Technical Data AT160 High Specification Waterproof Cloth Tape Issue 12 / May 2006 General description A polythene extruded matt cloth tape with a waterproof finish coated with an aggressive pressure sensitive adhesive. Very strong Easy tear and unwind Conformable to awkward shapes Water resistant finish Good abrasion resistance Non-corrosive adhesive Can be written on Wide colour range Specifications Certification* to the following standards may be available on request. DEF STAN 81-25 and BS3887 : 1991 Technical Details Typical values Thickness 0.33mm Breaking Load 85 N/cm Elongation 8% Adhesion Steel 4.0 N/cm Self 2.2 N/cm Moisture Vapour Permeability 35g/m2/24hrs Water extract PH 6.5 to 7.5 ChlorideMax. 0.05% as NaCl Sulphate Max. 0.25% as Na2SO4 RoHS compliant Yes Service Temperature -50C to +80C Application Temperature +10C to +45C Storage Temperature +12C to +25C NOTE Except where indicated otherwise, the figures stated are average values and should not be regarded as MAXIMUM or MINIMUM values for specification purposes.The Company reserves the right to improve products and any change in specification will result in a re-issue of the relevant `Technical Data Sheet'. Customers should satisfy themselves that the tape is suitable for their requirements whether after such modifications or otherwise. Please check that you have the latest issue of the `Technical Data Sheet'. All slitting and length tolerances are to British Standards. Before use the customer is advised to consult the Health & Safety Data Sheet produced by the company for this product, which is available on request. STORAGE Tapes stored below the minimum recommended temperature will require warming up to that level before use. Up to 24 hours may be required for this to take place. *Standard charge for certificate: 25.00. Advance Tapes International Limited, PO Box 122, Abbey Meadows, Leicester, LE4 5RA. Tel: 0116 251 0191. Fax: 0116 265 2046. www.advancetapes.com AFERA Association des Fabricants Europeens de Rubans Auto-Adhesifs.