Contact Us Search MySupermicro
Products Systems 2U [ 2026TT-H6IBQRF ]
4 Integrated Boards
Super X8DTT-
HIBQF+
Key Features
Four hot-pluggable systems (nodes) in
a 2U form factor. Each node supports
the following:
1. Intel® Xeon® processor 5600/5500
series, with QPI up to 6.4 GT/s
2. Up to 192GB DDR3 1333/ 1066/
800MHz ECC Registered DIMM /
48GB Unbuffered DIMM
3. 1 (x16) PCI-E 2.0 (Low Profile)
4. Integrated IPMI 2.0 with KVM and
Dedicated LAN
5. Dual Intel® 82574L Gigabit
Ethernet Controller
6. 6x 2.5" Hot-swap SAS Drive Bays
7. 1400W Gold-level High-efficiency
Redundant Power Supply
8. Mellanox ConnectX QDR Infiniband
40Gbps Controller w/ QSFP connector
Available Colors: Black
Drivers & Utilities BIOS IPMI Tested Memory Manuals Drive
Options
Product SKUs
SYS-2026TT-
H6IBQRF SuperServer 2026TT-H6IBQRF (Black)
Motherboard
4x Super X8DTT-HIBQF+
Processor/Cache
CPU
Dual 1366-pin LGA Sockets
Supports up to two Intel® 64-bit Xeon®
processor(s) of the same type below:
Intel® Xeon® Processor
X5600/E5600/L5600 Series
(Westmere) 40W - 95W
Intel® Xeon® Processor
X5500/E5500/L5500 Series
(Nehalem-EP) 38W - 95W
QPI up to 6.4 GT/s
System Memory
Memory
Capacity
12x 240-pin DIMM slots
Supports up to 192 GB** 1333 / 1066 /
800MHz DDR3 ECC Registered memory
Supports up to 48 GB 1333 / 1066 /
800MHz DDR3 ECC / Non ECC Unbuffered
memory
Memory Mirroring supported
Memory
Type
1333 / 1066 / 800MHz ECC Registered /
ECC or Non ECC Unbuffered DDR3 SDRAM
72-bit, 240-pin gold-plated DIMMs
DIMM Sizes 1GB, 2GB, 4GB , 8GB** , 16GB**
Memory
Voltage 1.5 V / 1.35 V
Error
Detection
Corrects single-bit errors
Detects double-bit errors (using ECC
memory)
Supports Intel® x4 and x8 Single Device
Data Correction (SDDC)
On-Board Devices (per Node)
Infiniband Mellanox ConnectX QDR Infiniband 40Gbps
Controller
Chipset Intel® 5520 (Tylersburg) chipset
ICH10R + IOH-36D
SATA Intel ICH10R SATA 3.0Gbps Controller
RAID 0, 1, 5, 10 support
SAS
Broadcom 6Gbps SAS 2108 w/ Hardware
RAID support via BPN-ADP-SAS2-H6iR
RAID 0, 1, 10, 5, 50, and 6 support
IPMI
Support for Intelligent Platform Management
Interface v.2.0
IPMI 2.0 with virtual media over LAN and
KVM-over-LAN support
Nuvoton WPCM450 BMC
Chassis
Form Factor 2U Rackmount
Model CSE-217HQ-R1400B
Dimensions
Height 3.47" (88mm)
Width 17.25" (438mm)
Depth 26.75" (679mm)
Gross
Weight 85 lbs (38.6kg)
Available
Colors Black
Front Panel (per Node)
Buttons Power On/Off button
UID button
LEDs
Power LED (on power button)
Network activity LED
System Overheat/fan fail/power fail/ LED
UID LED (on UID button)
Expansion Slots (per Node)
PCI-Express 1 (x16) PCI-E 2.0 (Low Profile)
Drive Bays (per Node)
Hot-swap 6x 2.5" hot-swap drive bays
Hard drive Backplane
2U Hard drive Backplane
System Cooling
Fans 4x Cooling Fans
Power Supply
1400W high-efficiency (1+1) redundant power supply with PMBus
AC Input
1100W Output @ 100-140V, 13.5-9.5A, 50-
60Hz
1400W Output @ 180-240V, 9.5-7.0A, 50-
60Hz
DC Output 1100W: +12V/92A; +5Vsb/4A
1400W: +12V/116A; +5Vsb/4A
With
Distributor
+5V: 30 Amp
+3.3V: 24 Amp
-12V: 0.6 Amp
Certification
Gold Certified
[ Test Report ]
PC Health Monitoring
CPU
Monitors for CPU Cores,+1.5V, +3.3V, +5V,
+12V, +5 Stdby, +3.3 Stdby, VBAT, Memory
Voltages.
CPU Core 6-Phase-switching voltage
regulator
SuperServer 2026TT-H6IBQRF
Network
Controllers
Dual Intel® 82574L Gigabit Ethernet
Controller
Supports 10BASE-T, 100BASE-TX, and
1000BASE-T, RJ45 output
1x Realtek RTL8201N PHY (dedicated IPMI)
Graphics Matrox G200eW
Super I/O Winbond W83527HG chip
Clock
Generator 932S421 chip
Input / Output (per Node)
Serial ATA Six Serial ATA ports
6 SATA hard drives supported
LAN 2x RJ45 LAN ports
1x RJ45 Dedicated IPMI LAN port
USB
2 rear + 1 header (2 Ports)
4 total USB ports, 2.0 Compliant / 1.1
Compliant
VGA 1x VGA Port
Serial Port 1 Fast UART 16550 serial port
Infiniband 1 External QSFP Infiniband Connector
System BIOS (per Node)
BIOS Type 32Mb SPI Flash EEPROM with AMI® BIOS
BIOS
Features
Plug and Play (PnP)
PCI 2.2
ACPI up to 3.0
USB Keyboard support
FAN
Total of four 4-pin PWM fans
4x fans with tachometer monitoring
Status monitor for speed control
Status monitor for on/off control
Low noise fan speed control
Temperature
Monitoring for CPU and chassis
environment
CPU thermal trip support
Thermal Control for 4x Fan Connectors
PSU I2C temperature sensing logic
Thermal Monitor 2 (TM2) support
PECI
LED
Power Fail / Overheat LED
Suspend-state Indicator LED
UID LED
Other
Features SDDC Support
Operating Environment / Compliance
RoHS RoHS Compliant
Environmental
Spec.
Operating Temperature: 10°to 35°C (50°to
95°F)
Non-operating Temperature: -40°to 70°C
(-40°to 158°F)
Operating Relative Humidity: 8% to 90%
(non-condensing)
Non-operating Relative Humidity: 5 to 95%
(non-condensing)
Parts List - (Items Included)
Part Number Qty Description
Motherboard / Chassis MBD-X8DTT-HIBQF+
CSE-217HQ-R1400B
4
1
Super X8DTT-HIBQF+ Motherboard
2U Black Chassis
Air Shroud MCP-310-82710-0B 42U Air Shroud
Backplane BPN-ADP-SAS2-H6IR 4[NR] BPN-ADP-SAS2-H6iR 6 X SAS2 LSI 2108
Backplane BPN-SAS-217HQ 124-port 2U Twin^2 CSE-217HQ (6 drives per node) backplane,
support up to 24x 2.5-inch SAS/SATA HDD
CD CDR-X8 1For X8 series
Riser Card RSC-R1U-E16R 4RSC-R1U-E16R
Heatsink / Retention SNK-P0037P 81U PASSIVE CPU HS FOR INTEL LGA1366 (HTP)
Drive Tray(s) MCP-220-00047-0B 24 Black gen 3 hot swap 2.5" HDD tray
** Please check 'Tested Memory List' for compatibility
Terms & Conditions | Privacy | Investor Relations | Jobs | Site Map
SuperServer® | Motherboard | Chassis | Rack Cabinet | SuperBlade® | Embedded | Networking | Storage | Accessories | AMD Solution | Power Supplies
Copyright © 2017 Super Micro Computer, Inc.
Information in this document is subject to change without notice.
Other products and companies referred to herein are trademarks or registered trademarks of their respective companies or mark holders.
