Datasheet RS-SERIES RS 30 115VAC LD LP 1A Weidmuller Interface GmbH & Co. KG Klingenbergstrae 16 D-32758 Detmold Germany Fon: +49 5231 14-0 Fax: +49 5231 14-2083 www.weidmueller.com Clip-on RS 30. 31. 32 relay bases are available in widths from 11.2 to 25 mm, depending on the type. The RSM relay multiplexers are available as 4, 8 and 16-way modules. To reduce the wiring work, the DC variants are fitted with a common plus or minus potential. The optional IEC603-1 plug-in connector enables the connection of pre-assembled lines. The screw connection system is used to connect the conductor with a rated cross-section of 2.5 mm. General ordering data Order No. Part designation Version GTIN (EAN) Qty. 1102111001 RS 30 115VAC LD LP 1A RS-SERIES, Relays, No. of contacts: 1, NO contact, Rated control voltage: 115 V AC, Screw connection 4032248045976 10 pc(s). Creation date November 4, 2010 6:08:49 PM CET Last update 27.09.2010 / We reserve the right to make technical changes. 1 Datasheet RS-SERIES RS 30 115VAC LD LP 1A Weidmuller Interface GmbH & Co. KG Klingenbergstrae 16 D-32758 Detmold Germany Fon: +49 5231 14-0 Fax: +49 5231 14-2083 www.weidmueller.com Technical data Dimensions Length Height 70 mm 56 mm Width 11.2 mm -25 C...+40 C Storage temperature -40 C...+60 C 250 V 98 V 4.3 mA / 2 mA Rated control voltage Rated current DC Power rating 115 V AC 8A 0.8 VA 5A 8A 10 mA < 9 ms 8A Duration of Bounce Max. switching frequency at rated load Switch-off delay Switching voltage AC, max. min. switching capacity 3 ms 30 Hz 8 ms 250 V 250 mW Contact design Contact material NO contact No. of contacts Mechanical service life 1 Electrical service life, DC coil > 5x10 switching cycles Electrical service life of AC coil > 7x10 switching cycles Screw connection 40C / 93% rel. humidity, no condensation DIN Rail compatibility TS 32 TS 35 Temperature Ambient temperature (operational) Input Rated voltage Response / drop-out voltage AC coil Pull-in / drop-out current, AC coil Output Continuous current Max. switching current Min. switching current Switch-on delay making current Contact data AgNi 0.15 gold flashed 5 6 20 x 10 switching cycles 5 Rated data Conductor connection system Humidity Insulation coordination (EN 50 178) Clearance and creepage distances for control/load side Overvoltage category Protection class > 3 mm III IP 20 Impulse withstand voltage Pollution severity Rated voltage 4 kV 2 250 V Reverse polarity protection not available ETIM 3.0 eClass 6.0 EC001437 27-37-16-01 Other technical data Free-wheel diode Version No Relay coupler Approvals Approvals institutes CSA; GOSTME25; MARITREG; CE Classifications ETIM 2.0 eClass 5.1 EC001437 27-37-16-01 Creation date November 4, 2010 6:08:49 PM CET Last update 27.09.2010 / We reserve the right to make technical changes. 2