Customer Information sheet DRAWING No. > M20-876XXXXP SHEET 2 OF 29 IF IN DOUBT - | NOT TO SCALE THIRD ANGLE PROJECTION ALL DIMENSIONS IN mm re 2.54 x No. OF CONTACTS > 2.54 x (No. OF CONTACTS PER ROW +0. 35 PER ROW - |) 40.20 = 10.00+0.20> (SEE NOTE 1) < 2.5440.05 (11.30) U JIE 2.54+0.05 1p > | Lo 64 SQUARE TYP A esas SEE NOTE 3, TABLE NOTES: wn o Oo H o Ro o yr 7.2040. 30 OF CONTACTS 2.54 x (No. PER ROW - |) 40.20 tet ap tet L353 540.05 TYP 8.2040. 10 RECOMMENDED 4 PCB LAYOUT 2. 5440.05 TYP }oeoo --| = 1.00+0.05 TYP [/-=+ 6. 3040.20 ' 2740.20 SPECIFICATION: MATERIAL: MOULDING = PA6T UL94V-0, BLACK CONTACT = BRASS FINISH (OVER NICKEL): 42 = SELECTIVE GOLD ON CONTACT AREA, 100% TIN ON TAILS 46 = 100% TIN ELECTRICAL: CURRENT RATING = 3A MAX CONTACT RESISTANCE = 20mQ) MAX INSULATION RESISTANCE = 500MC) MIN DIELECTRIC STRENGTH = I000V AC VOLTAGE RATING = 250V AC/DC MECHANICAL : DURABILITY = 50 OPERATIONS (TIN), 300 OPERATIONS (GOLD) ENVIRONMENTAL : TEMPERATURE RANGE = -40C TO +#105C SOLDERING: REFLOW TEMP = 260C FOR 10 SECONDS MAX MANUAL TEMP = 330C FOR 3-5 SECONDS PACKING: TUBE FOR COMPLETE SPECIFICATION, SEE COMPONENT SPECIFICATION COOIXX (LATEST ISSUE) No. OF CONTACTS|COPLANARITY PER ROW TOLERANCE 02 TO l2 0. 10mm MAX 13 TO 20 0. 15mm MAX 23 0.20mm MAX WJP fF 10 701.08. 177 20398 NAMEFISS. DATE JC/NOTE ORDER CODE: M20-876XXXXP | perected: No. OF CONTACTS PER ROW: APPROVED: W. J. PRESTON S. BENNETT DRAWN: A. J. FILLINGHAM CUSTOMER REF.: |. FOR 4+4-WAYS AND LESS, CAP LENGTH = 6.00mm. 02 10 20, 23 2. SEE M20-876XXXXR FOR TAPE & REELED VERSION, M20-876XXXX FOR STANDARD PRODUCT. FINISH: 3. CO-PLANARITY: FLATNESS OF SMT TAILS WILL NOT EXCEED VALUES GIVEN IN TABLE. 42 = SELECTIVE GOLD + 100% TIN ASSEMBLY DRG: 4, ALL TOLERANCES ARE +0.15 UNLESS OTHERWISE STATED. 46 = 100% TIN a4 INFORMATION OF DESCRIPTIVE TOLERANCES MATERIAL: 2.54mm PITCH DIL SMT (IZA 23 \VAV/F IN] COWF EDENTIAL AND COPYRIGHT SEE ABOVE PIN HEADER ASSEMBLY GROUP AND MUST NOT BE WITH PICK & PLACE CAP : DISCLOSED, LOANED, COPIED . DRAWING NUMBER. aT www. harwin. com oR TENDERING OR FOR ANT ANGLES = 5" FINISH: SEE ABOVE M20-876XXXXP 3 technical@harwin. com THEIR WRITTEN PERMISSION. [| UNLESS STATED. | S/AREA: mm? OF,