CHEMTRONICS TDS # 0167 Technical Data Sheet Static Free Floor Finish PRODUCT DESCRIPTION Static Free Floor Finish is a high gloss floor finish designed to dissipate electrostatic charges and prevent static generation, while providing protection and enhanced appearance to a floor surface. It can be applied to any hard floor surface, such as vinyl, vinyl asbestos, rubber, linoleum and other surfaces. Static Free Floor Finish eliminates the need for static control tiles or antistatic floor mats. Static FreeTM Floor Finish dries in 30 minutes and is perfect for cleanroom, electronic manufacturing, assembly and test areas. Provides a non-yellow high gloss floor surface Dissipates static build up on floor surfaces Eliminates need for static control tiles Dries in 30 minutes Enhances the appearance of hard surfaces Meets slip resistance standard ASTM D21.06 TYPICAL APPLICATIONS Static Free Floor Finish effectively dissipates static electrical charges on floor surfaces: Vinyl Composition Vinyl Asbestos Rubber Linoleum TYPICAL PRODUCT DATA AND PHYSICAL PROPERTIES Appearance Specific Gravity (water = 1) Appearance White, Opaque Liquid 1.02 White, Opaque Liquid Viscosity 18 cps @ RT (Brookfield DVII, No.1 spindle @ 100RPM) None Flash Point (TCC) 106 - 109 ohms Surface Resistivity (ANSI/ESD S7.1) Static Decay PASS (MIL-B-81705C) (Less than 1 Second) Coverage 1500 - 2000 sq ft. per gallon Shelf life 2 years RoHS/WEEE Status COMPATIBILITY Static Free Floor Finish is generally compatible with most materials used in commercial/industrial applications. As with any chemical product, component compatibility must be determined on a noncritical area prior to use. NOTE: USAGE INSTRUCTIONS Make sure floor is stripped of previous floor finish, and has been rinsed and cleaned. Pour the Static FreeTM Floor Finish into a clean bucket. Immerse a rayon or other mop designed for floor finish application into the finish. Ring mop slightly, place on the floor and apply in a figure eight motion. Repeat until entire area has been coating. Allow Static Floor Finish at least 30 minute drying before adding additional coats. AVAILABILITY ES167 ES567 1 gallon container 5 gallon container ENVIRONMENTAL IMPACT DATA ENVIRONMENTAL IMPACT DATA 0.0% 0.0% 0.0% VOC HFC ODP Chemtronics(R) is registered trademarks of Chemtronics. All rights reserved. Static FreeTM is a trademark of Chemtronics. All rights reserved. All other trademarks herein are trademarks or registered trademarks of their respective owners. CHEMTRONICS 8125 COBB CENTER DRIVE KENNESAW, GA 30152 1-770-424-4888 REV. C DISTRIBUTED BY: TECHNICAL & APPLICATION ASSISTANCE Chemtronics provides a technical hotline to answer your technical and application related questions. The toll free number is: 1800-TECH-401. CFC HCFC CL Solv. This information is believed to be accurate. It is intended for professional end users having the skills to evaluate and use the data properly. CHEMTRONICS does not guarantee the accuracy of the data and assumes no liability in connection with damages incurred while using it. 9.0% 0.0% 0.0 CFC, HCFC, CL. SOLV., VOC, and HFC numbers shown are the content by weight. Ozone depletion potential (ODP) is determined in accordance with the Montreal Protocol and U.S. Clean Air Act of 1990. The ODP of this product is 0.0. It is the sum of the ODP of the substances that may contribute to the depletion of stratospheric ozone, based upon the weight of each substance in the product's formulation. (08/13)