TLP170J TOSHIBA Photocoupler Photorelay TLP170J Modem*Fax Cards, Modems in PC Telecommunications PBX Security Equipment Measurement Equipment Unit: mm The Toshiba TLP170J consists of a gallium arsenide infrared emitting diode optically coupled to a photo-MOSFET in a 4-pin SOP package. This photorelay requires 1mA of LED current to turn it on. It is suitable for applications that need electrical power savings. * 4-pin SOP (2.54SOP4): Height = 2.1 mm, Pitch = 2.54 mm * 1-Form-A * Peak OFF-state voltage: 600 V (min) * Trigger LED current: 1 mA (max) * ON-state current: 90 mA (max) * ON-state resistance: 40 (max, t < 1 s) * ON-state resistance: 60 (max, continuous) * Isolation voltage: 1500 Vrms (min) JEDEC * UL recognized: UL1577, File No.E67349 JEITA * c-UL recognized CSA Component Acceptance Service No. 5A File No.E67349 TOSHIBA 11-5H1 Weight: 0.1 g (typ.) Pin Configuration (top view) 1 4 2 3 1: Anode 2: Cathode 3: Drain 4: Drain Internal Circuit 1 4 2 3 1 2009-05-15 TLP170J Absolute Maximum Rating (Ta = 25C) Characteristics Symbol Rating Unit IF 50 mA IF/C -0.5 mA/C Pulse forward current (100 s pulse, 100 pps) IFP 1 A Reverse voltage VR 5 V Junction temperature Tj 125 C VOFF 600 V ION 90 mA ION/C -0.9 mA/C Tj 125 C Storage temperature range Tstg -55~125 C Operating temperature range Topr -40~85 C Lead soldering temperature (10 s) Tsol 260 C BVS 1500 Vrms Forward current Forward current derating (Ta 25C) LED OFF-state output terminal voltage Detector ON-state current ON-state current derating (Ta 25C) Junction temperature Isolation voltage (AC, 1 min, R.H. 60%) (Note 1) Note: Using continuously under heavy loads (e.g. the application of high temperature/current/voltage and the significant change in temperature, etc.) may cause this product to decrease in the reliability significantly even if the operating conditions (i.e. operating temperature/current/voltage, etc.) are within the absolute maximum ratings. Please design the appropriate reliability upon reviewing the Toshiba Semiconductor Reliability Handbook ("Handling Precautions"/"Derating Concept and Methods") and individual reliability data (i.e. reliability test report and estimated failure rate, etc). Note 1: Device considered a two-terminal device: LED side pins shorted together, and detector side pins shorted together. Recommended Operating Conditions Characteristics Symbol Min Typ. Max Unit Supply voltage VDD 480 V Forward current IF 2 25 mA ON-state current ION 70 mA Operating temperature Topr -20 65 C Note: Recommended operating conditions are given as a design guideline to obtain expected performance of the device. Additionally, each item is an independent guideline respectively. In developing designs using this product, please confirm specified characteristics shown in this document. Electrical Characteristics (Ta = 25C) Characteristics LED Test Condition Min Typ. Max Unit Forward voltage VF IF = 10 mA 1.0 1.15 1.3 V Reverse current IR VR = 5 V 10 A V = 0, f = 1 MHz 30 pF OFF-state current IOFF VOFF = 600 V 1 1000 nA Capacitance COFF V = 0, f = 1 MHz 75 pF Capacitance Detector Symbol CT 2 2009-05-15 TLP170J Coupled Electrical Characteristics (Ta = 25C) Characteristics Symbol Test Condition Min Typ. Max Unit Trigger LED current IFT ION = 90 mA 0.4 1 mA Return LED current IFC IOFF = 100 A 0.1 mA ON-state resistance RON ION = 90 mA, IF= 2 mA, t < 1 s 40 ION = 90 mA, IF= 2 mA, continuous 45 60 Min Typ. Max Unit 0.8 pF Isolation Characteristics (Ta = 25C) Characteristics Symbol Capacitance input to output VS = 0 V, f = 1 MHz CS Isolation resistance Test Condition VS = 500 V, R.H. 60% RS 5 x 10 BVS 10 14 1500 AC, 1 s, in oil 3000 DC, 1 min, in oil 3000 Vdc Min Typ. Max Unit 2.0 8.0 5.0 0.5 3.0 AC, 1 min Isolation voltage 10 Vrms Switching Characteristics (Ta = 25C) Characteristics Symbol Test Condition Turn-on time tON RL = 200 VDD = 10 V, IF = 2 mA (Note 2) Turn-on time tON RL = 200 VDD = 10 V, IF = 5 mA (Note 2) Turn-off time tOFF RL = 200 VDD = 10 V, IF = 2 mA (Note 2) ms Note 2: Switching time test circuit IF 1 4 RL VDD IF VOUT 2 VOUT 3 10% tON 3 90% tOFF 2009-05-15 TLP170J I F Ta I ON Ta (mA) ION 50 40 Allowable ON-sate current Allowable forward current IF (mA) 60 30 20 10 0 -40 -20 0 20 40 60 Ambient temperature 80 100 100 90 80 70 60 50 40 30 20 10 0 -40 Ta (C) -20 0 (mA) ION Allowable ON-sate current Forward current IF (mA) Ta = 25 1 0.9 1.0 1.1 1.2 Forward voltage VF 1.3 1.4 100 Ta (C) 40 20 0 -20 -40 -60 -80 -100 -4 -3 -2 -1 0 1 ON-sate voltage 2 VON 3 4 (V) I FT Ta (mA) 0.7 I FT 40 30 Trigger LED current () 100 60 RON Ta RON 80 Ta = 25 IF = 2mA 80 (V) 50 ON-sate resistance 60 I ON VON 10 0.1 0.8 40 Ambient temperature I F VF 100 20 20 ION = 90mA IF = 2mA t < 1s 10 0 -40 -20 0 20 40 Ambient temperature 60 80 100 ION = 90mA t < 1s 0.6 0.5 0.4 0.3 0.2 0.1 0 0.0 -40 Ta (C) -20 0 20 40 Ambient temperature 4 60 80 100 Ta (C) 2009-05-15 TLP170J tON,tOFF I F tON,tOFF Ta 10 (ms) tON,tOFF 0.1 tOFF tON Switching time tON,tOFF 1 Switching time (ms) 10 VDD = 10V RL = 200 Ta=25C 0.01 0.1 1 10 Forward current IF 100 (mA) VDD = 10V RL = 200 IF = 2 mA tON 1 tOFF 0.1 -40 -20 0 20 40 Ambient temperature 60 80 100 Ta (C) I OFF Ta 100 (nA) 1 OFF-state current I OFF VOFF = 600V 10 0.1 0.01 0.001 -40 -20 0 20 40 Ambient temperature 60 80 100 Ta (C) 5 2009-05-15 TLP170J RESTRICTIONS ON PRODUCT USE * Toshiba Corporation, and its subsidiaries and affiliates (collectively "TOSHIBA"), reserve the right to make changes to the information in this document, and related hardware, software and systems (collectively "Product") without notice. * This document and any information herein may not be reproduced without prior written permission from TOSHIBA. Even with TOSHIBA's written permission, reproduction is permissible only if reproduction is without alteration/omission. * Though TOSHIBA works continually to improve Product's quality and reliability, Product can malfunction or fail. Customers are responsible for complying with safety standards and for providing adequate designs and safeguards for their hardware, software and systems which minimize risk and avoid situations in which a malfunction or failure of Product could cause loss of human life, bodily injury or damage to property, including data loss or corruption. Before creating and producing designs and using, customers must also refer to and comply with (a) the latest versions of all relevant TOSHIBA information, including without limitation, this document, the specifications, the data sheets and application notes for Product and the precautions and conditions set forth in the "TOSHIBA Semiconductor Reliability Handbook" and (b) the instructions for the application that Product will be used with or for. Customers are solely responsible for all aspects of their own product design or applications, including but not limited to (a) determining the appropriateness of the use of this Product in such design or applications; (b) evaluating and determining the applicability of any information contained in this document, or in charts, diagrams, programs, algorithms, sample application circuits, or any other referenced documents; and (c) validating all operating parameters for such designs and applications. TOSHIBA ASSUMES NO LIABILITY FOR CUSTOMERS' PRODUCT DESIGN OR APPLICATIONS. * Product is intended for use in general electronics applications (e.g., computers, personal equipment, office equipment, measuring equipment, industrial robots and home electronics appliances) or for specific applications as expressly stated in this document. Product is neither intended nor warranted for use in equipment or systems that require extraordinarily high levels of quality and/or reliability and/or a malfunction or failure of which may cause loss of human life, bodily injury, serious property damage or serious public impact ("Unintended Use"). Unintended Use includes, without limitation, equipment used in nuclear facilities, equipment used in the aerospace industry, medical equipment, equipment used for automobiles, trains, ships and other transportation, traffic signaling equipment, equipment used to control combustions or explosions, safety devices, elevators and escalators, devices related to electric power, and equipment used in finance-related fields. Do not use Product for Unintended Use unless specifically permitted in this document. * Do not disassemble, analyze, reverse-engineer, alter, modify, translate or copy Product, whether in whole or in part. * Product shall not be used for or incorporated into any products or systems whose manufacture, use, or sale is prohibited under any applicable laws or regulations. * The information contained herein is presented only as guidance for Product use. No responsibility is assumed by TOSHIBA for any infringement of patents or any other intellectual property rights of third parties that may result from the use of Product. No license to any intellectual property right is granted by this document, whether express or implied, by estoppel or otherwise. * ABSENT A WRITTEN SIGNED AGREEMENT, EXCEPT AS PROVIDED IN THE RELEVANT TERMS AND CONDITIONS OF SALE FOR PRODUCT, AND TO THE MAXIMUM EXTENT ALLOWABLE BY LAW, TOSHIBA (1) ASSUMES NO LIABILITY WHATSOEVER, INCLUDING WITHOUT LIMITATION, INDIRECT, CONSEQUENTIAL, SPECIAL, OR INCIDENTAL DAMAGES OR LOSS, INCLUDING WITHOUT LIMITATION, LOSS OF PROFITS, LOSS OF OPPORTUNITIES, BUSINESS INTERRUPTION AND LOSS OF DATA, AND (2) DISCLAIMS ANY AND ALL EXPRESS OR IMPLIED WARRANTIES AND CONDITIONS RELATED TO SALE, USE OF PRODUCT, OR INFORMATION, INCLUDING WARRANTIES OR CONDITIONS OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE, ACCURACY OF INFORMATION, OR NONINFRINGEMENT. * GaAs (Gallium Arsenide) is used in Product. GaAs is harmful to humans if consumed or absorbed, whether in the form of dust or vapor. Handle with care and do not break, cut, crush, grind, dissolve chemically or otherwise expose GaAs in Product. * Do not use or otherwise make available Product or related software or technology for any military purposes, including without limitation, for the design, development, use, stockpiling or manufacturing of nuclear, chemical, or biological weapons or missile technology products (mass destruction weapons). Product and related software and technology may be controlled under the Japanese Foreign Exchange and Foreign Trade Law and the U.S. Export Administration Regulations. Export and re-export of Product or related software or technology are strictly prohibited except in compliance with all applicable export laws and regulations. * Please contact your TOSHIBA sales representative for details as to environmental matters such as the RoHS compatibility of Product. Please use Product in compliance with all applicable laws and regulations that regulate the inclusion or use of controlled substances, including without limitation, the EU RoHS Directive. TOSHIBA assumes no liability for damages or losses occurring as a result of noncompliance with applicable laws and regulations. 6 2009-05-15