Stratum 3E High Stability Oven Stabilized Oscillator OH200-Series OCXO - OCVCXO 2111 Comprehensive Drive Aurora, Illinois 60505 Phone: 630- 851- 4722 Fax: 630- 851- 5040 www.conwin.com Description Connor-Winfield's high stability OH200series are exceptionally precise frequency standards, excellent for use in cellular base stations, test equipment, Synchronous Ethernet, VSAT and Stratum 3E applications These unique OCXO and OCVCXO products provide temperature stabilities in the range of 3 ppb to 25 ppb, over the commercial, extended commercial or the industrial temperature range. Power requirements are 3W over the commercial temperature range and 4.5W over the industrial temperature range. Additionally, excellent aging is achieved through the use of overtone SC cut crystals. The OH200 series is available with CMOS logic or Sinewave output along with Electronic Frequency Tuning. These oscillators provide outstanding phase noise that varies depending on frequency. Frequencies are available from 5.0 to 40.0 MHz. Allan Variance specifications are rated for primary reference standards. Warm up times are on the order of 5 minutes to 0.10 ppm of final frequency. 0939 03CF 0-610 0 2 H O Hz 12.8 M Features * Frequency Range: 5.0 to 40.0 MHz * OCXO - Fixed Frequency * OCVCXO - Voltage Controlled Frequency * 3.3 Vdc, 5.0 Vdc or 12.0 Vdc Operation * Available Frequency Stabilities: 3 ppb, 5 ppb, 10 ppb or 25 ppb * Available Temperature Ranges: 0 to 70C, -20 to 70C, -40 to 70C or -40 to 85C * Low Phase Noise / Phase Jitter * Available Outputs: CMOS or Sinewave * Package: 1.1" x 1.4" x 0.5" (CO-8) * RoHS Compliant / Lead Free Ordering Information OH200Package OH200- = 1.1x1.4 CO8 6 10 03 C Temperature Range Frequency Stability 06 = 3 ppb 10 = 5 ppb 20 = 10 ppb 50 = 25 ppb Supply Voltage Output Type OCXO Type 03 = 3.3 Vdc 05 = 5.0 Vdc 12 = 12.0 Vdc C = CMOS S = Sinewave F = Fixed Freq. V = Voltage Controlled Freq. 5 = 0 to 70C 6 = -40 to 85C 7 = -20 to 70C 8 = -40 to 70C F {(Fmax-Fmin)/2.Fo} - 012.8M Output Frequency Frequency Format -xxx.xM Min -xxx.xxxxxxM Max *Amount of numbers after the decimal point. M = MHz Example Part Number: OH200-61003CF-012.8M = 1.1" x 1.4" x 0.5" CO-8 package, -40 to 85C temperature range, 5.0 ppb frequency stability, 3.3 Vdc supply voltage, CMOS square wave output, fixed frequency OCXO, 12.8 MHz output frequency. To order a OH200-61003CF with an output frequency of: 6.4 MHz = OH200-61003CF-006.4M To order a OH200-61003CF with an output frequency of 16.384 MHz = OH200-61003CF-016.384M. Bulletin Page Revision Date Cx193 1 of 4 08 21 Mar 2012 OH200-712005SV-040.0M = 1.1" x 1.4" x 0.5" CO-8 package, -20 to 70C temperature range, 10.0 ppb frequency stability, 5.0 Vdc supply voltage, Sinewave output, voltage controlled output frequency OCVCXO, 40 MHz output frequency. Specifications subject to change without notice. All dimensions in inches. (c) Copyright 2010 The Connor-Winfield Corporation 2111 Comprehensive Drive Aurora, Illinois 60505 Phone: 630- 851- 4722 Fax: 630- 851- 5040 www.conwin.com Absolute Maximum Ratings Parameter Storage Temperature Supply Voltage - 3.3 Vdc (Vcc) Supply Voltage - 5.0 Vdc (Vcc) Supply Voltage - 12 Vdc (Vcc) Control Voltage (Vc) Minimum -55 -0.5 -0.5 -0.5 -0.5 Nominal - Maximum Units Notes Maximum Units Notes 125 4.5 7.0 13.5 7.0 C Vdc Vdc Vdc Vdc Operating Specifications Parameter Minimum Nominal Center Frequency: (Fo) 5.0 40.0 Operating Temperature Range: Temperature Code 5 0 70 Temperature Code 6 -40 85 Temperature Code 7 -20 70 Temperature Code 8 -40 70 Frequency Calibration: -0.1 0.1 Frequency Stability vs. Change in Temperature: Stability Code 06 -3.0 3.0 Stability Code 10 -5.0 5.0 Stability Code 20 -10.0 10.0 Stability Code 50 -25.0 25.0 Frequency Stability vs Load -5.0 5.0 Frequency Stability vs Voltage -5.0 5.0 Aging: Daily: 5 MHz to 20 MHz -1.0 1.0 >20 MHz to 40 MHz -2.0 2.0 Aging: First Year: 5 MHz to 20 MHz -50 50 >20 MHz to 40 MHz -100 100 Lifetime Tolerance: (20 Years) 5 MHz to 20 MHz- -300 300 >20 MHz to 40 MHz -500 500 Supply Voltage: (Vcc) (Note: Power supply turn-on ramp time must be > 5 ms to 90% of Vcc.) Voltage Code 03 3.13 3.30 3.47 Voltage Code 05 4.75 5.00 5.25 Voltage Code 12 11.40 12.00 12.60 Power Consumption: Turn-On 0 to 70C Models 3.00 -20 to 70C Models 3.20 -20 to 75C Models 3.30 -40 to 85C Models 3.80 Power Consumption: Steady State @ 25C 0 to 70C Models 1.10 -20 to 70C Models 1.10 -20 to 75C Models 1.20 -40 to 85C Models 1.50 Phase Jitter: (BW: 10 Hz to Fo/2) Models with Fo: 5 MHz to 20 MHz 1.0 Models with Fo: >20 MHz to 40 MHz 2.0 Short Term Allan Deviation (1s) 1.0E-11 Start-Up Time: 500 Warm Up Time @ 25C: 5 MHz C C C C ppm @ 25C ppb ppb ppb ppb ppb ppb 1 1 1 1 5% 5% ppb/day ppb/day 2 2 ppb ppb ppb ppb 3 3 Vdc Vdc Vdc W W W W 4 4 4 4 W W W W 4 4 4 4 ps RMS ps RMS RMS ms minutes 5 Notes: 1. Frequency stability vs. change in temperature [(Fmax-Fmin)/2.Fo]. 2. At time of shipment after 48 hours of operation. 3. Inclusive of calibration, operating temperature, supply voltage change, load change and 20 years aging. 4. Measured with Vcc = Nominal, in calm air. 5. Measured @ 25C, within 5 minutes, referenced one hour after turn-on. Specifications subject to change without notice. All dimensions in inches. (c) Copyright 2010 The Connor-Winfield Corporation Bulletin Page Revision Date Cx193 2 of 4 08 21 Mar 2012 2111 Comprehensive Drive Aurora, Illinois 60505 Phone: 630- 851- 4722 Fax: 630- 851- 5040 www.conwin.com Phase Noise Characteristics Typical Phase Noise for OXCO's with CMOS Output SSB Phase Noise 5 - 12 MHz @1Hz offset @ 10Hz offset @ 100Hz offset @ 1KHz offset @ 10KHz offset @ 100KHz offset 12.1- 20 MHz -85 -115 -140 -145 -150 -150 -80 -110 -135 -140 -150 -150 20.1 - 30 MHz -70 -100 -125 -140 -150 -150 30.1 - 40 MHz -65 -95 -120 -140 -150 -150 Units dBc/Hz dBc/Hz dBc/Hz dBc/Hz dBc/Hz dBc/Hz OCVCXO Input Characteristics (OCXO Type Code V) Parameter Control Voltage Range: 3.3 Vdc Models 5.0 Vdc Models 12.0 Vdc Models Frequency Pullability: Models with Fo 5 to 20 MHz Models with Fo >20 to 40 MHz Input Impedance Minimum Nominal Maximum Units Notes 0.30 0.50 0.50 1.65 2.50 2.50 3.00 4.50 4.50 V V V Vcc = 3.3 Vdc Vcc = 5.0 Vdc Vcc = 12.0 Vdc 0.4 0.6 100K - - ppm ppm Ohms CMOS Output Characteristics (Output Code C) Parameter Load Output Voltage: 3.3 Vdc Models High (Voh) Low (Vol) 5.0 Vdc Models High (Voh) Low (Vol) 12.0 Vdc Models High (Voh) Low (Vol) Duty Cycle at 50% of Vcc Rise / Fall Time: 10% to 90% Spurious Output Minimum Nominal Maximum Units 3.0 4.7 4.7 45 - 50 - 0.4 0.4 0.4 55 6 -80 V - 15 - pF Notes V V % ns dBc Sinewave Output Characteristics (Output Code S) Parameter Load Output Power Harmonics Spurious Minimum 5.0 - Nominal 50 - Maximum -30 -80 Units Ohms dBm: dBc dBc Notes Package Characteristics OH200 Package Hermetically sealed, resistive welded package with grounded case. Environmental Characteristics Shock Sinusoidal Vibration Random Vibration Moisture Marking Permanency Attachment Method PCB Resistance to Solder Heat Solder Process 500 G's 1ms, Halfsine, 3 shocks per direction, per MIL-STD 202G, Method 213B Test Condition D. 0.06" D.A. or 10G's Peak, 10 to 500 Hz, per MIL-STD-202G, Method 204D, Test Condition A. 5.35 G's rms. 20 to 2000 Hz per MIL-STD-202G, Method 214,Test Condition 1A, 15 minutes each axis. 10 cycles, 95% RH, Per MIL-STD-202G, Method 112. Per MIL-STD-202G, Method 215J. Through Hole Mounted Per MIL-STD-202G, Method 210, Condition E. RoHS compliant, lead free. See solder profile. Bulletin Page Revision Date Specifications subject to change without notice. All dimensions in inches. (c) Copyright 2010 The Connor-Winfield Corporation Cx193 3 of 4 08 21 Mar 2012 2111 Comprehensive Drive Aurora, Illinois 60505 Phone: 630- 851- 4722 Fax: 630- 851- 5040 www.conwin.com Re stabilization Time Off Time <1 Hour <6 Hour <24 Hour 1 to 16 Days >16 Days Re stabilization Time <2 Hours * <12 Hours * <48 Hours * 48 Hours + 1/4 Off Time * <6 Days * * For a given off time, the time required to meet daily aging, short term stability and TEV requirements. Package Marking Package Outline 0.500 Max. 12.70mm 0.035 Dia. 0.88mm Dia. 0.244 6.2mm 0.025 0.635mm 1.417 36mm 0939 OH200-61003CF 1 0.600 15.24mm 5 0.700 17.78mm Bottom View 4 12.8 MHz 2 0.350 8.9mm 1.063 27mm Pin 1 3 0.700 17.78mm 1.000 25.4mm Keep Out Area: Under the OCXO is a keep out area, do not place any parts in this area. Test Circuit Vcc Pin Connections Pin Connection 1: Control Voltage or N/C 2: N/C 3: Supply Voltage (Vcc) 4: Output 5: Ground (Case) Output Vcc N/C .01 uF 15 pF Total Output Load N/C Ground or Control Voltage Solder Profile Temperature 260C CMOS Output Waveform 260C 90% 220C 180C 150C 50% 120C 10% 0 10 s Up to 120 s 60 to 90 s Typical Typical Bulletin Meets IPC/JEDEC J-STD-020C Page Revision Date Specifications subject to change without notice. All dimensions in inches. (c) Copyright 2010 The Connor-Winfield Corporation Cx193 4 of 4 08 21 Mar 2012