1.D.C Bulbholder Packing Specification 114-3185 of Great Britain Ltd. APPLICATION 16th daleayee SPECIFICATION 1.0 SCOPE 44 This specification covers the requirements for the application of 5mm 1.D.C Bulbholders and the termination of wiring in these connectors. 2.0 APPLICABLE MATERIALS. 2.1 The following documents form part of the specification: - 108-3382 Product Specification C349494 Customer Drawing C349495 Customer Drawing SP525428-1 Equipment Specification, 3.0 APPLICABLE PART NUMBERS. 3.1 The following part numbers are covered by this specification 349494-1 Bulbholder Assembly 349494-9 Bulbholder Assembly 349495-1 Bulbhalder Assembly 349495-2 Bulbholder Assembly 525428-5 Pneumatic Terminating Tool 4.0 REQUIREMENTS FOR THE APPLICATION OF BULBHOLDER ASSEMBLIES. 4.1 This product is designed to be mounted in a panel of thickness 1.5mm minimum to 2.0mm maximum at a spacing as shown on drawings C349494 and C349495. 4.2 An optional anti-rotation feature is provided. 4.3 The buibhoiders are a push fit in the panel, and can be inserted and extracted easily by hand. 5.0 REQUIREMENTS FOR THE TERMINATION OF WIRES IN BULBHOLDER ASSEMBLIES. 5.1 This product is designed to be used with PVC covered wire of 1.2mm OD with 7 x 0.2mm diameter conductor strands. 5.2 Wires are inserted into the I.D.C slots using pneumatic too] 525428-5. Revision Summary REV .1. Drait Issue - B.Coolbear REV .O. EB00-0635-96 (12" December 1995) - B.Coolbear REV .A. EBO0-0659-96 - B.Coolbear REV .B. EBO0-0678-99 (16" March 2000) _=---: P.Bates Drawn:- B.Coolbear | Approved:- R.Gandy AMP GB Ltd, Merrion Avenue, Stanmore, Page | Midddlesex, HAT 4RS This AMP controlled document is subject to change, Copyright 1998 by AMP GB. All righis reserved. LOC E * Trademark