80001202656 - 3M - Product.Network

Interconnect Solutions

http://www.3M.com/interconnects/

3M is a trademark of 3M Company.

For technical, sales or ordering information call

800-225-5373

3M™ MetPak™ CP2 Press-Fit Socket

2 mm Type B, 95, 110 and 125 Signal Contacts, Right Angle CP2 Series

Physical

Mechanical

Electrical

Environmental

PCB Data

CompactPCI is a registered trademark of PICMG-PCI Industrial Computer Manufacturers Group, Inc.

MetPak is a trademark of 3M Company.

Insulation Material: Glass Filled Polyester (PBT)

Insulation Flammability: UL 94 V-0

Contact Material: Copper Alloy

Plating

Underplate: 50 μ" [ 1.27 μm ] Nickel

Wiping Area: 30 μ″ [ 0.76 μm ] Gold

Termination Area: 100 μ" [ 2.54 μm ] Tin Lead

Mating Force: 0.75 N/contact maximum

Withdrawal Force: 0.15 N/contact minimum

Insulation Resistance: 10G Ω (Minimum)

Current Ratings: 1A at +70°C

Test Voltage: 750 VAC

Temperature Ratings: -55°C to +125°C

Recommended PCB hole platings: Cu: .0250 - .050 mm [.001 - .002 in.] and Sn or Sn/Pb: <10 µm [400 µ"]

PCB thickness: 1.4 - 5.6 mm [.06 - .22 in.]

Press-In Force: 26 ± 6N/pin on nominal hole diameter Ø 0.6 ± 0.05 mm [Ø .024 ± .002 in.]

Retention Force: 20 ± 5N/pin on nominal hole diameter Ø 0.6 ± 0.05 mm [Ø .024 ± .002 in.]

TS-2032-04

Sheet 1 of 2

Date Modified: April 11, 2007

• 25 mm basic system unit

• 38, 44 and 50 mm module

• CompactPCI® combines the benefits of PCI desktop

architecture with the ruggedness of the 3U and 6U IEEE

Eurocard form factor popularized by the VME bus

• Designed according to IEC 61076-4-101

and IEC 917 standards

• Meets CPCI application requirements

• “Eye of the Needle” compliant pin press-fit design

reduces manufacturing time and cost

• 2 mm grid spacing allows for high signal density

at low cost

• Additional grounding rows available for improved

ground bounce and EMI immunity

• See Regulatory Information Appendix (RIA)

for chemical compliance information

UL File No.: E68080

DISCONTINUED,

Superseded by TS-2268-A

Interconnect Solutions

http://www.3M.com/interconnects/

3M is a trademark of 3M Company.

For technical, sales or ordering information call

800-225-5373

20.20

.795

11.40

.449

8.80

.346

7.70

.303

DIM. "A" MAX.

11.40

.449

DIM. "B"

8.00

.315

2.00

.079

TYP.

2.00

.079 TYP.

1357911151719212325

.95

.037

TYP.

7.25

.285

2.00

.079 TYP.

2.00

.079 9.40

.370

3.50

.138

3M™ MetPak™ CP2 Press-Fit Socket

2 mm Type B, 95, 110 and 125 Signal Contacts, Right Angle CP2 Series

CP2-GS XXX - L

CP2 - SB XXX - X 1 - TG30

Number of Signal Contacts

095, 110 and 125

Shield Options:

G=Upper Shield

Blank = No Shield

Connector Type:

B19 (95 Signal Contacts)

B22 (110 Signal Contacts)

B25 (125 Signal Contacts)

Lower Shield (Order Separately)

Ordering Information

Signal Contact

Quantity Dimension A Dimension B

95 38.00 [1.496] 36.00 [1.417]

110 44.00 [1.732] 42.00 [1.653]

125 50.00 [1.968] 48.00 [1.890]

Wiping Area = Gold plating

Press-Fit Tails = Tin-Lead plating

(RIA E2 & C2 apply

Tin-Lead plated contacts

(RIA E2 & C2 apply)

TS-2032-04

Sheet 2 of 2

Recommended PCB hole mounting pattern

Connector side

lO0.10 MAB

357911

151719212325

DIM. "B"

10.00

.394

2.00

.079

TYP.

1.50

.059

O.60 ±.05

.024 ±.002

PLATED HOLES

2.00

.079 TYP.

.0 .00 .000

mm ±2.5 ±.25 ±.025

Tolerance Unless Noted

[inch]

[ ] Dimensions for Reference

Only

DISCONTINUED,

Superseded by TS-2268-A

Regulatory Information Appendix

3M Electronic Solutions Division/Interconnect

EUROPE

Appendix E1: European Union RoHS

Directive 2002/95/EC, Restriction of the Use of Certain Hazardous Substances in Electrical & Electronic Equipment, as

amended by EU Commission Decision 2005/618/EC.

This product is RoHS Compliant 2005/95/EC.

“RoHS Compliant 2005/95/EC” means that the product or part (“Product”) does not contain any of the substances in

excess of the maximum concentration values in EU Directive 2002/95/EC, as amended by Commission Decision 2005/618/

EC, unless the substance is in an application that is exempt under EU RoHS. Unless otherwise stated by 3M in writing, this

information represents 3M’s best knowledge and belief based upon information provided by third party suppliers to 3M.

In the event any product is proven not to conform with 3M’s Regulatory Information Appendix, then 3M’s entire liability

and Buyer’s exclusive remedy will be in accordance with the Warranty stated below.

Appendix E2: European Union RoHS

Directive 2002/95/EC, Restriction of the Use of Certain Hazardous Substances in Electrical & Electronic Equipment, as

amended by EU Commission Decision 2005/618/EC

This product contains lead in the compliant pin area in excess of the maximum concentration value allowed but is

compliant by exemption under EU Commission Decision 2005/747/EC.

“RoHS Compliant 2005/95/EC” means that the product or part (“Product”) does not contain any of the substances in

excess of the maximum concentration values in EU Directive 2002/95/EC, as amended by Commission Decision 2005/618/

EC, unless the substance is in an application that is exempt under EU RoHS. Unless otherwise stated by 3M in writing, this

information represents 3M’s best knowledge and belief based upon information provided by third party suppliers to 3M.

In the event any product is proven not to conform with 3M’s Regulatory Information Appendix, then 3M’s entire liability

and Buyer’s exclusive remedy will be in accordance with the Warranty stated below.

Appendix E3: European Union RoHS

Directive 2002/95/EC, Restriction of the Use of Certain Hazardous Substances in Electrical & Electronic Equipment as

amended by Commission Decision 2005/618/EC.

This product contains lead in the solder tail area in excess of the maximum concentration value allowed.

Unless otherwise stated by 3M in writing, this information represents 3M’s best knowledge and belief based upon

information provided by third party suppliers to 3M.

In the event any product is proven not to conform with 3M’s Regulatory Information Appendix, then 3M’s entire liability

and Buyer’s exclusive remedy will be in accordance with the Warranty stated below.

Appendix E4: European Union RoHS

Directive 2002/95/EC, Restriction of the Use of Certain Hazardous Substances in Electrical & Electronic Equipment, as

amended by EU Commission Decision 2005/618/EC.

This product contains decaBDE in the insulating material in excess of the maximum concentration value allowed but is

compliant by exemption under EU Commission Decision 2005/17/EC.

“RoHS Compliant 2005/95/EC” means that the product or part (“Product”) does not contain any of the substances in

excess of the maximum concentration values in EU Directive 2002/95/EC, as amended by Commission Decision

2005/618/EC, unless the substance is in an application that is exempt under EU RoHS. Unless otherwise stated by 3M in

writing, this information represents 3M’s best knowledge and belief based upon information provided by third party

suppliers to 3M.

In the event any product is proven not to conform with 3M’s Regulatory Information Appendix, then 3M’s entire liability

and Buyer’s exclusive remedy will be in accordance with the Warranty stated below.

RIA-2217-B

DISCONTINUED,

Superseded by TS-2268-A

CHINA

Appendix C1: China RoHS

Electronic Industry Standard of the People’s Republic of China, SJ/T11363-2006, Requirements for Concentration Limits

for Certain Hazardous Substances in Electronic Information Products.

This symbol, per Marking for the Control of Pollution Caused by Electronic Information Products, SJ/T11364-2006,

means that the product or part does not contain any of the following substances in excess of the following maximum

concentration values in any homogeneous material: (a) 0.1% (by weight) for lead, mercury, hexavalent chromium,

polybrominated biphenyls or polybrominated diphenyl ethers; or (b) 0.01% (by weight) for cadmium. Unless otherwise

stated by 3M in writing, this information represents 3M’s best knowledge and belief based upon information provided by

third party suppliers to 3M.

In the event any product is proven not to conform with 3M’s Regulatory Information Appendix, then 3M’s entire liability

and Buyer’s exclusive remedy will be in accordance with the Warranty stated below.

Appendix C2: China RoHS

Electronic Industry Standard of the People’s Republic of China, SJ/T11363-2006, Requirements for Concentration Limits

for Certain Hazardous Substances in Electronic Information Products.

This symbol, per Marking for the Control of Pollution Caused by Electronic Information Products, SJ/T11364-2006,

means that the product or part does contain a substance, as detailed in the chart below, in excess of the following

maximum concentration values in any homogeneous material: (a) 0.1% (by weight) for lead, mercury, hexavalent

chromium, polybrominated biphenyls or polybrominated diphenyl ethers; or (b) 0.01% (by weight) for cadmium. Unless

otherwise stated by 3M in writing, this information represents 3M’s best knowledge and belief based upon information

provided by third party suppliers to 3M.

The numerical reference in the symbol above should not be construed as a representation regarding the product’s life or an

extension of a product warranty. The product warranty is stated below. In the event any product is proven not to conform

with 3M’s Regulatory Information Appendix, then 3M’s entire liability and Buyer’s exclusive remedy will be in

accordance with the product Warranty stated below.

Important Notice

All statements, technical information, and recommendations related to 3M’s products are based on information believed to be reliable, but the

accuracy or completeness is not guaranteed. Before using this product, you must evaluate it and determine if it is suitable for your intended

application. You assume all risks and liability associated with such use. Any statements related to the product which are not contained in 3M’s

current publications, or any contrary statements contained on your purchase order shall have no force or effect unless expressly agreed upon, in

writing, by an authorized officer of 3M.

Warranty; Limited Remedy; Limited Liability.

This product will be free from defects in material and manufacture for a period of one (1) year from the time of purchase. 3M MAKES NO OTHER

WARRANTIES INCLUDING, BUT NOT LIMITED TO, ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS FOR A

PARTICULAR PURPOSE. If this product is defective within the warranty period stated above, your exclusive remedy shall be, at 3M’s option, to

replace or repair the 3M product or refund the purchase price of the 3M product. Except where prohibited by law, 3M will not be liable for any

indirect, special, incidental or consequential loss or damage arising from this 3M product, regardless of the legal theory asserted.

Electronic Solutions Division

6801 River Place Blvd.

Austin, TX 78726-9000

800/225-5373

www.3M.com/interconnects RIA-2217-B

Name and Content of Hazardous Substances or Elements

DISCONTINUED,

Superseded by TS-2268-A