ky SGS-THOMSON MICROELECTRONICS TPA SERIES TRISIL FEATURES BIDIRECTIONAL CROWBAR PROTECTION. a BREAKDOWN VOLTAGE RANGE: From 62 V To 270 V. a HOLDING CURRENT = Ip Suffix 12 = 120mA min. Suffix 18 = 180mA min. a PEAK PULSE CURRENT : Ipp = 50 A, 10/1000 ps. F 126 DESCRIPTION (Plastic) The TPAxx series has been designed to protect telecommunication equipments against lightning and transient induced by AC power lines. SCHEMATIC DIAGRAM IN ACCORDANCE WITH FOLLOWING STANDARDS : CCITT K17 - K20 { 10/700 ps 1.5kV 5/310 ps 38 A VDE 0433 { 10/700 ps 2kV 5/200 ps 5O A CNET { 0.5/700 ps 1.5kV 0.2/310 us 38 A ABSOLUTE RATINGS (limiting values) (-40C < Tamb < + 85C) Symbol Parameter Value Unit P Power dissipation on infinite heatsink Tamb = 50C 1.7 WwW IPP Peak pulse current 10/1000 ps 50 A See notel 8/20 Ls 100 ITSM Non repetitive surge peak on-state current tp= 20 ms 30 A di/dt Critical rate of rise of on-state current Non repetitive 100 A/us dv/at Critical rate of rise of off-state voltage 67% VBR 5 KV/Us Tstg Storage and operating junction temperature range -40 to +150 C Tj + 150 C TL Maximum lead temperature for soldering during 10 s. 230 C 1/7 259TPAxxx THERMAL RESISTANCES Symbol Parameter Value Unit Rth g- Junction to leads on infinite heatsink. 60 CAN Rth (j-a) Junction to ambient. on printed circuit. Llead = 10 mm 100 C/AN Note 1: 10/1000 us waveform. % tpp 100-9 10ps 50 Ld_..- 0 ! yt 1000 us ELECTRICAL CHARACTERISTICS Symbol Parameter VRM Stand-off voltage VBR Breakdown voltage VBO Breakover voltage IH Halding current VT On-state voltage IBO Breakover current IPP Peak pulse current a7 OT SGS-THOMSON PRU -S WGRTes. 260ELECTRICAL CHARACTERISTICS TPAxxx Type IRM @ VRM VBR @ IR VBo @ IBo VT c IH max min max max max max min note2 note3 | note4 note2 LA Vv Vv mA Vv mA Vv pF mA P TPA62A -120r18 2 56 62 1 82 300 2 150 TPA62B - 12 of 18 2 56 62 1 75 300 2 150 P TPA68A -12o0r18 2 61 68 1 90 300 2 150 TPA68B - 12 018 2 61 68 1 82 300 2 150 (1) TPA75A - 12 0f 18 2 67 75 1 100 300 2 150 (1) TPA75B - 12 018 2 67 75 1 91 300 2 150 (1) TPA82A - 12 0r 18 2 74 82 1 1093 300 2 150 (1) TPA82B - 12 0f 18 2 74 82 1 99 300 2 150 Suftix 12 (1) TPASIA - 12 0f 18 2 82 91 1 121 300 2 150 for 120 mA. (1) TPASIB - 12 or 18 2 82 91 1 110 300 2 150 P TPA100A - 12 of 18 2 30 100 1 133 300 2 100 TPA1OOB - 12 of 18 2 30 100 1 121 300 2 100 P TPA110A - 12 cr 18 2 99 110 1 147 300 2 100 TPA110B - 12 of 18 2 99 110 1 133 300 2 100 P TPA120A - 12 or 18 2 108 120 1 160 300 2 100 Suffix 18 TPA120B - 12 of 18 2 108 120 1 145 300 2 100 for 180 mA. P TPA130A - 12 or 18 2 117 130 1 173 300 2 100 TPA130B - 12 of 18 2 117 130 1 157 300 2 100 (1) TPA150A - 12 of 18 2 135 150 1 200 300 4 75 (1) TPA150B - 12 of 18 2 135 150 1 181 300 4 75 (1) TPAI60A - 12 of 18 2 144 160 1 213 300 4 75 (1) TPA160B - 12 or 18 2 144 160 1 193 300 4 75 P TPA180A - 12 of 18 2 162 180 1 240 300 4 75 TPA180B - 12 of 18 2 162 180 1 217 300 4 75 P TPA200A - 12 or 18 2 180 200 1 267 300 4 75 TPA200B - 12 of 18 2 180 200 1 241 300 4 75 P TPA220A - 12 or 18 2 198 220 1 293 300 4 75 TPA220B - 12 of 18 2 198 220 1 265 300 4 75 P TPA240A - 12 of 18 2 216 240 1 320 300 4 75 TPA240B - 12 or 18 2 216 240 1 289 300 4 75 P TPA270A - 12 or 18 2 243 270 1 360 300 4 75 TPA270B - 12 or 18 2 243 270 1 325 300 4 75 All parameters tested at 25C, except where indicated. P: (1): Note 2: Note 3: Note 4: Preferred device. These voltages are on request. See the reference test circuit for ly, Iso and Vao paramders. Square pulse Tp = 1 ms - Ir =3A. Va =1V, F =1MHz. OT SGS-THOMSON PRU -S WGRTes. 3/7 261TPAxxx REFERENCE TEST CIRCUIT FOR Ih, Iso and Veo parameters : Tp = 20ms Auto Rt Transformer 7 220V/2A fy [static [1400] relay. Re a o[ 2400 | P K | Vv VBo = out D.U.T N Bo :'H measure measure T & Transformer 220V/800 5A TEST PROCEDURE : a Pulse Test duration (Tp = 20ms): - For Bidirectional devices = Switch K is closed - For Unidirectional devices = Switch K is open. a Vout Selection - Device with Ver < 150 Volt - Vout = 250 Vams, Ri = 140 2. - Device with Ver 2 150 Volt - Vout = 480 Vrms, Re = 240 0. FUNCTIONAL HOLDING CURRENT (lp) TEST CIRCUIT = GO - NOGO TEST. Al : 20 uF :[D.u.T}: 220nF = 50 o| | a =| Vp =: Vbat = 48V : 1KV : al O Surge Generator 10/700 psec Vp =1KV/ Ipp = 25A This is a GO-NOGO Test which allows to confirm the halding current (IH) level in a functional test circuit. This test can be performed if the reference test circuit cant be implemented. TEST PROCEDURE : a 1) Adjust the current level at the In value by short circuiting the AK of the D.U.T. 2) Fire the D.U.T with a surge Current : Ipp = 25A , 10/700 pus. 3) The D.U.T will come back to the OFF-State withing a duration of 50 ms max. 4/7 . hy S68-THOMSON 262Figure 1 : Non repetitive surge peak on state current versus number of cycles. (with sinusoidal HrsmfA) T] Initial = 25C Number of cycle 1 10 160 1000 Figure 3 : Relative variation of holding current versus junction temperature. WHIT; 1 IHIT | = 25C) 1.2 1.0 SK 0.8 a, oN, 0.6 Me, NY 04 a Tj (C) 0.2 I I 0 20 40 60 80 #100 #120 140 150 TPAxxx Figure 2: On - state characteristics (typical values}. hrm (A) 100 16 Vim CV) 0.1 2 3 4 5 6 F 8 $$ 10 11 #12 Note: Fordevice with Ver > 150 Volt The Vr valueis twice that shown. 7 SGS-THOMSON o/7 PRU -S WGRTes. 263TPAxxx ORDER CODE TPA 130 A 12 RL TRISIL 50 A_ . - RL = tape and reel. - = Ammopack. BREAKDOWN VOLTAGE _! + HOLDING CURRENT: Veo TOLERANCE, - 12 = 120 mA. - 18 = 180 mA. MARKING : Logo, Date Code, Part Number. PACKAGE MECHANICAL DATA. F 126 Plastic. Ref Millimeters Inches min max min max L 6 L I be 0.76 0.86 0.03 0.034 Li) |note1 note 1| 1 2D : 3.05 : 0.12 G - 6.35 - 0.25 L 26 - 1.02 - Let |] |_| | Ly - 1.27 - 0.05 L. b> o | note 1 :The diameter @ bp is not controlled over zoneL{. Packaging : Standard packaging is in tape and reel. Si7 7 SGS-THOMSON , RUSK -2 WORTES 264TPAxxx Information furnished is believed to be accurate and reliable. However, SGS-THOMSON Microelectronics assumes no responsability for the consequences of use of such information nor for any infringement of patents or other rights of third parties which may results from its use. No license is granted by implication or otherwise under any patent or patent rights of SGS-THOMSON Microelectronics. Specifications mentioned in this publication are subject to change without notica. This publication supersedes and replaces all information previously supplied. SGS-THOMSCN Microelectronics products are not authorized for use ascritical componentsin life support devices or systems without express written approval of SGS-THOMSON Microelectonics. 1994 SGS-THOMSON Microelectronics - All Rights Reserved Purchase of PC Components by SGS-THOMSON Microelectronics, conveys a licence under the Philips PC Patent. Rights to use these components in an IC system, is grantade provided that the system conforms to the PC Standard Specitication as defined by Philips. SGS-THOMSON Microelectronics GROUP OF COMPANIES Australia - Brazil - France - Germany - Hong Kong - Italy - Japan - Korea - Malaysia - Malta - Morocco - The Netherlands - Singapore - Spain - Sweden - Switzerland - Taiwan - Thailand - United Kingdom - U.S.A 7? il Wg Sai