Page 1 of 2 SparkFun MegaShield Kit D E V - 09 3 46 R OH S images are CC BY-NC-SA 3.0 Description: The Arduino Mega now has its very own prototyping shield! The SparkFun MegaShield mates with the Arduino Mega board and gives the user a prototyping area, two general LEDs, and, most important of all, the Arduino Mega reset switch is brought to the top level. The shield also works with our small breadboards if you don't want to solder to the prototyping area. This comes in kit form and must be soldered together by the end user. Please note we do not ship assembly instructions! All soldering is through-hole (relatively easy) but always check your component orientation before soldering! Kit Includes: * * * * * * * 1x MegaShield PCB 11x 8-pin Arduino Stackable Header 1x Bright 5mm Green LED 1x Bright 5mm Red LED 2x 330 Ohm resistors 1x Momentary push button 1x 10k resistor Page 2 of 2 Features: * * * * All Arduino Mega pins are brought to the top level 5V and GND power busses Power and stat (connected to D13) LEDs Reset Button brought to top level Documents: * * * * Protoshield Schematic Eagle Files Assembly Tutorial by Bob Gallup Arduino Home Page https://www.sparkfun.com/products/9346 2/12/2015