THE CONNOR-WINFIELD CORP. 2111 COMPREHENSIVE DRIVE. AURORA, IL 60505. FAX (630) 581-5040. PHONE (630) 851-4722. www.conwin.com PRODUCT D ATA SHEET CW 0107 VPLB54TEM 622.08 CRYSTAL CONTROLLED OSCILLATORS 3.3V SURFACE MOUNT PECL OSCILLATOR ABSOLUTE MAXIMUM RATINGS PARAMETER TABLE 1.0 UNITS MINIMUM NOMINAL MAXIMUM UNITS -40 - 85 C Storage Temperature Supply Voltage (Vcc) -0.5 - 7.0 Vdc Control Voltage (Vc) -0.5 - 7.0 Vdc MINIMUM MAXIMUM UNITS -20 0 NOMINAL 622.08000 644.53125 666.51428 669.32660 777.60000 - 20 70 MHz ppm C Vdc OPERATING SPECIFICATIONS - - Center Frequency Total Frequency Tolerance Operating Temperature Range (Fo) Supply Voltage (Vcc) 3.135 3.3 3.465 Supply Current (Icc) - - 100 mA Jitter (BW=10Hz to 20MHz) - - 5 ps rms Jitter (BW=12kHz to 20MHz) SSB Phase Noise at 100Hz offset SSB Phase Noise at 1KHz offset SSB Phase Noise at 10KHz offset SSB Phase Noise at 100KHz offset - -60 -100 -130 -135 1 - ps rms dBc/Hz dBc/Hz dBc/Hz dBc/Hz MINIMUM 0.3 +/-25 -10 - NOMINAL 1.65 50K MAXIMUM 3.0 10 - UNITS Vdc ppm % Ohm 10 - - KHz INPUT CHARACTERISTICS (Vc) Modulation Bandwidth (3dB) (High) (Voh) (Low) (Vol) PACKAGE CHARACTERISTICS 3.0 FEATURES IMPROVED MICROPHONIC DESIGN MAXIMUM UNITS NOTE - - 50 Ohms 3 2.26 - - Vdc Rise / Fall Time 20% to 80% 2.0 2 NOMINAL Duty Cycle at 50% Level Notes 1.0 NOTE MINIMUM LOAD Wash 1 TABLE 4.0 PARAMETER Solder Reflow The Connor-Winfield VPLB54TEM is a 3.3V Voltage Controlled Crystal Oscillator (VCXO) with LVPECL Differential outputs. Based on a fundamental strip crystal design, the VPLB54TEM is designed for phased lock loop applications requiring low jitter and tight stability. 3.3V SUPPLY VOLTAGE PECL OUTPUT CHARACTERISTICS PROCESS RECOMMENDATIONS DESCRIPTION NOTE TABLE 3.0 PARAMETER Control Voltage Range Absolute Pull Range (APR) Monotonic Linearity Input Impedance Package VPLB54TEM TABLE 2.0 PARAMETER Voltage NOTE - - 1.70 Vdc 45 50 55 % - - 1.0 nS LOW JITTER <1pS RMS FREQUENCY TOLERANCE 20PPM TEMPERATURE RANGE 0 TO 70C DIFFERENTIAL PECL OUTPUTS TABLE 5.0 Non-hermetic package consisting of an FR4 substrate with grounded m etal cover. ORDERING INFORMATION TABLE 6.0 The component solder used internal to this device has a m elting point of 221C. The peak temperature inside the device should be less than or equal to 220C for a maximum of 10 seconds Ultrasonic cleaning is not recommended. VPLB54TEM - 622.08MHz Control Voltage @ 1.65V. Includes calibration @ 25C, deviation over temperature, supply and load variations, shock, vibration and aging for fifteen years. Referenced to Fo at T=25C Positive Slope. Absolute pull range (APR) is the minimum guaranteed pull range of the VCXO under all conditions over lifetime operation. The APR is referenced to Fo. Output terminated into 50 ohms into Vcc - 2.0Vdc or Thevenin equivalent. VCXO SERIES CENTER FREQUENCY Specifications subject to change without notice. DATA SHEET #: Vx386 PAGE 1 OF 2 REV: 01 DATE: 5/30/03 aCopyright 2001 Connor-Winfield all rights reserved. THE CONNOR-WINFIELD CORP. 2111 COMPREHENSIVE DRIVE. AURORA, IL 60505. FAX (630) 581-5040. PHONE (630) 851-4722. www.conwin.com PRODUCT D ATA SHEET CRYSTAL CONTROLLED OSCILLATORS .225 MAX (5.71mm) PIN FUNCTION CW DATE CODE VPLB54TEM 622.08M 1 6 7 8 9 14 CONTROL VOLTAGE N/C GROUND (CASE) Q OUTPUT COMP OUTPUT Vcc 3.3Vdc 14 1 9 8 6 3.3Vdc 7 1.65Vdc N/C Specifications subject to change without notice. DATA SHEET #: Vx386 PAGE 2 OF 2 REV: 01 DATE: 5/30/03 aCopyright 2001 Connor-Winfield all rights reserved.