http://airpax.sensata.com/
PGFI Series - 20 Amp Portable (Cord) Series
272
PGFI Series
20 Amp Portable Series (Cord) GFCI / ELCI
INTRODUCTION
The LineGard™ 20 Amp Portable Series is an industrial grade ground fault circuit interrupter designed and manufactured by North
Shore Safety, Ltd., a leader in innovated safety products. This product is the “Go Anywhere” protection device. Rated for 20 amps and
available at 120 VAC, 240 VAC, 208 VAC, or 277 VAC (UL 1053 compliant), the device is also available with either manual (safe start) or
automatic reset configuration. Standard offerings include products with plug and connector or flying leads for field configuring which
can be constructed into stand-alone cord sets or equipment integrated power supply cords. The product series is well suited for wet
location use with an achieved NEMA 4X rating.
Note that any power cord integrated with this device becomes OSHA compliant for portable power usage in confined space: OSHA 29
CFR 1926.404(b)(1)(ii) and 29 CFR 1926.405(a)(2)(ii)(G). Additionally, this product meets the requirements of NEC 590.6(a) & (b).
• Powerandfaultstatusindicators
• Electro-mechanicallylatchedcontactswillnot
de-latch under rough service usage
• ChemicalandUVresistantenclosure
• ClassAcULus943listed
• NEMA4Xrated(indoor/outdooruse)
• Doubleinsulateduserinterfaceforaddedsafety
• Availableinautomaticormanualresetconfigurations*
• Availablewithwiringdevicesorflyingleads
• 2-yearmanufacturer’swarranty
SPECIFICATIONS
Listing Type cULus Listed Class A
UL 943
CSA 22.2 No. 144
Rated Supply Voltage 120 VAC, 240 VAC, 208 VAC,
277 VAC (UL 1053 compliant)
Rated Current Up to 20 Amps or rating of wiring device
and/or cable
Trip Level, Class A 5mA +/– 1mA (UL 943)
Operating Frequency 60 Hz
Reset Type1Automatic or Manual
Ground Trip Current 4 mA to 6 mA
Overload Current 90 Amps @ 125VAC
Insulation Voltage 1,500 VRMS for 1 minute
Endurance Operations 3000 operations
1. Manual configuration should be specified if automatic start-up after power
restoration of circuit power creates an unsafe condition.
2. Integrated or replacement cable must be indoor/outdoor 3-conductor cable of type
ST, SJT, SE, SJE, SO or SJO
FEATURES
2 Voltage
1 120 VAC
2 240 VAC
9 208 VAC
D 277 VAC
3 Ampacity
2 20 amps
4 Reset Type
0 Manual
1 Automatic
6 Connector
N None
1 Locking
PGFI - 2 2 0 1 N
Product Type
1
Note: 1. Manual configuration should be specified if automatic power-up, after power restoration of circuit power, could create an unsafe condition.
2. Units are configured with SJTW cable and molded locking non-watertight connectors configured to 20 Amps.
NEMA configurations for the 120 VAC and 208/240 VAC are L5-20 and L6-20 respectively. 277 VAC configurations are L7-20
3. Integrated or replacement cable must be indoor/outdoor 3-conductor cable of type ST, SJT, SE, SJE, SO or SJO
4. Custom cord sets and watertight connectors are available. Please consult Airpax
5 Cable Configuration
1 2’ yellow, 12/3, SJEOOW cable
2 25’ yellow, 12/3, SJEOOW cable
3 50’ yellow, 12/3, SJEOOW cable
5 6’ yellow, 12/3, SJEOOW cable
1
(see notes)
NEMA and IEC 309 Connectors available Flying Leads (SJOOW)
http://airpax.sensata.com/ PGFI Series - 20 Amp Portable (Cord) Series 273
APPLICATION OPPORTUNITIES:
Electrical wet locations
Power generators
Agricultural equipment
Outdoor electrical equipment
Cement cutting equipment
Portable electric heaters
Submersible pumps
Pipeline heaters
Automotive garages
Industrial part washers
Outdoor signage
De-icingequipment(roofheaters)
RELATED CODES
Confined Space OSHA 29 CFR 1926.404 (b)(1)(ii),
OSHA 29 CFR 1926.405 (a)(2)(ii)(G)
Construction Sites (NEC 590.6)
Commercial Garages (NEC 511.12)
Outdoor Signs (NEC 600.10)
Fountains & Water
Displays
(NEC 680.58)
Spa & Hot Tubs (NEC 680.40)
Marinas & Boat Yards (NEC 555.3)
DECISION TABLES
Ground Fault / Equipment Leakage
