17 CHANNEL HIGH VOLTAGE AMPLIFIER CMA17 HTTP://WWW.APEXMICROTECH.COM M I C R O T E C H N O L O G Y ABSOLUTE MAXIMUM RATINGS (800) 546-APEX SUPPLY VOLTAGE, +Vhv SUPPLY VOLTAGE, VDD to VSS ESD SUSCEPTIBILITY2 TEMPERATURE, junction2 TEMPERATURE, storage (800) 546-2739 240V 13V 1500V 150C -55 to +125C NOTE: Because of wafer probe test limitations, full power tests are not possible. Refer to packaged product data sheet MA17 for typical AC, DC and power performance specifications. DC WAFER PROBED SPECIFICATIONS PARAMETER TEST CONDITIONS INPUT (Each Channel) OFFSET VOLTAGE, initial BIAS CURRENT, initial VOLTAGE RANGE OUTPUT VOLTAGE SWING MIN TYPICAL Full temperature range Vhv-Vo or -Vhv + Vo ,IO = 200A,Full temp range 5 4.5 LOW VOLTAGE AMPLIFIER (one/chip) OFFSET VOLTAGE, initial POWER SUPPLY4 VOLTAGE, Vhv VOLTAGE, VSS, VDD, total CURRENT, quiescent Vhv CURRENT, quiescent VSS, VDD NOTES: 1. 2. 3. 4. Full temperature range Full temperature range Full temperature range Full temperature range /-15 11.5 -50 12 MAX UNITS 5 100 6 mV pA V V 25 mV /-110 12.5 5.5 5 V V mA mA VSS must be -3.0V to -4.5V. VDD must be set to equal 12V VSS to VDD. Human-body model, 100pF discharge through a 1.5K ohm resistor. Unless otherwise noted, all test condtions are the nominal specifications. TC = 25C. The CMA17 requires three power supplies for unipolar, or four power supplies for bipolar operation. To prevent damage to the CMA17 or the load the power supply turn on sequence must be followed. VSS and VDD should be on and stabilized for 100s prior to turn on of Vhv. DIE OUTLINE 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 Vddh Vddh Vssh Vssh SUB Vss VddL SUB Vss VddL Vss IN1 FB1 IN2 FB2 IN3 FB3 IN4 FB4 IN5 FB5 IN6 FB6 IN7 FB7 IN8 FB8 Vss IN9 IN10 IN11 IN12 IN13 IN14 IN15 IN16 IN17 LVIN FB9 FB10 FB11 FB12 FB13 FB14 FB15 FB16 FB17 LVOUT Die dimensions are 392 x 189 mils x 15 mils thick. Wire bond pads are 5 x 5 mils. This data sheet has been carefully checked and is believed to be reliable, however, no responsibility is assumed for possible inaccuracies or omissions. All specifications are subject to change without notice. APEX MICROTECHNOLOGY CORPORATION * 5980 CMA17U NORTH REV. SHANNON ROAD * TUCSON, ARIZONA 85741 * USA * APPLICATIONS HOTLINE: 1 (800) 546-2739 B AUGUST 2002 (c) 2002 Apex Microtechnology Corp. 84