VDR-75-12 - V-Infinity - Product.Network



•

V-Infinity, LLC, 9615 SW Allen Blvd Suite 103, Beaverton, OR 97005 www.v-infinity.com 1-866-372-1258

VDR-75-12 Single Output DIN Rail Power Supply

DC output voltage 12V

Output V. tolerance ±2%

Output rated current 6.3A

Output current range 0-6.3A

Ripple & noise 100mVp-p

Line regulation ±0.5%

Load regulation ±0.5%

DC output power 76W

Efficiency 76%

DC voltage adj. 12-14V

Input voltage range 85~264VAC 47~63Hz; 120~370VDC

AC current 2.0A/115V 1.2A/230V

Inrush current cold start 30A/115V 60A/230V

Leakage current <1mA/240VAC

Overload protection 105%~150%

type: constant current limiting, auto recovery

Over voltage protection 15~16.5V

Over temp. protection 85ºC± 5ºC type: shutdown reset\;auto recovery (TSW1)

Temperature coefficient ±0.03% / °C (0~50°C)

Set up, rise, hold up time 1000ms;60ms;50ms/230V;1800ms;60ms;10ms/115V

Vibration 10~500Hz, 2G 10min./1cycle (1 hour each axes)

Withstand voltage I/P-O/P: 3KVAC, I/P-FG: 1.5KVAC, O/P-FG: 0.5KVAC, for 1 min.

Isolation resistance I/P-O/P, I/P-FG, O/P-FG:500VDC / 100M Ohms min.

Working temp., humidity -10°C~+60% (refer to output derating curve), 20%-90% RH

Storage temp., humidity -20ºC~+85ºC, 10%~95% RH

Dimensions 2.19x4.93x3.94 inches (55.5x125.2x100mm)

Weight 1.32lbs (0.6Kgs)

Safety standards TUV EN60950, UL508

EMC standards EN55022 CLASS B, EN61000-4-2,3,4,5,6,8,11; ENV50204, EN61000-3-2,-3

Notes: 1. All parameters are specified at 230VAC input, rated load, 25°C 70% RH ambient

2. Tolerance includes set up tolerance, line regulation, load regulation

3. Ripple & noise are measured at 20MHz by using a 12” twisted pair terminated with a 0.1uF & 47 uF capacitor

4. Line regulation is measured from low line to high line at rated load

5, Load regulation is measure from 0% to 100% rated load

*V-Infinity reserves the right to make changes to its products or to discontinue any product or service without notice, and to advise cus-

tomers to verify the most up-to-date product information before placing orders. V-Infinity assumes no liability or responsibility for cus-

tomer’s applications using V-Infinity products other than repair or replacing (at V-I’s option) V-Infinity products not meeting V-I’s pub-

lished specifications. Nothing will be covered outside of standard product warranty.

Features

·Fixed switching frequency @ 50kHz

·Installed on din rail T535 / 7.5 or 15

·Universal AC input range

·Short circuit, overload, over-voltage protected

·100% full load burn-in test

·Built in EMI filter, low ripple noise

·Convection cooled

·3 year warranty

·Fully approved