Memory Module Specifications KVR1333D3N9K3/12G 12GB (4GB 2Rx8 512M x 64-Bit x 3 pcs.) PC3-10600 CL9 240-Pin DIMM Kit Important Information: The module defined in this data sheet is one of several configurations available under this part number. While all configurations are compatible, the DRAM combination and/or the module height may vary from what is described here. DESCRIPTION SPECIFICATIONS ValueRAM's KVR1333D3N9K3/12G is a kit of three 512M x 64- CL(IDD) 9 cycles bit (4GB) DDR3-1333 CL9 SDRAM (Synchronous DRAM), 2Rx8 Row Cycle Time (tRCmin) 49.5ns (min.) memory modules, based on sixteen 256M x 8-bit DDR3-1333 Refresh to Active/Refresh Command Time (tRFCmin) 160ns (min.) FBGA components per module. Total kit capacity is 12GB. The SPD's are programmed to JEDEC standard latency DDR3-1333 Row Active Time (tRASmin) 36ns (min.) timing of 9-9-9 at 1.5V. Each 240-pin DIMM uses gold contact Maximum Operating Power 2.400 W* (per module) fingers. The electrical and mechanical specifications are as follows: UL Rating 94 V - 0 Operating Temperature 0o C to 85o C Storage Temperature -55o C to +100o C FEATURES *Power will vary depending on the SDRAM used. * JEDEC standard 1.5V (1.425V ~1.575V) Power Supply * VDDQ = 1.5V (1.425V ~ 1.575V) * 667MHz fCK for 1333Mb/sec/pin * 8 independent internal bank * Programmable CAS Latency: 9, 8, 7, 6 * Programmable Additive Latency: 0, CL - 2, or CL - 1 clock * Programmable CAS Write Latency(CWL) = 7 (DDR3-1333) * 8-bit pre-fetch * Burst Length: 8 (Interleave without any limit, sequential with starting address "000" only), 4 with tCCD = 4 which does not allow seamless read or write [either on the fly using A12 or MRS] * Bi-directional Differential Data Strobe * Internal(self) calibration: Internal self calibration through ZQ pin (RZQ : 240 ohm 1%) * On Die Termination using ODT pin * Average Refresh Period 7.8us at lower than TCASE 85C, 3.9us at 85C < TCASE < 95C * Asynchronous Reset * PCB: Height 0.740" (18.75mm), double sided component Continued >> Document No. VALUERAM0844-001.C00 05/18/12 Page 1 MODULE DIMENSIONS: (Units = Millimeters) Document No. VALUERAM0844-001.C00 Page 2