NJU7102A/04
A
-
1
-
Ver.2012-07-23
C-MOS COMPARATOR WITH C-MOS OUTPUT
■ GENERAL DESCRIPTION ■ PACKAGE OUTLINE
The NJU7102A and 04A dual and quad C-MOS
Comparators performing wide operating voltage from 3 to
14V,low operating current and low offset voltage.
The NJU7102A and 04A operated on a
single-power-supply can interface with most of TTL and
C-MOS type standard logic ICs.
■ FEATURES
● Single-Power-Supply
● Wide Operating Voltage ( VDD=3~14V )
● Low Operating Current ( 9µA/circuit typ. )
● Wide Common Mode Input Voltage ( 0~3.8V @ VDD=5V )
● High Input Impedance
● Low Bias Current ( IIB=1pA )
● Low Offset Voltage
● C-MOS ( Push-Pull ) Output
● Package Outline DIP/DMP8 ( NJU7102A )
DMP14 ( NJU7104A )
● C-MOS Technology
■ PIN CONFIGURATION
■ EQUIVALENT CIRCUIT
NJU7102AD/AM
NJU7104AM
NJU7102AD NJU7102AM
NJU7104AM
NJU7102A/04A
-
2
-Ver.2012-07-23
■ ABSOLUTE MAXIMUM RATINGS
( Ta=25˚C )
PARAMETER SYMBOL RATINGS UNIT
Supply Voltage VDD 16 V
Differential Input Voltage VID ± 16 ( note1 ) V
Input Voltage VIC 16 V
Output Voltage VO 16 V
Output Current IO 20 mA
( DIP8 ) 500
( DMP8 ) 300
Power Dissipation PD
( DMP14 ) 300
mW
Operating Temperature Range Topr 0~+70 ˚C
Storage Temperature Range Tstg -40~+125 ˚C
( note1 ) If the supply voltage ( VDD ) is less than 16V, the input voltage must not over the VDD level though 16V is limit
specified.
■ ELECTRICAL CHARACTERISTICS
( Ta=25˚C,VDD=5V )
NJU7102A NJU7104A
PARAMETER SYMBOL TEST CONDITION
MIN. TYP. MAX. MIN. TYP. MAX. UNIT
Operating Voltage VDD 3 - 14 3 - 14 V
Input Offset Voltage VIO V
IC=VICMin ( note2 ) - 1.2 12 - 1.2 12 mV
Input Offset Current IIO - 1 - - 1 - pA
Input Bias Current IIB - 1 - - 1 - pA
Input Common Mode Voltage Range VICM 0 - 3.8 0 - 3.8 V
Output Voltage VOH V
ID=+1V,IOH=+5V 4.5 4.7 - 4.5 4.7 - V
V
OL V
ID=+1V,IOL=+6mA - 0.22 0.30 - 0.234 0.30 V
Common Mode Rejection Ratio CMR VIC=VICMin - 82 - - 78 - dB
Supply Voltage Rejection Ratio SVR VDD=5~10V - 90 - - 92 - dB
Operating Current IDD No Load,VO=0V - 18 40 - 36 80 µA
( note2 ) This condition is available for operating voltage VDD=5~10V and driving voltage is over 4.5V or under 0.3V.
■ SWITCHING CHARACTERISTICS
( Ta=25˚C,VDD=5V,f=10kHz,CL=15pF )
NJU7102A NJU7104A
PARAMETER SYMBOL CONDITIONS MIN TYP MAX MIN TYP MAX UNIT
Propagation Delay Over Drive=5mV - 3.0 - - 2.3 -
High to Low tPHL V
IC=0V TTL level step - 0.17 - - 0.17 - µs
Propagation Delay Over Drive=5mV - 1.9 - - 1.3 -
Low to High tPLH V
IC=0V TTL level step - 0.8 - - 0.8 - µs
Output Signal
Falling Time tTHL Over Drive=50mV - 30 - - 30 - ns
Output Signal
Rising Time tTLH Over Drive=50mV - 70 - - 70 - ns
NJU7102A/04
A
-
3
-
Ver.2012-07-23
■ MEASUREMENT CIRCUIT
■ TIMING WAVEFORM
[CAUTION]
The specifications on this databook are only
given for information , without any guarantee
as regards either mistakes or omissions. The
application circuits in this databook are
described only to show representative usages
of the product and not intended for the
guarantee or permission of any right including
the industrial rights.
