Electrical Specification Model No PA-1061-0 Part No PA-1061-02IL-LF Description 12V 60W AC Adaptor Revision A Issued Date Oct. 30, 2012 LITE-ON TECHNOLOGY CORP. 3 7 7,Lane 3,San Ho Rd,San-Shin Village,Da-Yuan Hsiang,Taoyuan Hsien 337,Taiwan, R.O.C. Approved By Checked By X Prepared By Change Record DCN No REV 00 Revision Description Modified form PA-1061-01LT-LF Date Jul. 17, 2012 1. 2.8 Safety: Hi-pot test from 1800Vac to 1850Vac X01 2. 4.1 EMS surge from 6KV(DM)/6KV(CM) to 1KV(DM)/2KV(CM) 3. 6.4 Weight from 450g to 32015g. X02 1. 6.3 DC cord: From 1500mm change to 1050mm A Release to factory Product modelPA-1061-02IL-LF Page 2 Jul. 18, 2012 Oct. 24, 2012 Oct. 30, 2012 RevisionA Date: Jul. 30, 2012 Contents 1. Description ........................................................................................................ 4 2. Electrical............................................................................................................ 4 2.1 2.2 2.3 2.4 Input Voltage ......................................................................................... 4 Input Frequency .................................................................................... 4 Input Current ......................................................................................... 4 Inrush Current ....................................................................................... 4 2.5 2.6 2.7 2.8 Hold-Up time ......................................................................................... 4 Input wattage......................................................................................... 4 Efficiency ............................................................................................... 4 Safety Test ............................................................................................ 4 2.9 2.10 Output Voltage and Current................................................................... 4 Ripple and Noise ................................................................................... 5 2.11 2.12 2.13 Over-Shoot and under-shoot ................................................................. 5 Protection .............................................................................................. 5 LED Indication ....................................................................................... 5 2.14 2.15 2.16 2.17 Rise time ............................................................................................... 5 Turn on delay time................................................................................. 5 Temperature Coeffience ........................................................................ 5 Transient Response .............................................................................. 5 3. Environment ...................................................................................................... 6 3.1 Temperature .......................................................................................... 6 3.2 Humidity ................................................................................................ 6 3.3 Altitude .................................................................................................. 6 4. EMC .................................................................................................................. 6 4.1 EMS ...................................................................................................... 6 4.2 EMI ........................................................................................................ 6 5. Reliability ........................................................................................................... 7 5.1 5.2 Life (E-cap.)........................................................................................... 7 M.T.B.F. ................................................................................................. 7 5.3 5.4 5.5 5.6 Temperature Rise. ................................................................................. 7 Burn-in .................................................................................................. 7 Vibration Test ........................................................................................ 7 Drop-Test............................................................................................... 7 6. Mechanical ........................................................................................................ 7 Product modelPA-1061-02IL-LF Page 3 RevisionA Date: Jul. 30, 2012 1. Description This product is a AC to DC power transfer device, it can provide for a 60W single dc output with constant voltage source. 2. Electrical 2.1 Input Voltage a. 100 - 240Vac Nominal. b. 90 - 264Vac Universal. 2.2 Input Frequency 47- 63Hz. 2.3 Input Current 1.5A max. at 90Vac input & dc output full-loading. 2.4 Inrush Current Inrush peak current and Joule integral will be measure at different line voltage at high ambient temperature. Peak current is within specified limit and Joule integral well below fuse and bridge spec. 2.5 Hold-Up time 10msec min. at dc output full-loading and 115Vac input. 2.6 Input wattage Less than 0.3W at 230Vac input & no load condition. 2.7 Efficiency Average efficiency 87% minimum min. at 25%, 50%, 75% & 100% of full-loading and 115/230Vac input (After warm up 20 minutes). 2.8 Safety Test a. Leakage current less than 0.25 mA at 254Vac, 50Hz. b. Hi-Pot test : 1850 Vac, 10mA, 1 - 3 Sec. between Primary to Secondary ground. c. Insulation resistance: at dc 500Vdc, 1 Sec. between Primary to Secondary circuit, IR shall >=20M. d. Grounding test : AC 30A , 2 Sec. between input safety ground and SELV output GND, GR 0.1. 2.9 Output Voltage and Current Vout (V) Range (V) 12V 11.4 - 12.6 Product modelPA-1061-02IL-LF Iout (min., A) 0 Page 4 Iout (max., A) 5 RevisionA Peak (10S, A) 6 Date: Jul. 30, 2012 2.10 Ripple and Noise Low frequency ripple ( < 100KHz ) <= 300mVpp, and Total composite Ripple and Noise. Less than 300mVp-p, tested by dc loading side parallel with a 10uF/EC. and 0.1uF/Ceramic. Capacitors and Measured Band Width 20MHz. 2.11 Over-Shoot and under-shoot Less than 10% of nominal Voltage value. 2.12 Protection a. SCP : Short circuit protection with auto. recovery function. b. OVP : Over voltage protection with shut down & latch off function. Tripped voltage will be less than 18Vdc. c. OCP : Over current protection with auto. recovery function, current limit : 9 A (max.) d. OTP: The adapter shall provide over temperature protection and if the temperature rises to set temperature point, the PSU shall be latch-off. 2.13 LED Indication Green light for Nominal operation. Blank or Flash for SCP mode. 2.14 Rise time Rise time shall be less than 50msec., it should be measured from 10% to 90% of the output voltage. 2.15 Turn on delay time The output voltage should turn on from AC on to settle within regulation in less than 3.0sec. 2.16 Temperature Coeffience Less than 0.2%/C 2.17 Transient Response Dynamic loading condition. DC output (V) I1 ( A ) I2 ( A ) dVmax.(V) Time-max. 12.0 0.0 1.7 +/- 1.0 10 msec. >=50mA/usec. 12.0 1.7 3.4 +/- 1.0 10 msec. >=50mA/usec. 12.0 3.4 50% of duty cycle. 5.0 +/- 1.0 10 msec. >=50mA/usec. Product modelPA-1061-02IL-LF Page 5 RevisionA dI/dT Date: Jul. 30, 2012 3. Environment 3.1 Temperature a. Operation : 0 to 40 b. Storage : -40 to 70 3.2 Humidity a. Operation : 20 to 80% b. Storage : 10 to 90% 3.3 Altitude From sea level to 2000m (operation). 4. EMC 4.1 EMS Test Item Test Specification IEC Standards ESD Contact +/- 8KV 61000-4-2 ESD Air +/- 15KV 61000-4-2 RS FR: 26MHz-1.0GHz, 61000-4-3 Field Strength: 3V/M EFT +/- 1KV (DM) & +/- 2KV (CM) 61000-4-4 SURGE +/- 1KV (DM) & +/- 2KV (CM) 61000-4-5 CS DIPS 3V/M 61000-4-6 0% 250Cy, 40% 5 Cy, 70% 5Cy 61000-4-11 4.2 EMI Standards Specification FCC Part 15,class B VCCI Class B CISPR Part 22,class B Product modelPA-1061-02IL-LF Page 6 RevisionA Date: Jul. 30, 2012 5. Reliability 5.1 Life (E-cap.) 12,000 hours (8 hours/day x 300 days/year x 5 years) At DC output full-loading, AC 115/230 Vac input & ambient temperature 25. 5.2 M.T.B.F. 50,000 Power On Hours at 25. 5.3 Temperature Rise. Less than 45 at nominal AC input / DC output full-loading and environment temperature 25+/-1 on Top/Bottom of plastic case. 5.4 Burn-in 100% Burn-In with 80~100% full-loading & 35~45 Environment temperature. 5.5 Vibration Test a. Non operation vibration with shipping container shall be 2G'S peak/7-50Hz, 4G'S /50-500Hz, after test no abnormally to be found. b. Operation vibration shall be 0.5G'S peak/10-60Hz, 3 AXES, after test no abnormally to be noted. 5.6 Drop-Test Test height is 100cm, after drop test no function abonormally to be noted. 6. Mechanical 6.1 Plastic enclosurePC+ABS material. 6.2 Physical Size120 mm( L ) * 60 mm ( W ) * 35 mm ( H ). 6.3 DC cord: 1050 mm, 16 wires. 6.4 Weight : 320 15g. Product modelPA-1061-02IL-LF Page 7 RevisionA Date: Jul. 30, 2012