CY15FRAMKIT-002 SERIAL F-RAM DEVELOPMENT KIT QUICK START GUIDE Morpho Headers (J9, J10) Headers (J8) Excelon 4-Mbit F-RAM Arduino Headers (J1-J4) CY15FRAMKIT-002 Features: * Excelon 108MHz QSPI F-RAM * ST NUCLEO-433LC-P compatible Morpho headers (J9, J10) * Arduino UNO R3 compatible I/O Header (J1 - J4) * Headers J8 (1A-8A), J8 (1B-8B), J8 (1C-8C) to select Arduino or Morpho connector signal connectivity to F-RAM device * J5 header for 1.8-V/3.3-V F-RAM device VDD power supply selection * J6 header for 1.8-V/3.3-V selection for level shifters. Set this to the base board's power supply value CY15FRAMKIT-002 SERIAL F-RAM DEVELOPMENT KIT QUICK START GUIDE * This kit is designed to work with the ST NUCLEO-433LC-P board or an Arduino UNO R3 compatible board * Download the kit firmware from: www.cypress.com/CY15FRAMKIT-002 * Follow the Kit Operation Chapter 3 in CY15FRAMKIT-002 User guide for MCU configuration and programming * Ensure that Jumpers J5 and J6 on Kit are set for 3.3V operation * Ensure that Jumpers J8 (1B-8B) and J8 (1C -8C) are all shorted * Connect the MCU and F-RAM Kit as shown below to USB port CY15FRAMKIT-002 Kit with ST NUCLEO-433LC-P Board * Open a UART terminal, select the Nucleo board and press B2 (Reset button) on the Nucleo board * On Successful programing, a GUI menu will be displayed on the terminal as shown in Appendix B of User Guide Download the kit User Guide, driver, and hardware files from: www.cypress.com/CY15FRAMKIT-002 For technical support, visit www.cypress.com/support (c) 2019 Cypress Semiconductor Corporation. All rights reserved. All trademarks or registered trademarks referenced herein are the properties of their respective owners. Doc.# 002-27301 Rev.*A