SPEC NO: DSAD0948 REV NO: V.3 DATE: MAR/12/2005 PAGE: 1 OF 4
APPROVED: J. Lu CHECKED: Allen Liu DRAWN: Y.CHENG ERP: 1203001890
Package Dimensions
APT2012SYC SUPER BRIGHT YELLOW
Notes:
1. All dimensions are in millimeters (inches).
2. Tolerance is ±0.1(0.004") unless otherwise noted.
3. Specifications are subject to change without notice.
2.0x1.25mm SMD CHIP LED LAMP
Features
2.0mmx1.25mm SMT LED,0.75mm THICKNESS.
LOW POWER CONSUMPTION.
WIDE VIEWING ANGLE.
IDEAL FOR BACKLIGHT AND INDICATOR.
VARIOUS COLORS AND LENS TYPES AVAILABLE.
PACKAGE : 2000PCS / REEL.
RoHS COMPLIANT.
Description
The Super Bright Yellow device is made with DH InGaAlP
(on GaAs substrate) light emitting diode chip.
SPEC NO: DSAD0948 REV NO: V.3 DATE: MAR/12/2005 PAGE: 2 OF 4
APPROVED: J. Lu CHECKED: Allen Liu DRAWN: Y.CHENG ERP: 1203001890
Selection Guide
Note:
1. θ1/2 is the angle from optical centerline where the luminous intensity is 1/2 the optical centerline value.
Electrical / Optical Characteristics at TA=25°C
Absolute Maximum Ratings at TA=25°C
Note:
1. 1/10 Duty Cycle, 0.1ms Pulse Width.
Part No. Dice Lens Type Iv (mcd)
@ 20mA
Viewing
Angle
Min. Typ. 2 θ
θ θ
θ 1/2
APT2012SYC SUPER BRIGHT YELLOW (InGaAIP) WATER CLEAR 36 150 120°
Symbol Parameter Device Typ. Max. Test ConditionsUnits
λpeak Peak Wavelength Super Bright Yellow 590 nm IF=20mA
λDDominant Wavelength Super Bright Yellow 588 nm IF=20mA
∆λ1/2 Spectral Line Half-width Super Bright Yellow 28 nm IF=20mA
C Capacitance Super Bright Yellow 25 pF VF=0V;f=1MHz
VFForward Voltage Super Bright Yellow 2.0 2.5 V IF=20mA
IRReverse Current Super Bright Yellow 10 uA VR = 5V
Parameter Super Bright Yellow Units
Power dissipation 125 mW
DC Forward Current 30 mA
Peak Forward Current [1] 150 mA
Reverse Voltage 5 V
Operating/Storage Temperature -40°C To +85°C
SPEC NO: DSAD0948 REV NO: V.3 DATE: MAR/12/2005 PAGE: 3 OF 4
APPROVED: J. Lu CHECKED: Allen Liu DRAWN: Y.CHENG ERP: 1203001890
Super Bright Yellow APT2012SYC
SPEC NO: DSAD0948 REV NO: V.3 DATE: MAR/12/2005 PAGE: 4 OF 4
APPROVED: J. Lu CHECKED: Allen Liu DRAWN: Y.CHENG ERP: 1203001890
Recommended Soldering Pattern
(Units : mm)
Tape Specifications
(Units : mm)
APT2012SYC
Remarks:
If there is sorting requirement (eg. forward voltage, luminous intensity or wavelength), the condition as follows:
1.Wavelength: +/-1nm (Test condition is based on the sorting standard).
2.Luminous intensity: +/-15% (Test condition is based on the sorting standard).
3.Forward voltage: +/-0.1V (Test condition is based on the sorting standard).
