ER3AB
THRU
ER3MB
3 Amp Super Fast
Recovery
Silicon Rectifier
50 to 1000 Volts
DO-214AA
(SMB) (LEAD FRAME)
Features
• Easy Pick And Place
• High Temp Soldering: 260°C for 10 Seconds At Terminals
• Super Fast Recovery Times For High Effieciency
Maximum Ratings
MCC
Catalog
Number
Device
Marking
Maximum
Recurrent
Peak Reverse
Voltage
Maximum
RMS
Voltage
Maximum
DC
Blocking
Voltage
ER3AB ER3AB 50V 35V 50V
ER3BB ER3BB 100V 70V 100V
ER3CB ER3CB 150V 105V 150V
ER3DB ER3DB 200V 140V 200V
ER3GB ER3GB 400V 280V 400V
ER3JB ER3JB 600V 420V 600V
Electrical Characteristics @ 25°C Unless Otherwise Specified
Average Forward
Current
IF(AV) 3.0A TA=75°C
Peak Forward Surge
Current
IFSM 100A 8.3ms, half sine
Maximum
Instantaneous
Forward Voltage
ER3AB-3DB
ER3GBVF.95V
1.25V
IFM = 3.0A;
TJ
= 25°C*
Maximum DC
Reverse Current At
Rated DC Blocking
Voltage
IR5µA
200µA
TJ = 25°C
TJ = 100°C
Maximum Reverse
Recovery Time
IF=0.5A, IR=1.0A,
Irr=0.25A
Typical Junction
Capacitance
CJ45pF Measured at
1.0MHz, VR=4.0V
*Pulse test: Pulse width 300 µsec, Duty cycle 2%
ER3JB~3MB 1.70V
MCC omponents
20736 Marilla Street Chatsworth
!"#
$% !"#
Revision: B 2013/01/01
TM
Micro Commercial Components
www.mccsemi.com
1 of 4
• Lead Free Finish/Rohs Compliant (Note1) ("P"Suffix designates
Compliant. See ordering information)
• Operating Temperature: -50°C to +150°C
• Storage Temperature: -50°C to +150°C
• Typical Thermal Resistance; 16 °C/W Junction To Lead
ER3KB ER3KB 800V 560V 800V
ER3MB ER3MB
1000V 700V 1000V
1. High Temperature Solder Exemptions Applied, see EU Directive Annex 7.
ER3AB~ER3JB
ER3KB~ER3MBTrr 35ns
75ns
0.070”
0.090"
0.085”
SUGGESTED SOLDER
PAD LAYOUT
H
J
E
G
A
B
D
C
DIMENSIONS
INCHES MM
DIM MIN MAX MIN MAX NOTE
A .075 .095 1.91 2.41
B .077 .083 1.96 2.10
C.002 .008 .05 .20
D ----- .02 ----- .51
E .030 .060 .76 1.52
G .200 .220 5.08 5.59
H .160 .187 4.06 4.75
J .130 .155 3.30 3.94
• Moisture Sensitivity Level 1
• Epoxy meets UL 94 V-0 flammability rating
• Halogen free available upon request by adding suffix "-HF"
ER3AB thru ER3MB
Figure 3
Typical Junction Capacitance
.1 .2 1.4 2 10 20 404 100 200
1
2
6
10
20
100
Junction Capacitance - pF versus
Reverse Voltage - Volts
pF
Volts
60
40
4
400 1000
TJ=25°C
Figure 1
Typical Forward Characteristics
Instantaneous Forward Current - Amperes versus
Instantaneous Forward Voltage - Volts
Volts
4
6
20
10
Amps
.4 1.4
.6 .8 1.0 1.2
.01
.02
.04
.06
.1
.2
.4
.6
1
2
TJ=25°C
40
60
100
1.6
Average Forward Rectified Current - Amperes versus
Lead Temperature -°C
Figure 2
Forward Derating Curve
40 60 100 120 140 160
0
.5
1.0
1.5
Single Phase, Half Wave
60Hz Resistive or Inductive Load
Amps
°C
80
2.0
2.5
3.0
MCC
ER3AB-3DB
ER33GB
ER3JB~3MB
Revision: B 2013/01/01
TM
Micro Commercial Components
www.mccsemi.com
2 of 4
ER3AB thru ER3MB
trr
+0.5A
0
-0.25
-1.0
1cm
Set Time Base for 20/100ns/cm
25Vdc
1Ω
50Ω10Ω
Oscilloscope
Note 1
Pulse
Generator
Note 2
Notes:
1. Rise Time = 7ns max.
Input impedance = 1 megohm, 22pF
2. Rise Time = 10ns max.
Source impedance = 50 ohms
3. Resistors are non-inductive
Figure 6
Reverse Recovery Time Characteristic And Test Circuit Diagram
1 100
4
0
25
50
75
8
Figure 5
Peak Forward Surge Current
Peak Forward Surge Current - Amperes versus
Number Of Cycles At 60Hz - Cycles
Cycles
2610 20 60 80
40
100
125
150
Figure 4
Typical Reverse Characteristics
Instantaneous Reverse Leakage Current - MicroAmperes versus
Percent Of Rated Peak Reverse Voltage - Volts
Volts
40
60
200
100
µAmps
20 120
40 60 80 100
.1
.2
.4
.6
1
2
4
6
10
20
TJ=25°C
400
600
1000
140
Amps
TJ=75°C
TJ=100°C
MCC
Revision: B 2013/01/01
TM
Micro Commercial Components
www.mccsemi.com
3 of 4
MCC
Revision: B 2013/01/01
TM
Micro Commercial Components
www.mccsemi.com
4 of 4
Device Packing
Part Number-TP Tape&Reel: 3Kpcs/Reel
Ordering Information :
***IMPORTANT NOTICE***
Micro Commercial Components Corp. reserves the right to make changes without further notice to any product herein to
make corrections, modifications , enhancements , improvements , or other changes . Micro Commercial Components
Corp . does not assume any liability arising out of the application or use of any product described herein; neither does it
convey any license under its patent rights ,nor the rights of others . The user of products in such applications shall assume all
risks of such use and will agree to hold Micro Commercial Components Corp . and all the companies whose products are
represented on our website, harmless against all damages.
***LIFE SUPPORT***
MCC's products are not authorized for use as critical components in life support devices or systems without the express written
approval of Micro Commercial Components Corporation.
***CUSTOMER AWARENESS***
Counterfeiting of semiconductor parts is a growing problem in the industry. Micro Commercial Components (MCC) is taking
strong measures to protect ourselves and our customers from the proliferation of counterfeit parts. MCC strongly encourages
customers to purchase MCC parts either directly from MCC or from Authorized MCC Distributors who are listed by country on
our web page cited below. Products customers buy either from MCC directly or from Authorized MCC Distributors are genuine
parts, have full traceability, meet MCC's quality standards for handling and storage. MCC will not provide any warranty
coverage or other assistance for parts bought from Unauthorized Sources. MCC is committed to combat this global
problem and encourage our customers to do their part in stopping this practice by buying direct or from authorized
distributors.
Note : Adding "-HF" suffix for halogen free, eg. Part Number-TP-HF
