KVR16LE11/8KF - KINGSTON TECHNOLOGY

KVR16LE11/8KF

8GB 2Rx8 1G x 72-Bit PC3L-12800

CL11 240-Pin ECC DIMM

DESCRIPTION

This document describes ValueRAM's 1G x 72-bit (8GB)

DDR3L-1600 CL11 SDRAM (Synchronous DRAM), 2Rx8, ECC,

low voltage, memory module, based on eighteen 512M x 8-bit

FBGA components. The SPD is programmed to JEDEC stan-

dard latency DDR3-1600 timing of 11-11-11 at 1.35V or 1.5V.

This 240-pin DIMM uses gold contact fingers. The electrical

and mechanical specifications are as follows:

FEATURES

•JEDEC standard 1.35V (1.28V ~ 1.45V) and 1.5V (1.425V ~

1.575V) Power Supply

•VDDQ = 1.35V (1.28V ~ 1.45V) and 1.5V (1.425V ~ 1.575V)

•800MHz fCK for 1600Mb/sec/pin

•8 independent internal bank

•Programmable CAS Latency: 11, 10, 9, 8, 7, 6

•Programmable Additive Latency: 0, CL - 2, or CL - 1 clock

•8-bit pre-fetch

•Burst Length: 8 (Interleave without any limit, sequential with

starting address “000” only), 4 with tCCD = 4 which does not

allow seamless read or write [either on the fly using A12 or

MRS]

•Bi-directional Differential Data Strobe

•Thermal Sensor Grade B

•Internal(self) calibration : Internal self calibration through ZQ

pin (RZQ : 240 ohm ± 1%)

•On Die Termination using ODT pin

•Average Refresh Period 7.8us at lower than TCASE 85°C,

3.9us at 85°C < TCASE < 95°C

•Asynchronous Reset

•PCB: Height 1.18” (30mm), double sided component

Document No. VALUERAM1375-001.B00 12/03/13 Page 1

Memory Module Speciﬁ cations

Continued >>

SPECIFICATIONS

CL(IDD) 11 cycles

Row Cycle Time (tRCmin) 48.125ns (min.)

Refresh to Active/Refresh 260ns (min.)

Command Time (tRFCmin)

Row Active Time (tRASmin) 35ns (min.)

Maximum Operating Power (1.35V) = 2.041 W*

UL Rating 94 V - 0

Operating Temperature 0o C to 85o C

Storage Temperature -55o C to +100o C

*Power will vary depending on the SDRAM.

SDRAM SUPPORTED

Kingston (F-Die)