1. DATE NOTICE OF REVISION (NOR) Form Approved OMB No. 07040188 (YYMMDD) 02-05-24 This revision described below has been authorized for the document listed. Public reporting burden for this collection is estimated to average 2 hours per response, including the time for reviewing instructions, searching existing data sources, gathering and maintaining the data needed, and completing and reviewing the collection of information. Send comments regarding this burden estimate or any other aspect of this collection of information, including suggestions for reducing this burden, to Department of Defense, Washington Headquarters Services, Directorate for Information Operations and Reports, 1215 Jefferson Davis Highway, Suite 1204, Arlington, VA 22202-4302, and to the Office of Management and Budget, Paperwork Reduction Project (0704-0188), Washington, DC 20503. PLEASE DO NOT RETURN YOUR COMPLETED FORM TO EITHER OF THESE ADDRESSED. RETURN COMPLETED FORM TO THE GOVERNMENT ISSUING CONTRACTING OFFICER FOR THE CONTRACT/ PROCURING ACTIVITY NUMBER LISTED IN ITEM 2 OF THIS FORM. 2. PROCURING ACTIVITY NO. 3. DODAAC 4. ORIGINATOR b. ADDRESS (Street, City, State, Zip Code) 5. CAGE CODE Defense Supply Center Columbus 3990 East Broad Street Columbus, Ohio 43216-5000 a. TYPED NAME (First, Middle Initial, Last) 6. NOR NO. 037Z3 5935-R002-02 7. CAGE CODE Ron Gary 8. DOCUMENT NO. 037Z3 86006 10. REVISION LETTER 9. TITLE OF DOCUMENT 11. Connector, Receptacle, Electrical, Coaxial, Radio Frequency, Series S-SMB, Printed Circuit Board Mount N/A a. CURRENT b. NEW E F ALL 12. CONFIGURATION ITEM (OR SYSTEM) TO WHICH ECP APPLIES 13. DESCRIPTION OF REVISION Sheet 1: Revisions Ltr. Column; add "F" Revisions description column; add "Changes in accordance with NOR 5935-R002-02". Revisions date column; add "02-05-24" Revisions rev status of pages, block 1, add "F". Revisions rev status of sheet 1, add "F". Sheet 3: Figure 1, dimension ".246 Max", delete and substitute ".264 Max". Revisions rev status block for sheet 3 add "F". 14. THIS SECTION FOR GOVERNMENT USE ONLY a. (X one) X (1) Existing document supplemented by the NOR may be used in manufacture. (2) Revised document must be received before manufacturer may incorporate this change. (3) Custodian of master document shall make above revision and furnish revised document. b. ACTIVITY AUTHORIZED TO APPROVE CHANGE FOR GOVERNMENT c. TYPED NAME (First, Middle Initial, Last) DSCC-VAI d. TITLE ROBERT HEBER e. SIGNATURE CHIEF, INTERCONNECTION DEVICES f. DATE SIGNED Robert M. Heber (YYMMDD) 02-05-24 15a. ACTIVITY ACCOMPLISHING REVISION DSCC-VAI b. REVISION COMPLETED (Signature) Ron Gary c. DATE SIGNED (YYMMDD) 02-05-24 DD Form 1695, APR 92 Previous editions are obsolete ECP NO. REVISIONS LTR DESCRIPTION DATE APPROVED A Figure 1, change dimension .060 to .028. Delete figure 2, interface dimensions. Editorial changes throughout. 19 Feb 1991 Randy Larson B Change PIN and address for CAGE 24931. Editorial changes throughout. 2 Mar 1992 Randy Larson C Figure 1, delete length dimension .246 max and substitute .264 max. Add new vendor PINs and CAGE and address. 24 Feb 1993 Randy Larson D Add new vendor PINs and new vendor CAGE 95077. 10 Nov 1994 Randy Larson E PIN and source update. 16 Nov 2001 Robert M. Heber Prepared in accordance with MIL-STD-100 REV PAGE REV STATUS REV E E E E E E E OF PAGES PAGE 1 2 3 4 5 6 7 DEFENSE SUPPLY CENTER, COLUMBUS COLUMBUS, OHIO 43216-5000 PREPARED BY PMIC N/A Original date of drawing 13 February 1986 Ron Gary CHECKED BY TITLE CONNECTOR, RECEPTACLE, ELECTRICAL, COAXIAL, RADIO FREQUENCY, SERIES S-SMB, PRINTED CIRCUIT BOARD MOUNT C. W. Koeller APPROVED BY R. Larson SIZE A CAGE CODE 037Z3 REV E 86006 DWG. NO. PAGE AMSC N/A DISTRIBUTION STATEMENT A. Approved for public release; distribution is unlimited. 1 OF 7 5935-E626 Part or Identifying Number (PIN): 86006ZBG-1 86006ZBG-2 86006ZBG-3 86006ZBS-1 86006ZBS-2 86006ZBS-3 Dimension A .155 .010 .125 .010 .093 .010 .155 .010 .125 .010 .093 .010 FIGURE 1. General configurations. DEFENSE SUPPLY CENTER, COLUMBUS COLUMBUS, OH 43216-5000 SIZE A CAGE CODE DWG NO. 86006 037Z3 REV E PAGE 2 PIN 86006ZBG-4 86006ZBG-5 86006ZBG-6 86006ZBS-4 86006ZBS-5 86006ZBS-6 Inches .001 .005 .010 .024 .028 .093 .100 .125 Dimension A .155 .010 .125 .010 .093 .010 .155 .010 .125 .010 .093 .010 mm 0.03 0.13 0.25 0.60 0.71 2.36 2.54 3.18 Inches .142 .155 .156 .218 .264 .385 .435 .600 mm 3.61 3.93 3.96 5.54 6.71 9.78 11.05 15.20 NOTES: 1. Dimensions are in inches. 2. All undimensioned pictorial representations are for reference purposes only. 3. Unless otherwise specified, tolerances shall be .005. 4. Metric equivalents are given for general information only. FIGURE 1. General configurations - Continued. DEFENSE SUPPLY CENTER, COLUMBUS COLUMBUS, OH 43216-5000 SIZE A CAGE CODE DWG NO. 86006 037Z3 REV E PAGE 3 ENGINEERING DATA: Nominal impedance: 50 ohms. Frequency range: 0 to 12.4 GHz. Voltage rating: 250 V rms at sea level, 60 V rms at 70,000 feet. Temperature rating: -65C to +165C. REQUIREMENTS: Requirements of Drawing 84148 are applicable. Dimensions and configuration: See figure 1 and MIL-STD-348. Force to engage and disengage: Longitudinal force: 6 pounds maximum engage, 2 pounds minimum disengage. Torque: Not applicable. Coupling proof torque: Not applicable. Hermetic seal: Not applicable. Leakage (pressurized connectors): Not applicable. Insulation resistance: Method 302, test condition B, in accordance with MIL-STD-202. 1,000 megohms, minimum. Center contact retention: 2 pounds minimum, axial force. Solderability: Method 208, MIL-STD-202. 1/ Voltage standing wave ratio: Not applicable. Connector durability: Applicable. Contact resistance (milliohms maximum): Initial Center contact Outer contact Braid to body After environmental 4.0 1.0 N/A 6.0 1.5 N/A Dielectric withstanding voltage: 500 V rms at sea level. Vibration, high frequency: MIL-STD-202, method 204, test condition B, 15 G's. Shock: MIL-STD-202, method 213, test condition B, 75 G's at 6 milliseconds, 1/2 sine. Thermal shock: MIL-STD-202, method 107, test condition B. Contact current rating: 1.0 amp dc. Moisture resistance: Not applicable. Corona level: 125 V up to 75,000 feet. 1/ For quality conformance inspection, the test shall be performed in group B following VSWR. DEFENSE SUPPLY CENTER, COLUMBUS COLUMBUS, OH 43216-5000 SIZE A CAGE CODE DWG NO. 86006 037Z3 REV E PAGE 4 RF high potential withstanding voltage: Voltage and frequency: 400 V rms at 5.0 MHz. Leakage current: Not applicable. Cable retention force: Not applicable. Coupling mechanism retention force: Not applicable. RF leakage: Not applicable. Insertion loss: Not applicable. PIN: 86006ZBG-1 through -6 and 86006ZBS-1 through -6 (see figure 1.) NOTE: Application data. These parts are intended for use in radio frequency application where specified performance is critical. DEFENSE SUPPLY CENTER, COLUMBUS COLUMBUS, OH 43216-5000 SIZE A CAGE CODE DWG NO. 86006 037Z3 REV E PAGE 5 Approved sources of supply are listed herein. Additional sources will be added as they become available. The vendors listed on the requirements drawing have agreed to this drawing and a certificate of compliance has been submitted to DSCC-VAI. DSCC PIN 1/ 86006ZBG-1 86006ZBG-2 86006ZBG-3 86006ZBG-4 86006ZBG-5 86006ZBG-6 86006ZBS-1 86006ZBS-2 86006ZBS-3 86006ZBS-4 86006ZBS-5 86006ZBS-6 1/ Vendor CAGE Number 00795 19505 24931 95077 00795 19505 24931 95077 00795 19505 24931 95077 00795 19505 24931 95077 00795 19505 24931 95077 00795 19505 24931 95077 00795 19505 24931 95077 00795 19505 24931 95077 00795 19505 24931 95077 00795 19505 24931 95077 00795 19505 24931 95077 00795 19505 24931 95077 Vendor reference PIN 2469000G000-001 7210-1511-999 53JR106-1 2185-0016 2469000G000-002 7210-1511-899 53JR106-2 2185-0018 2469000G000-003 7210-1511-799 53JR106-3 2185-0020 2468000G001-001 7209-1511-999 53JR107-1 2185-0022 2468000G001-002 7209-1511-899 53JR107-2 2185-0024 2468000G001-003 7209-1511-799 53JR107-3 2185-0026 2469000A000-001 7210-6511-999 53JR106-4 2185-0017 2469000A000-002 7210-6511-899 53JR106-5 2185-0019 2469000A000-003 7210-6511-799 53JR106-6 2185-0021 2468000A001-001 7209-6511-999 53JR107-4 2185-0023 2468000A001-002 7209-6511-899 53JR107-5 2185-0025 2468000A001-003 7209-6511-799 53JR107-6 2185-0027 Parts must be purchased to this DSCC PIN to assure that all performance requirements and tests are met. DEFENSE SUPPLY CENTER, COLUMBUS COLUMBUS, OH 43216-5000 SIZE A CAGE CODE DWG NO. 86006 037Z3 REV E PAGE 6 Vendor CAGE number Vendor name and address 00795 Delta Electronics 416 Cabot Street Beverly, MA 01915 19505 Applied Engineering Products P.O. Box 510 104 John W. Murphy Drive New Haven, CT 08513 24931 Specialty Connector Co. 2100 Earlywood Dr. Franklin, IN 46131 95077 Solitron/Vector Microwave Products 3301 Electronics Way West Palm Beach, FL 33407 DEFENSE SUPPLY CENTER, COLUMBUS COLUMBUS, OH 43216-5000 SIZE A CAGE CODE DWG NO. 86006 037Z3 REV E PAGE 7