MATERIALS BODY BRASS NICKEL PLATED CONTACT SILVER PLATED - INSULATOR PTFE 2.300 _ ( (==) ) 1.250 ASSEMBLY PROCEDURES 1. SLIDE CLAMP NUT (1), WASHER (2) & GASKET (3) OVER CABLE. STRIP CABLE AS SHOWN. DO NOT NICK BRAID WHILE CUTTING JACKET. TAPER END OF BRAID TO PERMIT ASSEMBLY OF BRAID CLAMP (4). SLIDE BRAID CLAMP (4) OVER BRAID & SEAT AGAINST JACKET. a7 rr LO 1 23 2. FORM BRAID OVER CLAMP NUT (4). TRIM BRAID BACK TO SHOULDER. CUT DIELECTRIC & CENTER CONDUCTOR TO DIMENSION SHOWN. DO NOT NICK CENTER CONDUCTOR. SOLDER CONTACT TO CENTER CONDUCTOR. REMOVE EXCESS SOLDER. DO NOT OVER HEAT DIELECTRIC. INSERT CABLE ASSEMBLY INTO BODY & TIGHTEN. all OU 250 oO NL PASTERNACK ENTERPRISES, INC. P.O BOX 16759, IRVINE, CA 92623 PHONE (949) 261-1920 FAX (949) 261-7451 WEB ADDRESS: www.pasternack.com PASTERNACK ENTERPRISES E-MAIL ADDRESS: sales@pasternack.com ESTABLISHED 1972 COAXIAL & FIBER OPTICS DWG TITLE DES. 7/16 MALE, CLAMP ATTACHMENT FOR RG14 PE44276 ere REV.A | FSCM NO. 53919 CAD FILE 020909 SCALE NIA | SIZE A| 147 NOTES: 1. UNLESS OTHERWISE SPECIFIED ALL DIMENSIONS ARE NOMINAL. 2. ALL SPECIFICATIONS ARE SUBJECT TO CHANGE WITHOUT NOTICE AT ANY TIME. 3. DIMENSIONS ARE IN INCHES.