RK08H113003G - ALPS ELECRIC

?Photo ?Dimensions ?Mounting Hole Details ?Circuit Diagram ?Packing Specifications ?

?Soldering Conditions ?

Part number RK08H113003G

Number of resistor elements Single-unit

Mounting direction Vertical type

Length of the shaft 1mm

Center detent Without

Total resistance 50k?

Resistance taper 1B

Soldering Reflow

Operating temperature range -10? to +60?

Electrical Performance Total resistance

tolerance

±30%

Rated power 0.03W

Maximum operating

voltage

50V AC, 20V DC

Maximum attenuation 80dB min.

Residual resistance 50? or less

Mechanical

Performance

Total rotational angle 200±10°

Rotational torque 0.5 to 10mN?m

Stopper strength 0.1N·m

Push-pull strength 10N

Durability Operating life 10,000 cycles

Minimum order unit

(pcs.)

Japan 1,000

Export 1,000

3D CAD (STEP)

Certificate of Compliance to RoHS regulations

Photo

Dimensions

Mounting Hole Details

1. Keep the DUMMY terminal open in the circuit.

2. Shaded areas are solder lands.

Circuit Diagram

Packing Specifications

Ta pi ng

Number of packages

(pcs.)

1 reel 1,000

1 case / Japan 4,000

1 case / export

packing

4,000

Tape width (mm) 16

Export package measurements (mm) 397×401×139

Soldering Conditions

Ex ampl e of R efl ow Sol deri ng Condi ti on

1. Heating method

Double heating method with infrared heater.

2. Temperature measurement

Thermocouple 0.1 to 0.2 ? CA (K) or CC (T) at soldering portion (copper foil surface). A heat resisting tape should be

used for fixed measurement.

3. Temperature profile

A B C D E F G H No. of reflows

250? 200? 150? 150? 2 min. 3s 40s 4 min. 2 time max.

1. When using an infrared refl ow oven, solder may sometimes not be applied. Be sure to use a hot air refl ow oven or a

type that uses infrared rays in combination with hot air.

2. The temperatures given above are the maximum temperatures at the terminals of the potentiometer when employing a

hot air reflow method. The temperature of the PC board and the surface temperature of the potentiometer may vary

greatly depending on the PC board material, its size and thickness. Ensure that the surface temperature of the

potentiometer does not rise to 250°C or greater.

3. Conditions vary to some extent depending on the type of refl ow bath used. Be sure to give due consideration to this

prior to use.

Notes are common to this series/models.

This site catalog shows only outline specifications. When using the products, please obtain formal specifications for

supply.

Please place purchase orders per minimum order unit (integer).

Products other than those listed in above products are also available. Please contact us for details.

Dip soldering can be applied to the above products. For dip soldering applications, specifyseparately as "dip soldering

applicable product". Back-to-back mounting types are excluded.

We recommend print boards with a thickness of 0.8mm to 1.2mm. For 1.6mm thickness board applications, please

Inquiries about Products

In qu i ry

F or more i nf ormati on pl ea s e contac t: Sa l es or Products

Inf orm a ti on Cen ter.

1-7, Yukigaya-otsukamachi, Ota-ku, Tokyo, Japan 145-8501

PHONE : +81 (3) 5499-8154

Rotary Potentiometer > RK08H Series > RK08H113003G

Without Knob Type RK08H Series