TXL 035 Series, 35 Watt
http://www.tracopower.com Page 2 of 4
All specifications valid at nominal input voltage, full load and +25°C after warm-up time unless otherwise stated.
Input Specifications
Input voltage range – nominal 100 – 240 VAC
– AC range (universal input) 88 – 264 VAC
– DC range 125 – 375 VDC
Input frequency 47 – 63 Hz
Input current at full load – at 100 VAC 1.0 A max.
Input inrush current – at 115 VAC / 230 VAC 30 A max. / 50 A max.
Zero load power consumption only single output models: 0.5 W max. (green mode function)
Recommended circuit breaker (characteristic C or slow bow fuse) 5 A
Output Specifications
Output voltage adjustment range ±10 % (only Vout 1)
Regulation – Input variation 1.0 % max.
– Load variation (20 - 100%) main output: 2.0 % max.
Vout 2: 5.0 % max.
Minimum load single output models: not required
dual output models: Vout 1 requires 0.3 A
Temperature coefficient 0.02 %/K
Start-up time 1 s max.
Rise time single output models: 20 ms max.
dual output models: 30 ms max.
Hold-up time single output models: 40 ms min.
dual output models: 60 ms min.
Ripple and noise – measured with external capacitors:
0.1 µF and 47 µF parallel capacitor
(20Mhz Bandwidth) – Vout 1 3.3 & 5 Vout models: 70 mVp-p typ.
12 Vout model: 120 mVp-p typ.
15 & 24 Vout models: 150 mVp-p typ.
48 Vout model: 200 mVp-p typ.
– Vout 2 (-)12 VDC models: 120 mVp-p typ.
15 VDC models: 150 mVp-p typ.
Overload protection by current limitation 105 – 150 % of Iout max.
Short circuit protection hiccup mode (automatic recovery)
Overvoltage protection (Latch off, recovery after restart) 115 – 140 % of nominal Vout (only Vout 1)
Capacitive load www.tracopower.com/products/txl-capload.pdf
General Specifications
Temperature ranges – Operating –20°C to +70°C
(with derating)
– Storage
–40°C to +85°C
Output power derating – Temperature 2.5 %/K above +50°C
– Low input voltage 0.8 %/V below 100 VAC
Cooling natural convection (20 lfm), no internal fan
Humidity (non condensing) 20 – 90 % rel. H max.
Altitude during operation 2000 m
Isolation voltage (60 sec.) – Input / Output 3000 VAC
– Input / PE 1500 VAC
– Output / PE 500 VAC
Isolation resistance (at 500 VDC) 100 MOhm min.
Leakage current (at 264 VAC/60Hz) 1 mA max.