TF
thin film chip fuse
Fusing
Time
Internal R.
Maximum
(mΩ)
Rated
Voltage
Rated
Ambient
Temperature
Operating
Temperature
Range
Part
Designation Marking
applications and ratings (continued)
Rated
Current
TF16SN0.25 C 0.25A 960
600
300
190
135
103
78
58
47
38
28
TF16SN0.315 D 0.315A
TF16SN0.50 F 0.50A -40°C
to
+125°C
TF16SN0.63 I 0.63A
Open within 5 sec. at
200% rated current
(Refer to Fusing
Characteristics graph)
TF16SN0.80 K 0.80A
TF16SN1.00 L 1.00A
TF16SN1.25 M 1.25A
TF16SN2.00 S 2.00A
TF16SN2.50 T 2.50A
TF16SN3.15 U 3.15A
32V +70°C
TF16SN1.60 N 1.60A
Derating Curve
environmental applications
% Rated Power
100
80
60
40
20
-40 -20 20 60 80 100120 180
125
40
Ambient Tem perature
(°C)
0
70 140 175
0160
Fusing Characteristics
Fusing Time (Sec.)
10
1
.1
.01
0.1 1 10
Fusing Current
(A)
.001
TF10BN
.315A .5A .63A .8A 1A 1.25A 1.6A 2A 2.5A.25A.20A 3A
Performance Characteristics
Parameter
Requirement
Limit Typical Test Method
Solderability
Bending Test
230°C ± 5°C, 3 seconds ± 0.5 second
Distance between holding points: 90mm, Bending: 3mm,
1 time (BN, AT), 2mm, 1 time (SN)
95% coverage minimum
No mechanical damages
No evidence of damages to
protective coating
and marking
—
—
Clearing Time 200% of rated voltage shall be carried
Within 1 second (16AT, SN)
Within 5 seconds (10BN) —
Resistance to Solder Heat 260°C ± 5°C, 10 seconds ± 0.5+1 second
±10% ±4.5% (16SN)
±5% (10BN, 16AT)
Load Life 70°C ± 2°C, 1000 hours, rated current x 100%,
1.5 hr ON, 0.5 hr OFF cycle
±10% ±4.5%(16SN)
±5% (10BN, 16AT)
Load Life Moisture 40°C ± 2°C, 90 - 95% RH, 1000 hours, rated current x 100%
(10BN, 16SN), x 75% (16AT), 1.5 hr ON, 0.5 hr OFF cycle
±10% ±3% (10BN)
±4.5% (16SN), 5% (16AT)
Rapid Change
of Temperature 16SN: -40°C ± 2°C (30 minutes), 10BN, 16AT: -55°C ± 2°C,
+125°C (30 minutes), 10 cycles
±10% ±4% (16SN)
±5% (10BN, 16AT)
Resistance to Solvent Conforming to MIL-STD-202F
—
Residual Resistance Measure DC resistance after fusing
10kΩ and more —
440
TF16SN0.40 H 0.40A
170
TF16SN0.70 J 0.70A
Fusing Time (Sec.)
10
1
.1
.01
0.1 1100
Fusing Current
(A)
.001
TF16AT
.25A 1A 2.5A
10
.315A .5A .63A .8A 1.25A 1.6A 2.0A 3.15A4.00A5.00A
Fusing Time (Sec.)
10
1
.1
.01
0.1 110
Fusing Current
(A)
.001
.25A
TF16SN
.315A .5A .63A .8A1A1.25A1.6A 2A 2.5A 3.15A.4A .7A.20A
TF16AT3.15 U 3.15A 24
17
TF16AT4.00 X 4.00A 14
TF16AT5.00 Y 5.00A 32V +70°C -55°C
to
+125°C
Open within
1 sec. at 200%
rated current
(Refer to Fusing
Characteristics
graph)
1500
TF16SN0.20 A 0.20A
-0
Stationary Current: Regard the peak of stationary current
waveform as stationary current value when the stationary
current is repeated pulse.
Temperature Derating: Rated current needs to be
derated if used at an ambient temperature 70℃or above.
Refer to the derating coefficient on the left figure.
251
KOA Speer Electronics, Inc. • 199 Bolivar Drive • Bradford, PA 16701 • USA • 814-362-5536 • Fax: 814-362-8883 • www.koaspeer.com
Specifications given herein may be changed at any time without prior notice. Please confirm technical specifications before you order and/or use. 1/06/14
circuit
protection