1970 by AMP Incorporated. All international tights reserved. A-Mir a) 1Ybs by U5. and foreign patenrs and/or patents pening. products covecwd AMP! A-MP* EXTRACTION TOOL 9$1038-3 FOR TYPE XI IS 7357 | AMP INCORPORATED PIN AND SOCKET CONTACTS RELEASED] 8-1-68 BEAL UL em eee REVISED 18-28-70 CONTACT NUMBER PIN SOCKET EXTRACTION TOOL 203816 203802 91038-3 203874 203875 KU ~ HANDLE. TYPE xI PIN CONTACT Oe Se TOOL TIP SHOULDER TYPE XI SOCKET CONTACT FIGURE 1 1. INTRODUCTION The A-MP Extraction Tool 91038-3 is designed to remove the Type XI Pin and Socket Contacts shown in Figure i from AMP-INCERT Rack and Panel Connectors. 2. EXTRACTION PROCEDURE CAUTION The Shoulder of the Tool Tip must bottom on the face of the connector BEFORE the tool handleis depressed. A. Extract Pin Contacts as follows: 1. Position the Pin in the hollowed portion of the tool tip. Then push the Tip straight in until the Shoulder bottoms on the face of the connector asshown in Figure 2. 2. Depress the spring-loaded hancie and the pin will back out of the connector cavity. B. Extract Socket Cantacts as follows: 1, Align the tool so that the contact will enter the hollowed portion of the tip. 2. Push the Tip straight into the cavity until the Shoulder bottoms on the face of the connector as shawn in Figure 3. 3. Depress the spring-loaded handle and the socket will back out of the cavity. PIN CONTACT RECEPTACLE INNER PLUNGER SOCKET CONTACT PLUG FIGURE 2 * TRADEMARK OF AMP |NCORPORATED FIGURE 3 PAGE ft OF 1