C8051F131 100 MIPS, 128 kB Flash, 10-Bit ADC, 64-Pin Mixed-Signal MCU Analog Peripherals High-Speed 8051 C Core - 10-Bit ADC - 1 LSB INL; no missing codes Programmable throughput up to 100 ksps 8 external inputs; programmable as single-ended or differential Programmable amplifier gain: 16, 8, 4, 2, 1, 0.5 Data-dependent windowed interrupt generator Built-in temperature sensor (3 C) - Memory - Two Comparators Internal Voltage Reference VDD Monitor/Brown-out Detector - - 8448 bytes data RAM 128 kB Flash; in-system programmable in 1024-byte sectors (1024 bytes are reserved) External parallel data memory interface Digital Peripherals On-Chip JTAG Debug & Boundary Scan - Pipelined instruction architecture; executes 70% of instructions in 1 or 2 system clocks Up to 100 MIPS throughput with 100 MHz system clock 16 x 16 multiply/accumulate engine (2-cycle) On-chip debug circuitry facilitates full speed, non-intrusive in-system debug (no emulator required) Provides breakpoints, single stepping, watchpoints, stack monitor Inspect/modify memory and registers Superior performance to emulation systems using ICE-chips, target pods, and sockets IEEE1149.1 compliant boundary scan - 32 port I/O; all are 5 V tolerant Hardware SMBusTM (I2CTM Compatible), SPITM, and two UART serial ports available concurrently Programmable 16-bit counter/timer array with six capture/compare modules 5 general-purpose 16-bit counter/timers Dedicated watchdog timer; bidirectional reset Real-time clock mode using Timer 3 or PCA Clock Sources - Internal oscillator: 24.5 MHz, 2% accuracy supports UART operation On-chip programmable PLL: up to 100 MHz External oscillator: Crystal, RC, C, or Clock Supply Voltage: 3.0 to 3.6 V - Typical operating current: 50 mA at 100 MHz Typical stop mode current: 0.4 A 64-Pin TQFP Temperature Range: -40 to +85 C VDD VDD VDD DGND DGND DGND AV+ AGND Port I/O Config. Digital Power UART0 SFR Bus Analog Power TCK TMS TDI TDO Boundary Scan JTAG Logic Debug HW Reset RST MONEN XTAL1 XTAL2 VDD Monitor WDT External Oscillator Circuit PLL Circuitry System Clock Calibrated Internal Oscillator VREF VREF CP0+ CP0CP1+ CP1- C o r e A M U X Prog Gain TEMP SENSOR ADC 100ksps (10-Bit) C R O S S B A R SMBus 256 byte RAM 8kbyte XRAM External Data Memory Bus SPI Bus PCA Timers 0, 1, 2, 4 Timer 3/ RTC P0, P1, P2, P3 Latches P0 Drv P0.0 P1 Drv P1.0/AIN2.0 P2 Drv P2.0 P3 Drv P3.0 P0.7 P1.7/AIN2.7 P2.7 P3.7 Crossbar Config. FLASH 128kbyte Bus Control 64x4 byte cache VREF0 AIN0.0 AIN0.1 AIN0.2 AIN0.3 AIN0.4 AIN0.5 AIN0.6 AIN0.7 8 0 5 1 UART1 Address Bus Data Bus CP0 C T L A d d r D a t a P4 Latch P4 DRV P5 Latch P5 DRV P6 Latch P6 DRV P7 Latch P7 DRV CP1 General Purpose Copyright (c) 2004 by Silicon Laboratories 8.9.2004 C8051F131 100 MIPS, 128 kB Flash, 10-Bit ADC, 64-Pin Mixed-Signal MCU Selected Electrical Specifications (TA = -40 to +85 C, VDD = 3.0 V unless otherwise specified) PARAMETER CONDITIONS GLOBAL CHARACTERISTICS Supply Voltage Supply Current Clock = 100 MHz (CPU active) Clock = 1 MHz Clock = 32 kHz Supply Current Oscillator off; VDD Monitor Enabled (shutdown) Oscillator off; VDD Monitor Disabled Clock Frequency Range INTERNAL CLOCKS Oscillator Frequency PLL Frequency A/D CONVERTER Resolution Integral Nonlinearity Differential Nonlinearity Guaranteed Monotonic Signal-to-Noise Plus Distortion Throughput Rate MIN TYP MAX UNITS 3.0 -- -- -- -- -- DC -- 50 0.6 16 10 0.4 -- 3.6 -- -- -- -- -- 100 V mA mA A A A MHz 24.0 -- 24.5 -- 25.0 100 MHz MHz -- -- 59 10 -- -- -- 1 1 -- bits LSB LSB dB -- -- 100 ksps C8051F120DK Development Kit Package Information D D1 MIN NOM MAX (mm) (mm) (mm) A E1 E - 1.20 A1 0.05 - 0.15 A2 0.95 - 1.05 b 64 PIN 1 DESIGNATOR 1 A2 e A b General Purpose - 0.17 0.22 0.27 D - 12.00 - D1 - 10.00 - e - 0.50 - E - 12.00 - E1 - 10.00 - A1 Copyright (c) 2004 by Silicon Laboratories Silicon Laboratories and Silicon Labs are trademarks of Silicon Laboratories Inc. Other products or brandnames mentioned herein are trademarks or registered trademarks of their respective holders 8.9.2004