101.6mm (4.0 INCH) 5x7 DOT MATRIX DISPLAY TA40-11GWA Features GREEN Description 4.0 INCH MATRIX HEIGHT. The Green source color devices are made with DOT SIZE 10mm. Gallium Phosphide Green Light Emitting Diode. LOW CURRENT OPERATION. HIGH CONTRAST AND LIGHT OUTPUT. COMPATIBLE WITH ASCII AND EBCDIC CODES. STACKABLE HORIZONTALLY. COLUMN ANODE AVAILABLE. EASY MOUNTING ON P.C. BOARDS OR SOCKETS. MULTICOLOR AVAILABLE. MECHANICALLY RUGGED. STANDARD : GRAY FACE, WHITE DOT. RoHS COMPLIANT. Package Dimensions & Internal Circuit Diagram Notes: 1. All dimensions are in millimeters (inches), Tolerance is 0.25(0.01")unless otherwise noted. 2. Specifications are subject to change without notice. SPEC NO: DSAD2483 REV NO: V.5 DATE: OCT/26/2005 PAGE: 1 OF 4 APPROVED: J. Lu CHECKED: Joe Lee DRAWN: Y.L.LI ERP:1332000227 Selection Guide Part No. Dice TA40-11GWA Lens Type GREEN (GaP) WHITE DIFFUSED Iv (ucd) @ 10mA Description Min. Typ. 4700 24000 Column Anode Electrical / Optical Characteristics at TA=25C Symbol Parameter Device peak Peak Wavelength Green D Dominant Wavelength 1/2 Typ. Max. Units Test Conditions 565 nm IF=20mA Green 568 nm IF=20mA Spectral Line Half-width Green 30 nm IF=20mA C Capacitance (Per Chip) Green 15 pF VF=0V;f=1MHz VF Forward Voltage (Per Dot) Green 4.4 5.0 V IF=20mA IR Reverse Current (Per Dot) Green 10 uA VR = 10V Absolute Maximum Ratings at TA=25C Parameter Green Units Power dissipation (Per Dot) 125 mW DC Forward Current (Per Dot) 25 mA Peak Forward Current [1] (Per Dot) 140 mA Reverse Voltage (Per Dot) 10 V Operating / Storage Temperature -40C To +85C Lead Solder Temperature [2] 260C For 5 Seconds Notes: 1. 1/10 Duty Cycle, 0.1ms Pulse Width. 2. 2mm below package base. SPEC NO: DSAD2483 REV NO: V.5 DATE: OCT/26/2005 PAGE: 2 OF 4 APPROVED: J. Lu CHECKED: Joe Lee DRAWN: Y.L.LI ERP:1332000227 Green TA40-11GWA SPEC NO: DSAD2483 REV NO: V.5 DATE: OCT/26/2005 PAGE: 3 OF 4 APPROVED: J. Lu CHECKED: Joe Lee DRAWN: Y.L.LI ERP:1332000227 PACKING & LABEL SPECIFICATIONS TA40-11GWA Remarks: If special sorting is required (e.g. binning based on forward voltage, Luminous intensity/ luminous flux, or wavelength), the typical accuracy of the sorting process is as follows: 1. Wavelength: +/-1nm 2. Luminous intensity/ luminous flux: +/-15% 3. Forward Voltage: +/-0.1V Note: Accuracy may depend on the sorting parameters. SPEC NO: DSAD2483 REV NO: V.5 DATE: OCT/26/2005 PAGE: 4 OF 4 APPROVED: J. Lu CHECKED: Joe Lee DRAWN: Y.L.LI ERP:1332000227