15
6
10
1. Allow clearance for finger squeeze access
from the two sides shown.
2. No tracks or vias in the shaded "KEEP OUT" AREA.
3. No other track or signal within
.02" of any contact pad.
4. Do not allow solder paste on the
contact pads.It is essential to
eliminate any hole in the solder
paste-mask (solder stencil) layer.
If this is not possible make the
contact pads thru-hole with a
finished hole size of .008" or less.
5. Leg and alignment holes may be
plated and used as vias but ensure
minimum finshed hole size meets
specified tolerances.
6. To prevent purchasing confusion,
please specify DNL in your BOM.
REV
A
10
PCB Footprint for J-LINK Needle Adapter
Protected by U.S. Patent Nos. 7,878,834, 8,057,248, International Patent Pending.
A
REV
A
Protected by U.S. Patent Nos. 7,878,834, 8,057,248, International Patent Pending.
CONNECTOR
Needle Adapter inserted
finger access to the
Needle-Adapter's leg tabs.
