869 MHz SAW Filter 12.5 MHz Bandwidth Part Number: SF0869BA02630S DESCRIPTION * * * 869 MHz SAW bandpass filter with a 12.5 MHz typical 3dB bandwidth. 3.8 x 3.8 mm ceramic SMP. RoHS compliant. TYPICAL PERFORMANCE IDT * SAW Products * 324 Clark Street, Worcester, MA 01606, USA * Ph 1-508-852-5400 * Fax 1-508-852-8456 www.idt.com DSSF0869BA02630S Rev- 20-April-2009 ECN 36378 Page 1 of 3 869 MHz SAW Filter 12.5 MHz Bandwidth Part Number: SF0869BA02630S SPECIFICATION Parameter Min Typ Max Units - 869 - MHz - 2.6 4.5 dB Amplitude Ripple (Fc+/-1 MHz) Absolute Attenuation (referenced to 0 dB) 0.4 1.5 dB p-p Attenuation (825 to 828 MHz) 40 47 - dB Attenuation (846 to 849 MHz) 35 40 - dB Attenuation (889 to 892 MHz) 30 36 - dB Attenuation (910 to 913 MHz) Source/Load Impedance Ambient Temperature 40 48 50 25 - dB ohms C Center Frequency, Fc 1 Insertion Loss (Fc+/-1 MHz) Notes: - - 1. Defined as the average of the lower and upper 3 dB frequencies. MAXIMUM RATINGS Parameter Storage Temperature Range Operating Temperature Range Input Power Level DC Voltage Min Max -30 -10 - 85 60 0 10 Units C C dBm V MATCHING CIRCUIT B E Input 50 Single-ended Output 50 Single-ended All other pads GND GND Notes: 1. External matching components are not required. IDT * SAW Products * 324 Clark Street, Worcester, MA 01606, USA * Ph 1-508-852-5400 * Fax 1-508-852-8456 www.idt.com DSSF0869BA02630S Rev- 20-April-2009 ECN 36378 Page 2 of 3 869 MHz SAW Filter 12.5 MHz Bandwidth Part Number: SF0869BA02630S PACKAGE OUTLINE Units: mm Tolerances are typically 0.15 mm except where indicated. Pad Configuration: Input: B Output: E To be grounded: all other pads MARKING SUGGESTED FOOTPRINT ISO 9001 Registered All specifications are believed to be accurate and reliable. However, MNC reserves the right to make changes without notice. (c) 2008 All rights reserved. IDT * SAW Products * 324 Clark Street, Worcester, MA 01606, USA * Ph 1-508-852-5400 * Fax 1-508-852-8456 www.idt.com DSSF0869BA02630S Rev- 20-April-2009 ECN 36378 Page 3 of 3