C3D10060G VRRM Silicon Carbide Schottky Diode 600 V IF (TC=135C) = 14 A Z-Rec Rectifier (R) Qc = 24 nC Features * * * * * * * = Package 600-Volt Schottky Rectifier Zero Reverse Recovery Current Zero Forward Recovery Voltage High-Frequency Operation Temperature-Independent Switching Behavior Extremely Fast Switching Positive Temperature Coefficient on VF TO-263-2 Benefits * * * * * Replace Bipolar with Unipolar Rectifiers Essentially No Switching Losses Higher Efficiency Reduction of Heat Sink Requirements Parallel Devices Without Thermal Runaway PIN 1 CASE PIN 2 Applications * * * * Switch Mode Power Supplies (SMPS) Boost diodes in PFC or DC/DC stages Free Wheeling Diodes in Inverter stages AC/DC converters Part Number Package Marking C3D10060G TO-263-2 C3D10060 Maximum Ratings (TC = 25 C unless otherwise specified) Symbol Value Unit Test Conditions VRRM Repetitive Peak Reverse Voltage 600 V VRSM Surge Peak Reverse Voltage 600 V VDC DC Blocking Voltage 600 V Continuous Forward Current 29 14 10 A TC=25C TC=135C TC=151C 44 30.5 A TC=25C, tP = 10 ms, Half Sine Wave TC=110C, tP=10 ms, Half Sine Wave IF Note Fig. 3 IFRM Repetitive Peak Forward Surge Current IFSM Non-Repetitive Peak Forward Surge Current 90 71 A TC=25C, tp = 10 ms, Half Sine Wave TC=110C, tp = 10 ms, Half Sine Wave Fig. 8 IF,Max Non-Repetitive Peak Forward Surge Current 860 680 A TC=25C, tP = 10 s, Pulse TC=110C, tP = 10 s, Pulse Fig. 8 Ptot Power Dissipation 125 54 W TC=25C TC=110C Fig. 4 Diode dV/dt ruggedness 200 V/ns VR=0-600V i2t value 40.5 25 A2s Operating Junction and Storage Temperature -55 to +175 C dV/dt i2dt TJ , Tstg 1 Parameter C3D10060G Rev. H, 01-2017 TC=25C, tP=10 ms TC=110C, tP=10 ms Electrical Characteristics Symbol Parameter Typ. Max. Unit Test Conditions Note VF Forward Voltage 1.5 2.0 1.8 2.4 V IF = 10 A TJ=25C IF = 10 A TJ=175C Fig. 1 IR Reverse Current 10 20 50 200 A VR = 600 V TJ=25C VR = 600 V TJ=175C Fig. 2 QC Total Capacitive Charge 24 nC VR = 400 V, IF = 10 A di/dt = 500 A/s TJ = 25C Fig. 5 C Total Capacitance 460.5 44 40 pF VR = 0 V, TJ = 25C, f = 1 MHz VR = 200 V, TJ = 25C, f = 1 MHz VR = 400 V, TJ = 25C, f = 1 MHz Fig. 6 EC Capacitance Stored Energy 3.6 J VR = 400 V Fig. 7 Note: This is a majority carrier diode, so there is no reverse recovery charge. Thermal Characteristics Symbol RJC Parameter Thermal Resistance from Junction to Case Typ. Unit Note 1.2 C/W Fig. 9 Typical Performance 100 30 25 90 TJ = -55 C TJ = 75 C TJ = 125 C TJ = 175 C 10 5 0 0.0 0.5 1.0 1.5 2.0 2.5 3.0 3.5 0 200 400 600 800 1000 1200 FowardVVoltage, (V) VF (V) F Figure 1. Forward Characteristics 2 80 70 TJ = 175 C 60 TJ = 125 C 50 TJ = 75 C R 15 Reverse Leakage ICurrent, (mA) IRR (mA) 20 F Foward Current, I (A) IF (A) TJ = 25 C C3D10060G Rev. H, 01-2017 4.0 4.5 5.0 40 TJ = 25 C 30 TJ = -55 C 20 10 0 0 100 200 300 400 500 600 700 800 900 1000 ReverseVVoltage, (V) VR (V) R Figure 2. Reverse Characteristics Typical Performance 100 160 10% Duty 20% Duty 30% Duty 50% Duty 70% Duty DC 80 140 120 100 F PTot(W) (W) PTOT IF(peak) (A) I (A) 60 40 80 60 40 20 20 0 0 25 50 75 100 125 150 175 25 C TTCC(C) 150 500 175 Conditions: TJ = 25 C Ftest = 1 MHz Vtest = 25 mV 450 400 30 350 25 Capacitance C (pF)(pF) CapacitiveQ Charge, (nC) QC (nC) C 125 Figure 4. Power Derating 20 15 10 300 250 200 150 100 5 50 0 0 100 200 300 400 500 600 700 ReverseVVoltage, (V) VR (V) R Figure 5. Total Capacitance Charge vs. Reverse Voltage 3 100 C Conditions: TJ = 25 C 35 75 C TTC (C) Figure 3. Current Derating 40 50 C3D10060G Rev. H, 01-2017 0 0 1 10 100 (V) VR (V) ReverseVVoltage, R Figure 6. Capacitance vs. Reverse Voltage 1000 Typical Performance 1,000 10 9 7 IIFSM (A) (A) 6 FSM 5 C Capacitance StoredE Energy, J) (mJ) EC ( 8 4 100 TJ_initial = 25 C TJ_initial = 110 C 3 2 1 0 0 100 200 300 400 500 600 10 10E-6 700 ReverseVVoltage, (V) VR (V) Figure 8. Non-repetitive peak forward surge current versus pulse duration (sinusoidal waveform) Figure 7. Capacitance Stored Energy Thermal Resistance (C/W) 1E-3 tp (s) Time, tp (s) R 1 100E-6 0.5 0.3 0.1 100E-3 0.05 0.02 SinglePulse 10E-3 0.01 1E-3 1E-6 10E-6 100E-6 1E-3 T (Sec) 10E-3 Figure 9. Transient Thermal Impedance 4 C3D10060G Rev. H, 01-2017 100E-3 1 10E-3 Package Dimensions Package TO-263-2 POS Inches Millimeters Min Max Min Max A 0.17 0.18 4.32 4.57 A1 - 0.01 - 0.25 b 0.028 0.037 0.71 0.94 b2 0.045 0.055 1.15 1.4 c 0.014 0.025 0.356 0.635 c2 0.048 0.055 1.22 1.4 D 0.35 0.37 8.89 9.4 D1 0.255 0.324 6.48 8.23 10.28 E 0.395 0.405 10.04 E1 0.31 0.318 7.88 8.08 e 0.1 BSC. 2.54 BSC. L 0.58 0.62 14.73 15.75 L1 0.09 0.11 2.29 2.79 L2 0.045 0.055 1.15 1.39 L3 0.05 0.07 1.27 1.77 q 0 8 0 8 Note: Tab "M" may not be present PIN 1 M CASE PIN 2 Recommended Solder Pad Layout 15.990 8.890 10.668 3.556 1.540 2.540 Tjb May 2015 MX+DI Part Number Package Marking C3D10060G TO-263-2 C3D10060 Note: Recommended soldering profiles can be found in the applications note here: http://www.wolfspeed.com/power_app_notes/soldering 5 C3D10060G Rev. H, 01-2017 Diode Model Diode Model CSD04060 Vf T = VT + If*RT VT= 0.965 + (Tj * -1.3*10-3) RT= 0.096 + (Tj * 1.06*10-3) VfT = VT + If * RT VT = 0.94 + (TJ * -1.3*10-3) RT = 0.044 + (TJ * 4.4*10-4) VT RT Note: Tj = Diode Junction Temperature In Degrees Celsius, valid from 25C to 175C Notes * RoHS Compliance The levels of RoHS restricted materials in this product are below the maximum concentration values (also referred to as the threshold limits) permitted for such substances, or are used in an exempted application, in accordance with EU Directive 2011/65/EC (RoHS2), as implemented January 2, 2013. RoHS Declarations for this product can be obtained from your Wolfspeed representative or from the Product Ecology section of our website at http://www.wolfspeed.com/Power/Tools-and-Support/Product-Ecology. * REACh Compliance REACh substances of high concern (SVHCs) information is available for this product. Since the European Chemical Agency (ECHA) has published notice of their intent to frequently revise the SVHC listing for the foreseeable future,please contact a Cree representative to insure you get the most up-to-date REACh SVHC Declaration. REACh banned substance information (REACh Article 67) is also available upon request. * This product has not been designed or tested for use in, and is not intended for use in, applications implanted into the human body nor in applications in which failure of the product could lead to death, personal injury or property damage, including but not limited to equipment used in the operation of nuclear facilities, life-support machines, cardiac defibrillators or similar emergency medical equipment, aircraft navigation or communication or control systems, or air traffic control systems. Related Links * * * Cree SiC Schottky diode portfolio: http://www.wolfspeed.com/Power/Products#SiCSchottkyDiodes Schottky diode Spice models: http://www.wolfspeed.com/power/tools-and-support/DIODE-model-request2 SiC MOSFET and diode reference designs: http://go.pardot.com/l/101562/2015-07-31/349i Copyright (c) 2018 Cree, Inc. All rights reserved. The information in this document is subject to change without notice. Cree, the Cree logo, and Zero Recovery are registered trademarks of Cree, Inc. 6 C3D06060G Rev. H, 01-2018 Cree, Inc. 4600 Silicon Drive Durham, NC 27703 USA Tel: +1.919.313.5300 Fax: +1.919.313.5451 www.cree.com/power