zSFP+ Multi-Port Connector Tooling 2-by-12 zSFP+ Insertion Tool Application Tooling Specification Sheet Order No. 62202-5280 FEATURES Lightweight tool used in the insertion of a zSFP+ connector in a PCB Inserts connector to a PCB without damage to the board Use tool 62202-5290 for removing connectors PCB support not included (furnished by customer) SCOPE Products: zQuad Small Form-Factor Pluggable Plus (zSFP+) Cage Assembly, with Elastomeric Gasket or Metal EMI Gasket, 2-by-12 Enhanced EMI Cage Construction. Connector Series No. 170071 170071-1201 171224-1201 171224 171224-1215 171224-1260 172501 172501-1202 Connector Order No. 170071-1211 170071-1212 170071-1213 170071-1214 170071-1215 171224-1209 171224-1211 171224-1212 171224-1213 171224-1214 171224-1230 171224-1231 171224-1241 171224-1242 171224-1250 171224-1261 Notes: 1. See the following pages for tooling operation instructions. 2. These tools require a "Keep Out Zone" around the connector free of components. The right and left sides should be 0.08" (2mm). The rear of the connector should be .197" (5.0mm). See Figure 1. zSFP+ CAGE ASSEMBLY 5mm MINIMUM Figure 1 2mm MINIMUM (BOTH SIDES) Doc. No: ATS-622025280 Revision: C Release Date: 09-13-13 Revision Date: 06-05-17 PCB KEEP OUT ZONE UNCONTROLLED COPY Page 1 of 2 zSFP+ Multi-Port Connector Tooling Description The following Instructions are used for inserting the 2-by-12 connector into a PCB: INSERTION TOOL OVER CONNECTOR ASSEMBLY INSERTION TOOL (CLOSED END) zSFP+ CONNECTOR ASSEMBLY BOTTOM OF CONNECTOR TO SEAT FLUSH ON PCB Operation Figure 2 PCB 1. Place a connector assembly on the PCB. 2. Place the tool on the connector assembly (closed end to the back end of the connector). See Figure 2. 3. Place tool, connector and PCB in a press of suitable size and force, and seat the connector assembly as shown. The support plate (furnished by the customer) under the PCB must have clearance for the connector pins as they pass through the PCB. SIDE PLATE Clearance 1.0mm CLEARANCE BETWEEN BOARD AND THE SIDE PLATE AFTER zSFP+ ASSEMBLY IS SEATED ONTO THE PCB PCB Figure 3 Use this tool only with a press that has a predetermined shut height when seating a zSFP+ assembly on a PCB. See Figure 3. Allowing the press-in tool to stop on the board will result in damage to the zSFP+ cage and the terminals being overseated. CAUTION: Molex application tooling specifications are valid only when used with Molex connectors and tooling. Application Tooling Support Phone: (402) 458-TOOL (8665) E-Mail: applicationtooling@molex.com Website: www.molex.com/applicationtooling Molex is a registered trademark of Molex, LLC in the United States of America and may be registered in other countries; all other trademarks listed herein belong to their respective owners. Doc. No: ATS-622025280 Revision: C Release Date: 09-13-13 Revision Date: 06-05-17 UNCONTROLLED COPY Page 2 of 2