Material Safety Data Sheet for AMP Part Nos. 275442-1, 275446-1, and 275447-1 125-6326 18 MAY 99 Rev D AMP Emergency HOTLINE: 1-717-561-8800 KRREE MATERIAL SAFPFETY DATA SHEET KKKKE Latest Revision Date...62/10/93 Print Date.........--.-- 2.902/10/93 EMERGENCY PHONE NUMBER: SECTION 1 PRODUCT NAME... eee eee reece en taee MANUFACTURER'S NAME...+..--- COMPANY ADDRESS.....+-+5. nae COMPANY PHONE NUMBER......-- eee HMIS RATING....... teas BUTYL RUBBER SEALER * 800 424-9300 PRODUCT IDENTIFICATION S903E AMP DIELECTRIC TAPE KOCH PROTECTIVE TREATMENTS, INC. 3345 STOP EIGHT ROAD DAYTON, OHTO 45413 (513) -890-3150 HEALTH HAZARD - 1 FLAMMABILITY - 1 REACTIVITY - 2 PERSONAL PROTECTION - B W. KAUPFTMANN SECTION 2 HAZARDOUS INGREDIENTS/HAZARD DATA CHEMICAL RAMECS) CAS NUMBER X WI TLY PEL SEC,313 REL CARCINOGEN *SILICA-CRYSTALLIHE QUARTZ 14808-60-7 <5 6.1 4G/M3 Q.1 MG/M3 Wo HA YES *SUBSTAHCE WORK'T SE RELEASED UNDER NORMAL USE Wo SECTION 3 PHYSICAL DATA BOTLING/MELTING POINT @760 mm Hg ND DH eee ccc eee ee teen tent ences .. ND VAPOR PRESSURE mn Hg @20 Cosas ND VAPOR DENSITY (Air = 1)......... ND SPECIFIC GRAVITY......---- tesaee 1.94 +- 0.03 SOLUBILITY IN WATER.......++-+--. NEGLIGIBLE EVAPORATION RATE (BuAc = 1)..... ND APPEARANCE s sete ceeeceeceeeececes BLACK COLOR ODOR. ce ecenececcceeeres weeeeeees MILD VOC CONTENT (LB/GAL)..... teeeee ND SECTION 4 FIRE AND EXPLOSION HAZARD DATA FLASH POINT F (Test Method).... AUTOIGNITION TEMPERATURE... ee05+ FLAMMABILITY LIMITS IN AIR (% V) EXTINGUISING MEDIA......... aeees SPECIAL FIRE FIGHTING PROCEDURES > 200 DEG F ND ND FOAM, CARBON DIOXIDE, DRY CHEMICAL, WATER SPRAY. FULL EMERGENCY EQUIPMENT WITH SELF- CONTAINED BREATHING APPARATUS AND FULL PROTECTIVE CLOTHING SHOULD BE WORN BY FIRE FIGHTERS. MOVE UNDAMAGED CONTAINERS FROM SPILL AREA IF IT CAN BE DONE WITHOUT RISK. AMP Incorporated, Harrisburg, PA17105 Copyright 1999 by AMP Incorporated. All Rights Reserved. Tof4 The technical content of this document has been reproduced from the Material Safety Data Sheet furnished by the manufacturer. AMP Incorporated is not responsible for the technical content of this document. LOCBANP Material Safety Data Sheet 125-6326 keeeEK MATERIAL BAFET Y DATA SHEET REEKE Latest Revision Date...02/10/93 BUTYL RUBBER SEALER Print Date........6...-02/10/93 EMERGENCY PHONE NUMBER: * 800 424-9300 SECTION 4 FIRE AND EXPLOSION HAZARD DATA CONT'D UNUSUAL FIRE & EXPLOSION HAZARDS SILICA-CRYSTALLINE MAY BE RELEASED DURING COMBUSTION. SECTION 5 HEALTH HAZARD DATA * EFFECTS OF OVEREXPOSURE INHALATION.....- NEGLIGIBLE HAZARD AT AMBIENT TEMPERATURE. HOWEVER, IF THE PRODUCT IS HEATED, IT MAY CAUSE IRRITATION TO THE UPPER RESPIRATORY TRACT. EYE CONTACT....MAY PRODUCE MILD IRRITATION. SKIN CONTACT...MAY PRODUCE MILD IRRITATION. REPEATED CONTACT WITH THE SKIN MAY CAUSE DERMATITIS IN SENSITIVE INDIVIDUALS. INGESTION......+MINIMAL TOXICITY. SECTION 6 EMERGENCY AND FIRST AID PROCEDURES INHALATION....IF RESPIRATORY SYMPTOMS DEVELOP, MOVE VICTIM AWAY FROM SOURCE OF EXPOSURE AND INTO FRESH AIR. IF SMPTOMS PERSIST, SEEK MEDICAL ATTENTION. IF VICTIM IS NOT BREATHING, IMMEDIATELY BEGIN ARTIFICIAL RESPIRATION. IF BREATHING DIFFICULTIES DEVELOP, OXYGEN SHOULD BE ADMINISTERED BY QUALIFIED PERSONNEL. KEEP PERSON WARM, QUIET, AND SEEK IMMEDIATE MEDICAL ATTENTION. EYES........,.IF IRRITATION OR REDNESS DEVELOPS, MOVE VICTIM AWAY FROM EXPOSURE AREA AND INTO FRESH AIR. FLUSH EYES WITH CLEAN WATER, LIFTING UPPER AND LOWER LIDS OCCASSIONALLY FOR AT LEAST 15 MINUTES. IF SYMPTOMS PERSIST, SEEK MEDICAL ATTENTION. SKIN.........+REMOVE CONTAMINATED CLOTHING AND CLEANSE AFFECTED AREA(S) THOROUGHLY WITH COPIOUS AMOUNTS OF WATER FOR AT LEAST 15 MINUTES. IF IRRITATION OR REDNESS DEVELOPS AND PERSISTS, SEEK MEDICAL ATTENTION. INGESTION.....- DO NOT INDUCE VOMITING. SEEK MEDICAL ATTENTION IMMEDIATELY. SECTION 7 REACTIVITY DATA PRODUCT STABILITY....-- seen wees STABLE CONDITIONS TO AVOLTD.. cae eee een eee AVOID ALL POSSIBLE SOURCES OF IGNITION AND EXCESSIVE HEAT. 2of4 The technical content of this document has been reproduced from the Material Safety Data Sheet furnished by Rev D the manufacturer. AMP Incorporated is not responsible for the technical content of this document.ANP Material Safety Data Sheet 125-6326 eeeke MATERIAL SAFETY DATA SHEET eK Latest Revision Date...02/10/93 BUTYL RUBBER SEALER Print Date.........-.. 02/10/93 EMERGENCY PHONE NUMBER: * 800 424-9300 SECTION 7 REACTIVITY DATA CONT'D CHEMICAL INCOMPATIBILITY...-...+.+...AVOID STRONG ACIDS, OXIDIZING AGENTS, AND EXCESSIVE HEAT. HAZARDOUS DECOMPOSITION PRODUCTS.....THERMAL DECOMPOSITION MAY PRODUCE CARBON DIOXIDE, CARBON MONOXIDE, AND OTHER TOXIC DECOMPOSITION PRODUCTS. HAZARDOUS POLYMERIZATION.......- oeeee WELL NOT OCCUR SECTION & SPECIAL PROTECTION INFORMATION VENTIDATION. 22 eee n eee aeee PROVIDE SUFFICIENT MECHANICAL (GENERAL AND/OR LOCAL EXHAUST) VENTILATION TO MAINTAIN EXPOSURE BELOW OSHA PEL(S} AND ACGIH TLV(S}) LIMITS. RESPIRATORY PROTECTION..-IF WORKPLACE EXPOSURE LIMIT(S) OF PRODUCT OR ANY COMPONENT IS EXCEEDED (SEE SECTION 2), A NIOSH/MSHA RESPIRATOR IS ADVISED IN ABSENCE OF PROPER ENVIRONMENTAL CONTROL. ENGINEERING OR ADMINISTRATIVE CONTROLS SHOULD BE IMPLEMENTED TO REDUCE EXPOSURE. PROTECTIVE GLOVES,........ THE USE OF GLOVES TMPERMEABLE TO THE SPECIFIC MATERIAL HANDLED IS ADVISED TO PREVENT SKIN CONTACT AND POSSIBLE IRRITATION. EYE PROTECTION. ..-+-++0e8- APPROVED EYE PROTECTION IN COMPLIANCE WITH OSHA REGULATIONS IS ADVISED TO SAFEGUARD AGAINST POTENTIAL EYE CONTACT, IRRITATION OR INJURY. OTHER PROTECTIVE EQUIPMENT....-EMERGENCY EYE WASH STATIONS AND SAFETY SHOWERS SHOULD BE AVAILABLE IN THE WORK AREA. IMPERVIOUS CLOTHING SHOULD BE WORN AS NEEDED. SECTION 9 SPECIAL PRECAUTIONS AND SPILL/LEAK PROCEDURES PRECAUTIONS TO BE TAKEN IN HANDLING AND STORAGE..STORE IN A WELL VENTILATED AREA AWAY FROM STRONG OXIDIZING AGENTS AND SOURCES OF HEAT OR IGNITION. FOLLOW GOOD HYGIENIC PRACTICES TO AVOID POTENTIAL CHRONIC EFFECTS. CONTAMINATED CLOTHING SHOULD BE REMOVED AND LAUNDERED BEFORE REUSE. AVOID REPEATED OR PROLONGED CONTACT WITH THE MATERIAL. IF MATERIAL IS HEATED, AVOID INHALATION OF VAPORS. DO NOT EAT OR SMOKE IN AREAS WHERE THIS MATERIAL IS USED CR STORED. Rev D The technical content of this document has been reproduced from the Material Safety Data Sheet furnished by 3 of 4 the manufacturer. AMP Incorporated is not responsible for the technical content of this document.ANP Material Safety Data Sheet 125-6326 ekeeke MATERIAL SAFETY DATA SHEET ReKEK Latest Revision Date...02/10/93 BUTYL RUBBER SEALER Print Date.....e.eeeee G2/10/93 EMERGENCY PHONE NUMBER: * 800 424-9300 SECTION 9 SPECIAL PRECAUTIONS AND SPILL/LEAK PROCEDURES CONTTD STEPS TO BE TAKEN IN CASE MATERIAL IS RELEASED OR SPILLED...... WHEN MATERIAL IS IN CONTACT WITH HOT OBJECTS, AVOID BREATHING FUMES. REMOVE IGNITION SOURCES. COVER WITH AN EXCESS OF AN INORGANIC ABSORBENT MATERIAL (VERMICULITE). SWEEP UP AND PLACE IN LABELED DRUM. PREVENT RUN-OFF TO SEWERS, STREAMS, OR OTHER BODIES OF WATER. IF RUN-OFF OCCURS, NOTIFY PROPER AUTHORITIES AS REQUIRED THAT A SPILL HAS OCCURRED. WASTE DISPOSAL METHOD....DISPOSE OF IN ACCORDANCE WITH LOCAL, STATE AND FEDERAL REGULATIONS. SECTION 10 ABBREVIATION SYMBOLS ND - NOT DETERMINED NE - NOT ESTABLISHED NA - NOT AVAILABLE PROP - PROPRIETARY TO THE RAW MATERIAL VENDOR SECTION 11 SUPPLIER INFORMATION THE INFORMATION CONTAINED IN THIS MATERIAL SAFETY DATA SHEET HAS BEEN PREPARED IN ACCORDANCE WITH THE OSHA HAZARD COMMUNICATION STANDARD, CFR1910.1200. THIS INFORMATION RELATES SPECIFICALLY TO THE PRODUCT DESIGNATED AND MAY NOT BE VALID FOR THE PRODUCT WHEN USED IN COMBINATION WITH ANY OTHER MATERIALS OR PRODUCTS OR IN A PARTICULAR PROCESS. THE INFORMATION IS TO THE BEST OF OUR KNOWLEDGE AND BELIEF, ACCURATE AND RELIABLE AS OF THE DATE COMPILED. HOWEVER, NO REPRESENTATION, WARRANTY OR GUARANTEE IS MADE AS TO ITS ACCURACY, RELIABILITY OR COMPLETENESS. THE USER SHOULD REVIEW THIS INFORMATION, SATISFY ONESELF AS TO ITS SUITABILITY AND COMPLETENESS, AND PASS ON THE INFORMATION TO ITS EMPLOYEES OR CUSTOMERS IN ACCORDANCE WITH APPLICABLE FEDERAL, STATE OR LOCAL HAZARD COMMUNICATIONS REQUIREMENTS. WE DG NOT ACCEPT RESPONSIBILITY FOR ANY LOSS OR DAMAGE WHICH MAY OCCUR FROM THE USE OF THIS INFORMATION. REVISION SUMMARY FOR MSDS 125-6326 Date Prepared: 18 May 1999 Last Revised: 01 November 1994 Previous Revision: 04 October 1994 Summary of Revisions: Revised MSDS per EC 0990-0580-99 4of 4 The technical content of this document has been reproduced from the Material Safety Data Sheet furnished by Rev D the manufacturer. AMP Incorporated is not responsible for the technical content of this document.