Data brief
For further information contact your local STMicroelectronics sales office.
August 2011 Doc ID 022089 Rev 1 1/4
4
STEVAL-ISV009V1
300 W photovoltaic converter demonstration board
based on the SPV1020
Features
PWM mode DC-DC boost converter
Duty cycle controlled by MPPT algorithm with
0.2% accuracy
Operating voltage range: 0-40 V
Overvoltage, overcurrent and overtemperature
protection
Built-in soft-start
Up to 98% efficiency
Automatic transition to burst mode for
improved efficiency during low solar radiation
SPI interface
RoHS compliant
Description
The STEVAL-ISV009V1 demonstration board is
based on the SPV1020, which is a monolithic DC-
DC boost converter designed to maximize the
power generated by photovoltaic panels
independent of temperature and amount of solar
radiation.
The optimization of the power conversion is
obtained with embedded logic which performs the
MPPT (max power point tracking) algorithm on
the PV cells connected to the converter.
One or more converters can be housed in the
connection box of the PV panels, replacing the
bypass diodes and, thanks to the fact that the
maximum power point is locally computed, the
efficiency at system level is higher than that of
conventional topologies, where the MPP is
computed in the main centralized inverter.
For a cost effective application solution and
miniaturization needs, the SPV1020 embeds the
power MOSFETs for active switches and
synchronous rectification, minimizing the number
of external devices necessary. Furthermore, the
4-phase interleaved topology of the DC-DC
converter eliminates the need for electrolytic
capacitors, which would severely limit lifetime.
It works at a fixed frequency in PWM mode,
where the duty cycle is controlled by the
embedded logic running a “perturb & observe”
MPPT algorithm. The switching frequency,
internally generated and set by default at 100
kHz, is externally tunable, while the duty cycle can
range from 5% to 90% with a step of 0.2%.
Safety of the application is guaranteed by
stopping the drivers in case of output overvoltage
or overtemperature.
STEVAL-ISV009V1
www.st.com
Schematic diagram STEVAL-ISV009V1
2/4 Doc ID 022089 Rev 1
1 Schematic diagram
Figure 1. STEVAL-ISV009V1 circuit schematic
#
0'.$0'.$
6).?3.3?-
6).?3.3?-
!'.$
3(5430)?8#3
4%34?$!4!30)?$!4!?).
4%34?#,+30)?#,+
06
06
6OUT
6OUT
6/5 4?3.36/5 4?3.3
,
6?/54
#"#"#"#"#"
,6).
6). ,
#"#"#"#"#"
#"#"#"#"#"
6).,,
6).,,
#"#"#"#"#"
,
,
,
6).
6).?3.36).?3.3
6).
6##
6).
6?/54
$)!'30)?$!4!?/54
6?/54
0:?/54
6/54?3.36/54?3.36/54?3.36/54?3.3
/3#?).
#"
6?/54
#"
6?/54
#"
6?/54
6##
6).?3.3
#"
$)!'30)?$!4!?/54
/3#?).
6REG
6?/54
6?/54
*
#/.!4!
*
#/.!4!


























*
#/..&,%8
*
#/..&,%8
, U(, U(
# N&# N&
$
$)/$%
$
$)/$%
40
06?
40
06?
, U(, U(
2
-
2
-
# N&# N&
*
&!34/.
*
&!34/.
#
P&
#
P&
#
U&
2 K2 K
$
$)/$%
$
$)/$%
,U( ,U(
#
N&
#
N&
U&
#U&
2
K
2
K
#
N&
#
N&
$
$)/$%
$
$)/$%
#
P&
#
P&
#
,U( ,U(
2
K
2
K
$
3-"#!
$
3-"#!
$
3-"#!
$
3-"#!
#
U&
#
U&
*
&!34/.
*
&!34/.
U& #
,U(,U(
40
06?
40
06?
2 2
*
(%!$%2
*
(%!$%2
40
06?
40
06?
2 DNM2 DNM
$
$)/$%
$
$)/$%
#
N&
#
N&
$ $)/$%$ $)/$%
#
N&
#
N&
2
-
2
-
#
U&
#
U&
$ $)/$%$ $)/$%
40
06?
40
06?
!-6
STEVAL-ISV009V1 Revision history
Doc ID 022089 Rev 1 3/4
2 Revision history
Table 1. Document revision history
Date Revision Changes
08-Aug-2011 1 Initial release.
STEVAL-ISV009V1
4/4 Doc ID 022089 Rev 1
Please Read Carefully:
Information in this document is provided solely in connection with ST products. STMicroelectronics NV and its subsidiaries (“ST”) reserve the
right to make changes, corrections, modifications or improvements, to this document, and the products and services described herein at any
time, without notice.
All ST products are sold pursuant to ST’s terms and conditions of sale.
Purchasers are solely responsible for the choice, selection and use of the ST products and services described herein, and ST assumes no
liability whatsoever relating to the choice, selection or use of the ST products and services described herein.
No license, express or implied, by estoppel or otherwise, to any intellectual property rights is granted under this document. If any part of this
document refers to any third party products or services it shall not be deemed a license grant by ST for the use of such third party products
or services, or any intellectual property contained therein or considered as a warranty covering the use in any manner whatsoever of such
third party products or services or any intellectual property contained therein.
UNLESS OTHERWISE SET FORTH IN ST’S TERMS AND CONDITIONS OF SALE ST DISCLAIMS ANY EXPRESS OR IMPLIED
WARRANTY WITH RESPECT TO THE USE AND/OR SALE OF ST PRODUCTS INCLUDING WITHOUT LIMITATION IMPLIED
WARRANTIES OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE (AND THEIR EQUIVALENTS UNDER THE LAWS
OF ANY JURISDICTION), OR INFRINGEMENT OF ANY PATENT, COPYRIGHT OR OTHER INTELLECTUAL PROPERTY RIGHT.
UNLESS EXPRESSLY APPROVED IN WRITING BY TWO AUTHORIZED ST REPRESENTATIVES, ST PRODUCTS ARE NOT
RECOMMENDED, AUTHORIZED OR WARRANTED FOR USE IN MILITARY, AIR CRAFT, SPACE, LIFE SAVING, OR LIFE SUSTAINING
APPLICATIONS, NOR IN PRODUCTS OR SYSTEMS WHERE FAILURE OR MALFUNCTION MAY RESULT IN PERSONAL INJURY,
DEATH, OR SEVERE PROPERTY OR ENVIRONMENTAL DAMAGE. ST PRODUCTS WHICH ARE NOT SPECIFIED AS "AUTOMOTIVE
GRADE" MAY ONLY BE USED IN AUTOMOTIVE APPLICATIONS AT USER’S OWN RISK.
Resale of ST products with provisions different from the statements and/or technical features set forth in this document shall immediately void
any warranty granted by ST for the ST product or service described herein and shall not create or extend in any manner whatsoever, any
liability of ST.
ST and the ST logo are trademarks or registered trademarks of ST in various countries.
Information in this document supersedes and replaces all information previously supplied.
The ST logo is a registered trademark of STMicroelectronics. All other names are the property of their respective owners.
© 2011 STMicroelectronics - All rights reserved
STMicroelectronics group of companies
Australia - Belgium - Brazil - Canada - China - Czech Republic - Finland - France - Germany - Hong Kong - India - Israel - Italy - Japan -
Malaysia - Malta - Morocco - Philippines - Singapore - Spain - Sweden - Switzerland - United Kingdom - United States of America
www.st.com