17 17 www.stego.de | www.stego.co.uk | www.stegonorden.se HEATING STEGO - PRODUCT CATALOGUE TECHNICAL DATASHEET TOUCH-SAFE SMALL HEATER (SEMICONDUCTOR) CSK 060 | 10 W, 20 W >>Low surface temperature >>Double insulated (plastic housing) >>Wide voltage range >>Dynamic heating up >>Clip fixing TECHNICAL DATA Operating voltage AC/DC 120 -240 V (min. 110 V, max. 265 V) Heating element PTC resistor - temperature limiting Surface temperature < +85 C (+185 F) (according to VDE 0100), except upper protective grille Connection 2-pole terminal 2.5 mm, torque 0.8 Nm max. Casing plastic according to UL94 V-0, black Dimensions 98 x 38 x 75 mm Mounting clip for 35mm DIN rail, EN 60715 Fitting position vertical airflow (air outlet up, connection on bottom) Operating/Storage temperature -45 C to +70 C (-49 F to +158 F) Operating/Storage humidity max. 90 % RH (non-condensing) Protection type/Protection class IP20 / II (double insulated) Approvals VDE, UL File No. E150057, EAC Note other voltages on request Operating with voltages below AC/DC 140 V reduces heating performance by approx 10 %. Example of connection Heater CSK 060 Thermostat FTO 011 (NC) L N Art. No. Heating capacity Inrush current max. Recommended pre-fuse T (time-delay) 06040.0-00 10 W 1.0 A 2.0 A 0.2 kg 06030.0-00 20 W 2.5 A 4.0 A 0.3 kg at +20 C (+68 F) ambient temperature Weight (approx.) 19.03.2019 | Specifications are subject to change without notice. Errors and omissions excepted. Suitability of this product for its intended use and any associated risks must be determined by the end customer/buyer in its final application. The heaters are used in enclosures where condensation is to be prevented or the temperature may not fall below a minimum value. In this way corrosion is avoided and an even temperature is ensured. The heaters are designed for permanent operation.