm/Hz 1930 MHz to 1990 MHz
Harmonics
2fo
3fo, 4fo
-
-
-40
-55
-30
-30 dBc
Input Impedance - - 2.5:1 VSWR
Spurious Output Level
(all spurious outputs) - - -65 dBc
P
OUT
< +28 dBm
In-band load VSWR < 5:1
Out-of-band load VSWR < 10:1
Applies over all operating ranges
Load mismatch stress with no
permanent degradation or failure 8:1 - - VSWR Applies over full operating range
Data Sheet - Rev 2.1
09/2008
AWT6302R
5
Table 5: Electrical Specications
(TC = +25 °C, VCC = +3.4 V, VREF = +2.85 V, VMODE = +2.85 V, 50 Ω system)
Notes:
1. ACPRs and Efciency Limits at mid-band only.
PARAMETER MIN TYP MAX UNIT COMMENTS
Gain 24
22
26
24.5
28
27 dB P
OUT
= +28 dBm
P
OUT
= +16 dBm
Adjacent Channel Power
at +1.25 MHz offset
Primary Channel BW - 1.23 MHz
Adjacent Channel BW = 30 kHz
-
-
-52
-51
-47
-47 dBc P
OUT
= +28 dBm
P
OUT
= +16 dBm
Adjacent Channel Power
at +2.25 MHz offset
Primary Channel BW - 1.23 MHz
Adjacent Channel BW = 30 kHz
-
-
-61
-69
-57
-57 dBc P
OUT
= +28 dBm
P
OUT
= +16 dBm
Power-Added Efficiency 37
8.3
40
9
-
-%P
OUT
= +28 dBm
P
OUT
= +16 dBm
Quiescent Current (Icq) -48 62 mA V
MODE
= +2.85 V
Reference Current -2.3 4mA through V
REF
pin, PA "on"
Mode Control Current -0.3 1.0 mA through V
MODE
pin
Leakage Current -<1 5µA V
CC
= +4.2 V, V
REF
= 0 V,
V
MODE
= 0 V
Noise in Receive Band --132 -130 dBm/Hz 1930 MHz to 1990 MHz
Harmonics
2fo
3fo, 4fo
-
-
-40
-55
-30
-30 dBc
Input Impedance - - 2.5:1 VSWR
Spurious Output Level
(all spurious outputs) - - -65 dBc
P
OUT
< +28 dBm
In-band load VSWR < 5:1
Out-of-band load VSWR < 10:1
Applies over all operating ranges
Load mismatch stress with no
permanent degradation or failure 8:1 - - VSWR Applies over full operating range
6Data Sheet - Rev 2.1
09/2008
AWT6302R
APPLICATION INFORMATION
To ensure proper performance, refer to all related
Application Notes on the ANADIGICS web site:
http://www.anadigics.com
Shutdown Mode
The power amplier may be placed in a shutdown
mode by applying logic low levels (see Operating
Ranges table) to both the VREF and VMODE voltages.
Table 6: Bias Control
Bias Modes
The power amplier may be placed in either a Low Bias
mode or a High Bias mode by applying the appropriate
logic level (see Operating Ranges table) to the VMODE
voltage. The Bias Control table lists the recommended
modes of operation for various applications.
Figure 3: Application Circuit
APPLICATION
POUT
LEVELS
BIAS
MODE VREF VMODE
CDMA - low power <+16dBm Low +2.85 V +2.85 V
CDMA - high power >+16 dBm High +2.85 V 0 V
Shutdown -Shutdown 0 V 0 V
RF IN 2
1
6
7
8
5
4
3
V
REF
RFIN
VMODE GND
GND
V
CC VCC
RFOUT
VCC2
VMODE
VCC1
C5
2.2µF
RF OUT
C2
0.01µF
C4
2.2 µF
VREF
C3
1000 pF
C6
68 pF
C1
1000 pF
GND
at slug
Data Sheet - Rev 2.1
09/2008
AWT6302R
7
PACKAGE OUTLINE
Figure 4: M9 Package Outline - 8 Pin 3 mm x 3 mm x 1.1 mm Surface Mount Module
Figure 5: Branding Specication
8Data Sheet - Rev 2.1
09/2008
AWT6302R
COMPONENT PACKAGING
Table 7: Tape & Reel Dimensions
Figure 6: Tape & Reel Packaging
PACKAGE TYPE TAPE WIDTH POCKET PITCH REEL CAPACITY MAX REEL DIA
3 mm x 3 mm x 1 mm 12 mm 4 mm 2500 7"
Data Sheet - Rev 2.1
09/2008
AWT6302R
9
NOTES
WARNING
ANADIGICS products are not intended for use in life support appliances, devices or systems. Use of an ANADIGICS product
in any such application without written consent is prohibited.
IMPORTANT NOTICE
ANADIGICS, Inc.
141 Mount Bethel Road
Warren, New Jersey 07059, U.S.A.
Tel: +1 (908) 668-5000
Fax: +1 (908) 668-5132
URL: http://www.anadigics.com
E-mail: Mktg@anadigics.com
ANADIGICS, Inc. reserves the right to make changes to its products or to discontinue any product at any time without notice.
The product specications contained in Advanced Product Information sheets and Preliminary Data Sheets are subject to
change prior to a product’s formal introduction. Information in Data Sheets have been carefully checked and are assumed
to be reliable; however, ANADIGICS assumes no responsibilities for inaccuracies. ANADIGICS strongly urges customers
to verify that the information they are using is current before placing orders.
Data Sheet - Rev 2.1
09/2008
10
AWT6302R
ORDERING INFORMATION
ORDER NUMBER TEMPERATURE
RANGE
PACKAGE
DESCRIPTION COMPONENT PACKAGING
AWT6302RM9Q7 -30 °C to +85 °C
RoHS-Compliant
8 Pin
3 mm x 3 mm x 1 mm
Surface Mount Module
Tape and Reel, 2500 pieces per Reel