2.0x1.2mm SMD CHIP LED LAMP KP-2012SURCK HYPER RED Features Description !2.0mmx1.2mm SMT LED,1.1mm THICKNESS. The Hyper Red source color devices are made with DH !LOW POWER CONSUMPTION. InGaAlP on GaAs substrate Light Emitting Diode. !WIDE VIEWING ANGLE. !IDEAL FOR BACKLIGHT AND INDICATOR. !VARIOUS COLORS AND LENS TYPES AVAILABLE. !PACKAGE : 2000PCS / REEL. Package Dimensions Notes: 1. All dimensions are in millimeters (inches). 2. Tolerance is 0.1(0.004") unless otherwise noted. 3. Lead spacing is measured where the lead emerge package. 4. Specifications are subject to change without notice. SPEC NO: KDA0084 APPROVED: J.LU REV NO: V.1 CHECKED: DATE: SEP/07/2001 DRAWN: S. H. CHEN PAGE: 1 OF 4 Selection Guide Par t No . Dic e KP-2012SURCK Iv (m c d ) @ 20 m A L en s Ty p e HYPER RED ( InGaAlP ) WATER CLEAR V i ew i n g An g l e Min . Ty p . 21/2 50 100 120 Note: 1. 1/2 is the angle from optical centerline where the luminous intensity is 1/2 the optical centerline value. Electrical / Optical Characteristics at T)=25C Sy m b o l Par am et er D ev i c e peak Peak Wavelength Hyper Red D Dominate Wavelength 1/2 Ty p . Max . Un it s Tes t Co n d it io n s 640 nm IF=20mA Hyper Red 6 30 nm IF=20mA Spectral Line Halfwidth Hyper Red 28 nm IF=20mA C Capacitance Hyper Red 35 pF VF=0V;f=1MHz VF Forward Voltage Hyper Red 1.95 2.5 V IF=20mA IR Reverse Current Hyper Red 10 uA V R = 5V Absolute Maximum Ratings at T)=25C Par am et er H y p e r R ed Un it s Power dissipation 170 mW DC Forward Current 30 mA Peak Forward Current [1] 185 mA Reverse Voltage 5 V Operating Temperature -40C To +85C Storage Temperature -40C To +85C Note: 1. 1/10 Duty Cycle, 0.1ms Pulse Width. SPEC NO: KDA0084 APPROVED: J.LU REV NO: V.1 CHECKED: DATE: SEP/07/2001 DRAWN: S. H. CHEN PAGE: 2 OF 4 Hyper Red KP-2012SURCK SPEC NO: KDA0084 APPROVED: J.LU REV NO: V.1 CHECKED: DATE: SEP/07/2001 DRAWN: S. H. CHEN PAGE: 3 OF 4 KP-2012SURCK SMT Reflow Soldering Instructions Number of reflow process shall be less than 2 times and cooling process to normal temperature is required between first and second soldering process. Recommended Soldering Pattern (Units : mm) Tape Specifications (Units : mm) SPEC NO: KDA0084 APPROVED: J.LU REV NO: V.1 CHECKED: DATE: SEP/07/2001 DRAWN: S. H. CHEN PAGE: 4 OF 4