Model C10A50Z4 Surface Mount Termination 10 Watts, 50 Description The C10A50Z4 is high performance RoHS compliant Alumina (Al2O3) surface mount termination intended as a lower cost alternative to Aluminum Nitride (AlN) and Beryllium Oxide (BeO). The termination is well suited to all cellular frequency bands such as; AMPS, GSM, DCS, PCS, PHS and UMTS. The high power handling makes the part ideal for terminating 90 degree hybrid directional couplers, and for use in isolators . General Specifications Features: * RoHS Compliant * 10 Watts * DC - 3.0 GHz * Al2O3 Ceramic * Non-Nichrome Resistive Element * Low VSWR * 100% Tested Resistive Element Substrate Terminal Finish Operating Temperature Thick film Al2O3 Ceramic Matte Tin over Nickel Barrier -55 to +125C (see de-rating chart) Tolerance is 0.010", unless otherwise specified. Designed to meet or exceed applicable portions of MIL-E-5400. All dimensions in inches. Electrical Specifications Resistance Value: Power: Frequency Range: V.S.W.R.: 50 Ohms, 2% 10 Watts DC - 3.0 GHz < 1.25:1 Specification based on unit properly installed using suggested mounting instructions and a 50 ohm nominal impedance. Specifications subject to change without notice. Outline Drawing UNLESS OTHERWISE SPECIFIED DIMENSIONS ARE IN INCHES C10A50Z4 pg. 1 of 2 Available on Tape and Reel For Pick and Place Manufacturing. USA/Canada: Toll Free: Europe: (315) 432-8909 (800) 544-2414 +44 2392-232392 Model C10A50Z4 Typical Performance: C10A50Z4 C10A50Z4 Power De-rating: Mounting Footprint and Procedure: *Actual performance could be limited by the solder properties of the application Tape & Reel: C10A50Z4 pg. 2 of 2 USA/Canada: Toll Free: Europe: (315) 432-8909 (800) 544-2414 +44 2392-232392 Available on Tape and Reel For Pick and Place Manufacturing.