Product Data Sheet
TC-210 (Z5) Series TCXOs
Features
Frequency from 0.5 to 160 MHz
Stability as tight as ±0.28 ppm
Aging to <3.5 ppm for ten years
Package: 29.21 x 25.40 x 10.03mm (1.15 x 1.0 x 0.395)
3.3 Vdc or 5 Vdc operation
All outputs available
(TTL, HCMOS, PECL, SINEWAVE)
Stratum 3 Applications
SONET/SDH Network Timing Sources
DWDM / FDM / ATM
Wireless Communications
VSAT, LMDS, WLL
Vectron International has introduced a series of surface
mount, Temperature Compensated Crystal Oscillators
(TCXOs) available in frequencies from 0.5 to 160 MHz.
Model Z5 surface mount TCXOs can be mounted
using the standard convection reflow process. The
units can meet the ±0.37 ppm Holdover requirement of
GR-1244-CORE Table 3-1 from 0ºC to +70ºC
temperature range and operate from a 3.3V or 5V
supply. Current drain to lower than 2 mA is available
upon request. Aging <3.5 ppm for ten years. Phase
noise is -115 dBc/Hz at 100 Hz and -155 dBc/Hz at
100k Hz at 10 MHz.
These units are ideal for Stratum 3 applications.
For additional Stratum 3 solutions please visit our
website at: www.stratum3.com
Temperature Compensated Crystal Oscillators
Output Options:
Standard Stability Options:
Stability vs Supply:
B-307 = ±3.0 x 10-7 over C to +50ºC
B-ST3 = Stratum 3 over C to +50ºC
C-ST3 = Stratum 3 over C to +70ºC
C-507 = ±5.0 x 10-7 over C to +70ºC
F-106 = ±1.0 x 10-6 over -40ºC to +85ºC
STRATUM 3 per GR-1244-CORE Table 3-1
Total Stability: 4.6 x 10-6 for all causes & 10 years
Vs Holdover: 3.7 x 10-7 for all causes and 24 Hours
(Available in Temperature Ranges B & C)
Current Draw: Current draw will vary greatly depending on frequency and output type.
For this series TCXO typical current draw will be about 15 mA and
depending on output type may be less than 2 mA. Please consult the
factory about your exact current requirements.
Supply Voltage (Vdd):
(Other options are available upon request) C = 5 Vdc ±5%
D = 3.3 Vdc ±5%
Electrical Frequency
Adjust:
±5 ppm minimum
via external voltage, 0 to Vdd
Phase Noise (Typical):
10 MHz
Offset Phase Noise
100 Hz -115 dBc/Hz
1k Hz -145 dBc/Hz
10k Hz -150 dBc/Hz
100k Hz -155 dBc/Hz
Aging (typical): <3.5 ppm for ten years @ +70ºC
0.1 ppm for a ±5% change in Supply Voltage
Package: 210 = 29.21 x 25.40 x 10.03 mm (1.15 x 1.00 x 0.395) (See page 3)
A = HCMOS / ACMOS 0.5 to 160 MHz
B = 10 TTL 0.5 to 160 MHz
F = Complementary PECL 35 to 160 MHz
G = 0 dBm / 50 ohm 5.0 to 100 MHz
Note: Other stability options are available.
Contact the factory for assistance.
For HCMOS / ACMOS / TTL & PECL
outputs with frequencies above 35 MHz
a low phase noise PLL multiplier may be
used. Please inform that factory of your
phase noise requirements.
Standard Frequencies: 10.00, 12.80, 16.384, 19.44, 20.00, 38.88, 40.00, 77.76, 155.52 MHz,
Available from 0.5 MHz to 160 MHz
*
*
*
(in.)
25.40
(1.00)
29.21
(1.15)
10.16
(0.4)
20.574
(0.81)
10.033
(0.395)
25.4
(1.00)
20.32
(.800)
2.54
(.100)
13.97
(.550)
6.35
(.250)
2.54
(.100)
3.048 SQ
(.120 SQ )
2.54
(.100)
1.143R
(.045R)
2.54
(.100)
5 places
pre-heating
60 to 90 sec.
at 150ºC to 170ºC
reflow
20 to 40 sec.
at > 200ºC
Note: TCXOs are precision subsystems with tolerances measured to ±0.01 ppm. Non-Hermetically sealed TCXOs should
not be subjected to a wash process that will immerse the TCXO in solvents. NO CLEAN is the recommended procedure.
The Z5 series of TCXOs has been designed for pick and place reflow soldering. The suggested reflow profile is shown
above. The TCXO may be reflowed once, and should not be reflowed in the inverted position. Typical frequency shift as a
result of reflow is <1.0 ppm per reflow.
www.vectron.com
TC- 210 - X X X - X X X A - MHz
Supply Voltage
C = 5 Vdc +/-5%
D = 3.3 Vdc +/-5%
Other Options
A = Standard, No Options (Default)
Output Frequency
0.5 to 160 MHz
Output Type
A = HCMOS / ACMOS
B = 10 TTL
F = Comp. PECL
G = 0 dBm / 50 ohm
Temperature & Stability
B-307 = ±3.0 x 10-7 over 0ºC to +50ºC
B-ST3 = Stratum 3 over 0ºC to +50ºC
C-ST3 = Stratum 3 over 0ºC to +70ºC
C-507 = ±5.0 x 10-7 over 0ºC to +70ºC
F-106 = ±1.0 x 10-6 over -40ºC to +85ºC
Note: Other stabilities are available upon request
Example:
TC-210-DAC-507A - 10 MHz
This is a 10 MHz Z5 series TCXO in our 210 package configuration, 3.3 Vdc supply,
HCMOS / ACMOS output, with a Temp stability of ±5.0 x 10-7 over C to +70ºC.
OUT
Vdd
.01µF
CL
PROBE
DUT
Standard CMOS (A)
RL
OUT
Vdd
.01µF
DUT
50
50 COAX
50 Ohm Sinewave (G)
Q
Vdd
.01µF
PROBE
DUT
PECL (F)
+3 Vdc
51
Q
+3 Vdc
51